Reversible model-simplifying method for aero-engine rotor systems
-
摘要: 针对航空发动机高压转子系统动力学模型,给出了一种模型可逆化简化的方法.首先采用有限元法建立了较为精确的动力学模型,然后基于质心集中方法对该模型进行了不同程度的简化,分别得到了单跨双盘模型和单盘模型,并将其与原始模型进行了临界转速的对比.这是一种从结构特点将实际多盘转子简化成单盘转子的方法,它使得在考虑到支承等非线性因素后利用低维非线性动力学理论进行分析和参数优化成为可能.另一方面,研究了模型简化方法的可逆性,即基于质心位置及总质量最优的原则,由单跨双盘模型的圆盘结构参数反推了多级圆盘的等效内外半径、厚度、位置等参数,构建了新的工程结构模型,对比该模型和原始模型的前3阶临界转速,误差均在3%之内.这种由简化模型参数反推多级圆盘的方法,为由非线性动力学理论优化分析所得到的简化模型优化结构参数反推设计多级圆盘工程结构参数奠定了基础.Abstract: A reversible simplified method was given to investigate the dynamic model for aero-engine high-pressure rotor system. By using the finite element method, the accurate complex dynamics model was built, and also simplified to gain the single-span with dual-disc model and single-disc model based on the center of mass concentration method. The critical whirling speed was compared for the simplified and complex models to indicate the correctness of the simplified method. This modeling-simplify method based on the structural characteristics made low-dimensional nonlinear dynamics analysis and parameter optimization possible with the consideration of the nonlinear factors of supporting, etc. And then the reversibility of the model-simplifying method was investigated. The new complex model and the discs' parameters of equivalent radius, thickness and location were obtained from the single-span with dual-disc model by the principle of optimized centroid location and the total mass of the discs. The 1th to 3th critical whirling speeds of the new complex model and the original model were compared, indicating that the errors were all less than 3%. The reversible model-simplifying method laid the foundation for the multistage-disc's engineering structural parameters design from the simple model structural parameters optimized by the nonlinear dynamics theory.
-
[1] 陈予恕,张华彪.航空发动机整机动力学研究进展与展望[J].航空学报,2011,32(8):1371-1391. CHEN Yushu,ZHANG Huabiao.Review and prospect on the research of dynamics of the aero-engine system[J].Acta Aeronautica et Astronautica Sinica,2011,32(8):1371-1391.(in Chinese) [2] 陈果.双转子航空发动机整机振动建模与分析[J].振动工程学报,2011,24(6):619-632. CHEN Guo.Vibration modeling and analysis for dual-rotor aero-engine[J].Journal of Vibration Engineering,2011,24(6):619-632.(in Chinese) [3] 陈果.航空发动机整机振动耦合动力学模型及其验证[J].航空动力学报,2012,27(2):241-254. CHEN Guo.A coupling dynamic model for whole aero-engine vibration and its verification[J].Journal of Aerospace Power,2012,27(2):241-254.(in Chinese) [4] 胡绚,罗贵火,高德平.反向旋转双转子稳态响应计算分析与试验[J].航空动力学报,2007,22(7):1044-1049. HU Xuan,LUO Guihuo,GAO Deping.Numerical analysis and experiment of counter-rotating dual-rotor's steady-state response[J].Journal of Aerospace Power,2007,22(7):1044-1049.(in Chinese) [5] Chiang H W D,Hsu C N,Tu S H.Rotor-bearing analysis for turbomachinery single-and dual-rotor systems[J].Journal of Propulsion and Power,2004,20(6):1096-1104. [6] Sinou J J.Effects of a crack on the stability of a non-linear rotor system[J].International Journal of Non-Linear Mechanics,2007,42(7):959-972. [7] AL-Shudeifat M A.On the finite element modeling of the asymmetric cracked rotor[J].Journal of Sound and Vibration,2013,332(11):2795-2807. [8] ZHANG Huabiao,CHEN Yushu,LI Jun.Bifurcation on the synchronous full annular rub of a rigid-rotor elastic-support system[J].Applied Mathematics and Mechanics:English Edition,2012,33(7):812-827. [9] Hou L,Chen Y,Cao Q.Nonlinear vibration phenomenon of an aircraft rub-impact rotor system due to hovering flight[J].Communications in Nonlinear Science and Numerical Simulation,2014,19(1):286-297. [10] Zhou H L,Luo G H,Chen G,et al.Analysis of the nonlinear dynamic response of a rotor supported on ball bearings with floating-ring squeeze film dampers[J].Mechanism and Machine Theory,2013,59:65-77. [11] 陈会征,陈予恕.航空发动机转子一种振动跳跃问题及其工程控制的分岔分析[J].航空动力学报,2013,28(12):2781-2789. CHEN Huizheng,CHEN Yushu.Analysis on bifurcation of a vibration jumping and engineering control in aero-engine[J].Journal of Aerospace Power,2013,28(12):2781-2789.(in Chinese) [12] Nandi A,Neogy S.Modelling of rotors with three-dimensional solid finite elements[J].The Journal of Strain Analysis for Engineering Design,2001,36(4):359-371. [13] 张力,洪杰,马艳红.航空发动机转子系统建模方法和振动特性分析[J].北京航空航天大学学报,2013,39(2):147-153. ZHANG Li,HONG Jie,MA Yanhong.Modeling method and vibration characteristics of aero-engine rotor system[J].Journal of Beijing University of Aeronautics and Astronautics,2013,39(2):147-153.(in Chinese) [14] 王国丽,刘树辉,朱清乐.基于三维有限元模型的双转子-支承系统动力学特性研究[J].北京理工大学学报,2011,31(11):1292-1296. WANG Guoli,LIU Shuhui,ZHU Qingle.Study on dynamic characteristics of dual rotor-supporting system based on three-dimensional FEA model[J].Transactions of Beijing Institute of Technology,2011,31(11):1292-1296.(in Chinese) [15] 刘长福,邓明.航空发动机结构分析[M].西安:西北工业大学出版社,2006. [16] 邓明.航空燃气涡轮发动机原理与构造[M].北京:国防工业出版社,2008:87-156. [17] 钟一鄂.何衍宗.转子动力学[M].北京:清华大学出版社,1987. [18] 张文.转子动力学基础[M].北京:科技出版社,1990.
点击查看大图
计量
- 文章访问数: 968
- HTML浏览量: 3
- PDF量: 486
- 被引次数: 0