压力面小翼对涡轮叶栅不同间隙下流场影响的实验

钟兢军; 魏曼; 陆华伟

doi:10.13224/j.cnki.jasp.2016.01.012

压力面小翼对涡轮叶栅不同间隙下流场影响的实验

doi: 10.13224/j.cnki.jasp.2016.01.012

大连海事大学轮机工程学院, 辽宁大连 116026

基金项目:

中央高校基本科研业务费专项资金(3132014319)

辽宁省高等学校创新团队支持计划(LT2015004)

详细信息

作者简介:
钟兢军(1963-),男,黑龙江哈尔滨人,教授、博士生导师,博士,主要从事叶轮机械气动热力学研究.E-mail:zhongjj@dlmu.edu.cn

中图分类号: V231.3
计量
- 文章访问数: 872
- HTML浏览量: 2
- PDF量: 458
- 被引次数: 0
出版历程
- 收稿日期: 2015-05-05
- 刊出日期: 2016-01-28

Experiment on effect of pressure-side winglet on flow field in turbine cascade at different tip clearances

Marine Engineering College, Dalian Maritime University, Dalian Liaoning 116026, China

摘要

摘要: 对某涡轮叶栅加装不同宽度的压力面小翼对叶栅间隙流场的影响进行了实验研究,详细测量了间隙高度为0.5%h,1%h,1.5%h时叶栅出口流场和叶片表面静压分布情况.通过实验结果分析得出:随着间隙高度的增加,间隙泄漏流动加剧,泄漏涡增强,叶栅总损失增加,同时使上通道涡的强度减弱;压力面小翼在间隙高度为0.5%h时对间隙泄漏流动的控制效果较好,宽度为0.4倍当地叶片厚度的压力面小翼能使叶栅总损失降低18%.间隙高度为1%h时,0.3倍当地叶片厚度的压力面小翼效果最佳,使叶栅总损失降低10.37%.间隙高度为1.5%h时,压力面小翼对间隙泄漏流动基本没有影响,但在一定程度上降低了叶栅总损失.
- 涡轮叶栅 /
- 间隙高度 /
- 压力面小翼 /
- 间隙泄漏流动 /
- 实验测量
Abstract: Detailed experiments were carried out to investigate the effect of the tip clearance flow in a turbine cascade with different width pressure-side winglets.The flow field of the cascade outlet and the static pressure distribution on the blade surface were surveyed in detail at different tip clearance height of 0.5%h, 1%h, 1.5%h.The results show that, as the tip clearance height increases, the leakage flow is intensified, the leakage vortex is strengthened, the total loss of cascade is increased, and the up channel vortex is weakened.Pressure-side winglet has a good effect at the 0.5%h tip clearance height, the total loss of the cascade is reduced by 18% with width being 0.4 times of the local blade thickness.0.3 times of the local blade thickness case reduces the total loss of the cascade by 10.37% at the 1%h tip clearance height.At the 1.5%h tip clearance height, the pressure-side winglet almost has no effect on clearance leakage flow, but reduces the total loss of the cascade to a certain extent.
- turbine cascade /
- tip clearance height /
- pressure-side winglet /
- tip leakage flow /
- experimental measure

HTML

参考文献(18)

[1]	Mizuki S,Tsujita H.Numerical calculation of flow for cascade with tip clearance[R].ASME Paper 94-GT-361,1994.
[2]	Yamamoto A.Endwall flow/loss mechanisms in a linear turbine cascade with blade tip clearance[J].Journal of Turbomachinery,1989,111(2):246-275.
[3]	Tallman J,Lakshminarayana B.Numerical simulation of tip leakage flows in axial flow turbines,with emphasis on flow physics:Part Ⅰ effect of tip clearance height[J].Journal of Turbomachinery,2001,123(2):324-333.
[4]	Tallman J,Lakshminarayana B.Numerical simulation of tip leakage flows in axial flow turbines,with emphasis on flow physics:Part Ⅱ effect of out casing relative motion[J].Journal of Turbomachinery,2001,123(2):314-323.
[5]	王大磊,朴英.叶尖间隙高度对某高压涡轮级损失分布的影响[J].航空动力学报,2012,27(1):169-175. WANG Dalei,PIAO Ying.Influence of tip clearance size on flow losses of a transonic high pressure turbine stage[J].Journal of Aerospace Power,2012,27(1):169-175.(in Chinese)
[6]	江永泉.飞机翼梢小翼设计[M].北京:航空工业出版社,2009.
[7]	贾瑞博.风力机叶尖加小翼动力放大的数值模拟研究[D].呼和浩特:内蒙古工业大学,2005. JIA Ruibo.Numerical simulation of wind turbine blade tip winglet with power amplification[D].Hohhot:Inner Mongol University of Technology,2005.(in Chinese)
[8]	崔承根,施能继.叶梢带端板螺旋桨的性能研究[J].华中理工大学学报,1991,19(3):117-120. CUI Chenggen,SHI Nengji.Performance of a propeller blade tip with the end plates[J].Journal of Huazhong University of Science and Technology,1991,19(3):117-120.(in Chinese)
[9]	Yaras M I.Measurements of the effects of winglets on tip-leakage losses in a linear turbine cascade[R].AIAA 91-7011,1991.
[10]	Dey D,Camci C.Aerodynamic tip desensitization of an axial turbine rotor using tip platform extensions[R].ASME Paper 2001-GT-0484,2001.
[11]	ZHOU Chao,Hodson H.Effects of winglet geometry on the aerodynamic performance of tip leakage flow in a turbine cascade[R].ASME Paper GT2012-68942,2012.
[12]	Coull J D,Atkins N R,Hodson H P.Winglets for improved aerothermal performance of high pressure turbines[R].ASME Paper GT2013-94425,2013.
[13]	王生武.涡轮叶尖压力边小翼肋条对泄漏流场的数值模拟[J].计算机测量与控制,2009,17(8):1527-1534. WANG Shengwu.Numerical simulation of single pressure side winglet rim on tip leakage flow in axial turbine[J].Computer Measurement and Control,2009,17(8):1527-1534.(in Chinese)
[14]	蔡晋,陈波,闫雪,等.带小翼肋条的涡轮叶尖泄漏流场的数值模拟[J].动力工程学报,2010,30(12):919-925. CAI Jin,CHEN Bo,YAN Xue,et al.Numerical simulation on tip leakage flow of turbine blade with suction-side winglet ribs[J].Journal of Chinese Society of Power Engineering,2010,30(12):919-925.(in Chinese)
[15]	王大磊,邵伏永,郭昊雁,等.翼梢小翼对涡轮间隙泄漏流动影响的数值研究[J].推进技术,2014,35(3):341-346. WANG Dalei,SHAO Fuyong,GUO Haoyan,et al.Study of tip winglets on leakage flow in a transonic turbine stage[J].Journal of Propulsion Technology,2014,35(3):341-346.(in Chinese)
[16]	陈鑫.矩形叶栅风洞设计及流场品质分析[D].辽宁大连:大连海事大学,2011. CHEN Xin.Design and flow filed analysis of rectangular cascade windtunnel[D].Dalian Liaoning:Dalian Maritime University,2011.(in Chinese)
[17]	Behr T.Control of rotor tip leakage and secondary flow by casing air injection in unshroudedaxial turbines[D].Zürich,Switzerland:Swiss Federal Institute of Technology,2007.
[18]	祁明旭,丰镇平.透平动叶顶部间隙流的表现形式及其对透平性能的影响[J].西安交通大学学报,2005,39(3):243-246. QI Mingxu,FENG Zhenping.Representation formation of tip clearance flow and influence on turbine performance[J].Journal of Xi'an Jiaotong University,2005,39(3):243-246.(in Chinese)

施引文献

资源附件(0)

访问统计

点击查看大图

计量

文章访问数: 872
HTML浏览量: 2
PDF量: 458
被引次数: 0

姓名
邮箱
手机号码
标题
留言内容
验证码

留言板

压力面小翼对涡轮叶栅不同间隙下流场影响的实验

doi: 10.13224/j.cnki.jasp.2016.01.012

作者简介:
钟兢军(1963-),男,黑龙江哈尔滨人,教授、博士生导师,博士,主要从事叶轮机械气动热力学研究.E-mail:zhongjj@dlmu.edu.cn

计量

Experiment on effect of pressure-side winglet on flow field in turbine cascade at different tip clearances

计量

目录

留言板

压力面小翼对涡轮叶栅不同间隙下流场影响的实验

doi: 10.13224/j.cnki.jasp.2016.01.012

作者简介: 钟兢军(1963-),男,黑龙江哈尔滨人,教授、博士生导师,博士,主要从事叶轮机械气动热力学研究.E-mail:zhongjj@dlmu.edu.cn

计量

出版历程

Experiment on effect of pressure-side winglet on flow field in turbine cascade at different tip clearances

计量

出版历程

目录

作者简介:
钟兢军(1963-),男,黑龙江哈尔滨人,教授、博士生导师,博士,主要从事叶轮机械气动热力学研究.E-mail:zhongjj@dlmu.edu.cn