基于安全寿命法的高压涡轮盘低循环疲劳寿命试验

刘闯; 陈国栋; 刘大成

doi:10.13224/j.cnki.jasp.2015.05.017

基于安全寿命法的高压涡轮盘低循环疲劳寿命试验

doi: 10.13224/j.cnki.jasp.2015.05.017

中国航空工业集团公司沈阳发动机设计研究所, 沈阳 110015

详细信息

作者简介:
刘闯(1983-),男,辽宁铁岭人,工程师,硕士,主要从事发动机转子强度寿命研究.

中图分类号: V232.2
计量
- 文章访问数: 1152
- HTML浏览量: 2
- PDF量: 797
- 被引次数: 0
出版历程
- 收稿日期: 2014-05-26
- 刊出日期: 2015-05-28

Low cycle fatigue life test of high pressure turbine disk based on safe life procedure

Shenyang Engine Design and Research Institute, Aviation Industry Corporation of China, Shenyang 110015, China

摘要

摘要: 基于英军标Defence Standard 00971对盘类零件的安全性要求,采用安全寿命法对某型发动机高压涡轮盘的低循环疲劳寿命试验进行了研究.通过有限元法对发动机工作条件下的高压涡轮盘进行了应力分析,考虑了温度场对应力分布的影响,按照Defence Standard 00971的要求确定了高压涡轮盘的关键部位及其标准循环,制定了高压涡轮盘低循环疲劳寿命试验方案,给出了基于试验结果确定高压涡轮盘安全寿命的方法.分析表明:中心孔和螺栓孔的应力系数分别为1.0和1.017,均在合理范围内;提高高压涡轮盘转速同时截短涡轮叶片的试验方法能有效模拟热应力对寿命的影响,对高压涡轮盘低循环疲劳寿命试验具有重要指导意义.
- 定寿 /
- 安全寿命 /
- 温度场 /
- 有限元法 /
- 低循环疲劳寿命 /
- 高压涡轮盘
Abstract: The low cycle fatigue life test of high pressure turbine disk of an engine was studied by using safe life procedure based on Britain military standard Defence Standard 00971 safety requirements for disks. The finite element method was used for analyzing the stress field of high pressure turbine disk of engine under working conditions, and the effect of temperature field on stress distribution was considered. The critical position and reference cycle of high pressure turbine disk were determined according to Defence Standard 00971; then the test plan of low cycle fatigue life of high pressure turbine disk was formed, and the safe life assessment method of high pressure turbine disk based on test results was determined finally. The analysis shows that the stress factors of hub and bolt-hole are 1.0 and 1.017 respectively, which are within a reasonable scale; the test method of increasing rotation speed and cutting turbine blade simultaneously can simulate the effect of thermal stress on life effectively, giving important guidelines for low cycle fatigue life test of high pressure turbine disk.
- life assessment /
- safe life /
- temperature field /
- finite element method /
- low cycle fatigue life /
- high pressure turbine disk

HTML

参考文献(18)

[1]	宋兆泓, 熊昌炳, 郑少华.航空燃气涡轮发动机强度设计[M].北京:北京航空学院出版社, 1988.
[2]	石亮, 魏大盛, 王延荣.考虑应力梯度的轮盘疲劳寿命预测[J].航空动力学报, 2013, 28(6):1236-1242. SHI Liang, WEI Dasheng, WANG Yanrong.Fatigue life prediction of turbine disk based on stress gradient[J].Journal of Aerospace Power, 2013, 28(6):1236-1242.(in Chinese)
[3]	Corran R S J, Williams S J.Lifing methods and safety criteria in aero gas turbines[J].Engine Failure Analysis, 2007, 14(3):518-528.
[4]	刘翔, 朱旭程.航空发动机涡轮盘低循环疲劳寿命研究[J].海军航空工程学院学报, 2008, 23(5):527-530. LIU Xiang, ZHU Xucheng.Research on turbine disk LCF life of jet engine[J].Journal of Naval Aeronautical and Astronautical University, 2008, 23(5):527-530.(in Chinese)
[5]	Federal Aviation Administration.Advisory circular 33.70-1:Guidance material for aircraft engine life-limited part requirment[R].Washington DC:US Department of Transportation, 2009.
[6]	European Aviation Safety Agency.Certification specification for engine CS_E[S].Koeln:European Aviation Safety Agency, 2010.
[7]	甘晓华, 李伟.现役航空发动机使用寿命确定和控制方法[J].航空工程进展, 2010, 1(2):103-106. GAN Xiaohua, LI Wei.A summary of military aero-engine life determination methods[J].Advance in Aeronautical Science and Engineering, 2010, 1(2):103-106.(in Chinese)
[8]	徐可君, 江龙平.军用航空发动机可靠性和寿命管理[J].中国工程科学, 2003, 5(1):82-88. XU Kejun, JIANG Longping.Reliability and life management on aeroengine used in army[J].Engineering Science, 2003, 5(1):82-88.(in Chinese)
[9]	陈国栋, 邢雷, 赵明.国外航空发动机关键件定寿和延寿方法分析[J].航空发动机, 2013, 39(5):60-65. CHEN Guodong, XING Lei, ZHAO Ming.Analysis of life deciding and life extending for aero-engine critical parts[J].Aeroengine, 2013, 39(5):60-65.(in Chinese)
[10]	Boyd-Lee A D, Harrison G F, Henderson M B.Evaluation of standard life assessment procedures and life extension methodologies for fracture-critical components[J].International Journal of Fatigue, 2001, 23(suppl.1):11-19.
[11]	UK Ministry of Defence.DEF STAN 00-971 General specification for aircraft gas turbine engines[S].London:UK Ministry of Defense, 1987.
[12]	Federal Aviation Administration.Advisory circular 33.70-2:Damage tolerance of hole features in high energy turbine engine rotors[R].Washington DC:US Department of Transportation, 2009.
[13]	徐可君, 叶新农.航空发动机综合飞行换算率的确定[J].推进技术, 2006, 27(1):24-29. XU Kejun, YE Xinnong.Study on assessment method of comprehensive flight conversion ratio for aero-engine[J].Journal of Propulsion Technology, 2006, 27(1):24-29.(in Chinese)
[14]	UK Ministry of Defence.DEF STAN 00-970:Part 11 design and airworthiness requirements for service aircraft[S].London:UK Ministry of Defence, 2006.
[15]	王大伟, 王伟, 冯振宇.民用航空发动机限寿件适航符合性方法[J].科技导报, 2013, 31(13):49-53. WANG Dawei, WANG Wei, FENG Zhenyu.Airworthiness compliance of life-limited part of civil aircraft engine[J].Science and Technology Review, 2013, 31(13):49-53.(in Chinese)
[16]	罗尔斯-罗伊斯公司.EGD-3斯贝MK202发动机应力标准[S].丁爱祥, 吴君, 译.北京:《国际航空》编辑部, 1979.
[17]	黄庆东, 龚梦贤.振动监测在轮盘低循环疲劳试验中的应用[J].燃气涡轮试验与研究, 1998, 11(4):15-18.
[18]	US Department of Defense.MIL-HDBK-1783B Engine structural integrity program[S].Washington DC:US Department of Defense, 2002.