Layout optimization and influence law of cascade plasma flow control
-
摘要: 为提高流动控制能力,基于高负荷压气机叶栅的流场特性和等离子体气动激励特性,对等离子体流动控制的激励布局进行优化,通过选取典型激励布局,实验揭示了不同因素对等离子体气动激励抑制叶栅流动分离的影响.结果表明:吸力面激励布局中,靠近前缘流向激励的作用效果强于展向激励和尾缘激励,沿流向分布多组电极的激励效果最佳;端壁激励布局中,横向激励的作用效果明显强于流向激励;组合激励布局中,基于端壁横向激励和吸力面流向激励的组合布局的激励效果最佳.等离子体气动激励的作用效果随着激励电压的增大而增强,随着攻角的增大其作用效果先增强后变弱;变定常激励为非定常激励,通过耦合流动的不稳定性,可以提高等离子体气动激励流动控制效果.Abstract: In order to improve the plasma flow separation control abilities on highly loaded compressor cascade, optimizations of plasma aerodynamic actuation layouts were researched based on characteristics of the highly loaded compressor cascade flow field and plasma aerodynamic actuation. With typical actuation layout, influence factors on plasma compressor cascade flow control was studied experimentally. Results show that among the layouts of plasma aerodynamic actuations on suction surface, the actuation effect of streamwise direction near blade leading edge is better than that of pitchwise direction or that near trailing edge, and the multigroup electrodes of streamwise direction are most effective in flow control; the control effect of pitchwise plasma aerodynamic actuation on endwall is better than that of streamwise direction; the control effect of streamwise plasma aerodynamic actuations on suction surface combined with pitchwise ones on endwall is the best among all plasma aerodynamic actuation layouts. As the actuation voltage increases, the control effect of plasma aerodynamic actuation on flow separation becomes better, while with the increase of the incidence angle, the control effect is enhanced firstly and then decreases; by coupling the flow field instability, the unsteady plasma aerodynamic actuation leads to a better flow control effect than the steady plasma aerodynamic actuation method.
-
Key words:
- actuation layout /
- optimization design /
- incidence angle /
- actuation voltage /
- unsteady frequency
-
[1] 陈绍文,郭爽,陆华伟,等.超高负荷吸附式压气机叶栅气动性能分析[J].热能动力工程,2009,24(1):167-171. CHEN Shaowen,GUO Shuang,LU Huawei,et al.Analysis of the aerodynamic performance of a super highly loaded adsorption type compressor cascade[J].Journal of Engineering for Thermal Energy & Power,2009,24(1):167-171.(in Chinese) [2] Gmelin C,Steger M,Thiele F,et al.Unsteady RANS simulations of a highly loaded low aspect ratio compressor stator cascade with active flow control[R].ASME Paper GT2010-22516,2010. [3] Zhang Y J,Chen F,Feng G T,et al.Influence of turning angle on flow field performance of linear bowed stator in compressor at low mach number[J].Chinese Journal of Aeronautics,2006,19(4):271-277. [4] Thomas F O,Kozlov A,Corke T C.Plasma actuators for landing gear noise reduction[R].AIAA 2005-3010,2005. [5] Wicks M,Thomas F O,Schatzman D,et al.A parametric investigation of plasma streamwise vortex generator performance[R].AIAA 2012-0824,2012. [6] 李应红,梁华,马清源,等.脉冲等离子体气动激励抑制翼型吸力面流动分离的实验[J].航空学报,2008,29(6):1429-1435. LI Yinghong,LIANG Hua,MA Qingyuan,et al.Experimental investigation on airfoil Suction side flow separation by pulse plasma aerodynamic actuation[J].Acta Aeronautica et Astronautica Sinica,2008,29(6):1429-1435.(in Chinese) [7] Benard N,Jolibois J,Moreau E.Lift and drag performances of an axisymmetric airfoil controlled by plasma actuator[J].Journal of Electrostatics,2009,67(1):133-139. [8] Kelley C L,Bowles P,Cooney J,et al.High Mach number leading-edge flow separation control using AC DBD plasma actuators[R].AIAA 2012-0906,2012. [9] Huang J H,Corke T C,Thomas F O.Plasma actuators for separation control of low-pressure turbine blades[J].AIAA Journal,2006,44(1):51-57. [10] Morris S,Corke T C,Van Ness D K,et al.Tip clearance control using plasma actuators[R].AIAA 2005-0782,2005. [11] Stephens J,Corke T C,Morris S.Turbine blade tip leakage control using plasma actuators[R].AIAA 2007-0646,2007. [12] Wu Y,Li Y H,Zhu J Q,et al.Experimental investigation of a subsonic compressor with plasma actuation treated casing[R].AIAA 2007-3849,2007. [13] 赵小虎,吴云,李应红,等.高负荷压气机叶栅分离结构及其等离子体流动控制研究[J].航空学报,2012,33(2):208-219. ZHAO Xiaohu,WU Yun,LI Yinghong,et al.Separation structure and plasma flow control on highly loaded compressor cascade[J].Acta Aeronautica et Astronautica Sinica,2012,33(2):208-219.(in Chinese) [14] 吴云,李应红,朱俊强,等.等离子体气动激励抑制压气机叶栅角区流动分离的仿真与实验[J].航空动力学报,2009,24(4):830-835. WU Yun,LI Yinghong,ZHU Junqiang,et al.Computational and experimental investigation of plasma aerodynamic actuation based corner flow separation control in a compressor cascade[J].Journal of Aerospace Power,2009,24(4):830-835.(in Chinese) [15] Li Y H,Wu Y,Zhou M,et al.Control of the corner separation in a compressor cascade by steady and unsteady plasma aerodynamic actuation[J].Experiments in Fluids,2010,48(6):1015-1023. [16] Wu Y,Li Y H,Jia M,et al.Experimental investigation into characteristics of plasma aerodynamic actuation generated by dielectric barrier discharge[J].Chinese Journal of Aeronautics,2010,23(1):39-45. [17] Nerger D,Saathoff H,Radespiel R,et al.Experimental investigation of endwall and suction side blowing in a highly loaded compressor stator cascade[R].ASME Paper GT2010-22578,2010. [18] Greig A,Cheong M,Arjomandi D M,et al.Investigation into the effect of electrode angle on force production of a dielectric barrier discharge plasma actuator[R].AIAA 2012-821,2012. [19] Dorfner C,Hergt A,Nicke E,et al.Advance non-axisymmetric endwall contouring for axial compressors by generating an aerodynamic separator:Part Ⅰ principal cascade design and compressor application[J].ASME Paer GT2009-59383,2009. [20] 赵小虎,李应红,岳太鹏,等.等离子体气动激励抑制高负荷压气机叶栅流动分离的实验研究[J].高电压技术,2011,37(6):1521-1527. ZHAO Xiaohu,LI Yinghong,YUE Taipeng,et al.Experimental investigation of flow separation control on highly loaded compressor cascade by plasma aerodynamic actuation[J].High Voltage Engineering,2011,37(6):1521-1527.(in Chinese)
点击查看大图
计量
- 文章访问数: 1238
- HTML浏览量: 3
- PDF量: 1074
- 被引次数: 0