局部规则涂层对气冷叶片测温影响的数值研究

杨光; 艾延廷; 徐毅

doi:10.13224/j.cnki.jasp.2019.12.018

局部规则涂层对气冷叶片测温影响的数值研究

doi: 10.13224/j.cnki.jasp.2019.12.018

基金项目: 国家自然科学基金（11702177）；辽宁省自然科学基金（20180550650）

计量
- 文章访问数: 316
- HTML浏览量: 1
- PDF量: 266
- 被引次数: 0
出版历程
- 收稿日期: 2019-06-13
- 刊出日期: 2019-12-28

Numerical study on influence of local regular coating on temperature measurement of film-cooled vane

1.
Key Laboratory of Advanced Measurement and Test Technology for Aircraft Propulsion System,Liaoning Province,Shenyang Aerospace University,Shenyang 110136,China
2.
Sichuan Gas Turbine Establishment,Aero Engine Corporation of China,Jiangyou Sichuan 621703,China

摘要

摘要: 为研究微细热电偶测温安装涂层对其测量精度的影响机理,基于气固耦合传热(CHT)方法,建立了接近真实气膜冷却叶片的三维模型,选择SST(shear stress transport) γ -θ湍流模型,对未喷涂氧化铝涂层与在叶片吸力面前缘、压力面前缘、压力面尾缘处喷涂氧化铝涂层后的气冷叶片表面温度进行数值研究。无涂层工况的数值计算结果与实验结果误差控制在5%以下,验证了数值方法的有效性。研究结果表明:涂层对近壁面燃气的流动特性产生显著影响;三种有涂层工况的数值计算结果表明,压力面前缘处比吸力面前缘处温差波幅小,且比压力面尾缘处测温误差降低35.5%;在压力面及吸力面前缘处,最佳测温区域为涂层中部至下端之间的部位,而在压力面尾缘处,最佳测温区域尽量选择靠近涂层上端部位。
- 局部规则涂层 /
- 气冷叶片 /
- 耦合传热 /
- 温度场分布 /
- 测温精度
Abstract: In order to study the influence mechanism of temperature measurement coating on measuring accuracy of fine thermocouple, a three-dimensional model for film-cooled vane was established based on conjugated heat transfer(CHT) method. SST(shear stress transport) γ -θ turbulence model was carried out on the film-cooled vane sprayed with alumina coating on the front edge of suction, front edge of pressure and trailing edge of pressure surface. The error between the numerical results and the experimental results was controlled below 5%, verifying the effectiveness of the numerical method. The results showed that, the coating had a significant effect on the flow characteristics of gas near the wall. However, the numerical results of three coating conditions showed that the temperature difference amplitude at the front edge of pressure was smaller than that at the front edge of suction, and the temperature measurement error was 35.5% lower than that at the trailing edge of pressure. In addition, on the pressure surface and the front edge of suction, the best temperature measurement area was between the middle and the lower end of the coating, while on the trailing edge of the pressure surface, the best temperature measurement area was close to the upper end of the coating.
- local regular coating /
- film-cooling vane /
- conjugate heat transfer /
- temperature field distribution /
- temperature measurement accuracy

HTML

参考文献(19)

[1]	隋俊友,张锦,刘兴洲.涡扇发动机涡轮导向器故障分析［J］.推进技术,2000,21(1):37-39. SUI Junyou,ZHANG Jin,LIU Xingzhou.Fault analysis of turbine guide of turbofan engine［J］.Journal of Propulsion Technology,2000,21(1):37-39.(in Chinese)
[2]	徐可君.涡轮导向叶片故障分析及其对策［J］.航空工程与维修,1999(1):28-29. XU Kejun.Fault analysis of turbine guide vane and its countermeasures［J］.Journal of Aviation Engineering and Maintenance,1999(1):28-29.(in Chinese)
[3]	许文锋,朱惠人,张丽.带冷却的涡轮叶片温度场耦合计算工程方法研究［J］.汽轮机技术,2008(3):201-203,207. XU Wenfeng,ZHU Huiren,ZHANG Li.Study on engineering method of temperature field coupling calculation of cooled turbine blades［J］.Journal of Steam Turbine Technology,2008(3):201-203,207.(in Chinese)
[4]	DUBOUE J M,LIAMIS N,PATE L.Recent advances in aero-thermal turbine design and analysis［R］.AIAA 2000-3355,2000.
[5]	HAN J C,DUTTA S,EKKAD S.Gas turbine heat transfer and cooling technology［M］.London:Taylor and Francis,2000.
[6]	董平,黄洪雁,冯国泰.高压燃气涡轮径向内冷叶片气热耦合的数值分析［J］.航空动力学报,2008,23(2):201-207. DONG Ping,HUANG Hongyan,FENG Guotai.High pressure gas turbine radial cold blade gas heat coupling numerical analysis［J］.Journal of Aerospace Power,2008,23(2):201-207.(in Chinese)
[7]	王文革.辐射测温技术综述［J］.宇航计测技术,2005,25(4):20-24. WANG Wenge.Survey of radiation thermometry technology［J］.Journal of Astronautic Metrology and Measurement,2005,25(4):20-24.(in Chinese)
[8]	熊庆荣,石小江,侯敏杰,等.基于示温漆的高压涡轮导向叶器表面温度测试［J］.燃气涡轮试验与研究,2014,27(3):44-48. XIONG Qingrong,SHI Xiaojiang,HOU Minjie,et al.Surface temperature measurement of turbine nozzle based on temperature-sensitive paint［J］.Gas Turbine Experiment and Research,2014,27(3):45-48.(in Chinese)
[9]	LEPICOVSKY J,SMITH F A,ZHANG L J,et al.Thin-film thermocouples for turbine hot-cascade testing［R］.Florence,Italy:International Society for Air Breathing Engines,1999.
[10]	胡冰城,王建华,徐华昭,等.具有热障涂层的导向叶片耦合数值研究［J］.航空动力学报,2017,32(10):2394-2402. HU Bingcheng,WANG Jianhua,XU Huazhao,et al.Numerical investigation of a thermal barrier coated vane using conjugate heat transfer approach［J］.Journal of Aerospace Power,2017,32(10):2394-2402.(in Chinese)
[11]	NI R,HUMBER W,FAN G,et al.Comparison of predictions from conjugate heat transfer analysis of a film-cooled turbine vane to experimental data［R］.ASME Paper GT-2013-94716,2013.
[12]	BOHN D,BECKER V.A conjugate 3-D flow and heat transfer analysis of a thermal barrier cooled turbine guide vane［R］.ASME Paper GT-1998-89,1998.
[13]	ROSSETTE A,MAZUR Z,DEMEULENAERE A,et al.Unsteady 3-D conjugated heat transfer simulation of a thermal barrier coated gas turbine bucket［R］.ASME Paper GT-2008-50597,2008.
[14]	王利平,张靖周,姚玉.敷设热障涂层气冷叶片温度分布数值研究［J］.航空动力学报,2012,27(2):357-364. WANG Liping,ZHANG Jingzhou,YAO Yu.Numerical investigation on temperature distribution of an air-cooled and thermal barrier coating blade［J］.Journal of Aerospace Power,2012,27(2):357-364.(in Chinese)
[15]	李涛,边昕,冯宇,等.基于Gama-Theta转捩模型的气冷涡轮气热耦合研究［J］.推进技术,2014,35(7):932-940. LI Tao,BIAN Xin,FENG Yu,et al.Conjugate heat transfer simulation of air-cooled turbine based on Gama-Theta transition model［J］.Journal Propulsion Technology,2014,35(7):932-940.(in Chinese)
[16]	石慧,李亮,丰镇平.污垢沉积影响叶片表面换热的研究［J］.航空动力学报,2015,30(11):2616-2622. SHI Hui,LI Liang,FENG Zhenping.Research of fouling deposition influence on heat transfer of blade surface［J］.Journal of Aerospace Power,2015,30(11):2616-2622.(in Chinese)
[17]	廉筱纯,吴虎.《航空发动机原理》［M］.西安:西北工业大学出版社,2005.
[18]	韩志双,王振峰.高压燃气涡轮叶栅热辐射特性研究［J］.机械工程师,2010(4):74-76. HAN Zhishuang,WANG Zhenfeng.High pressure gas turbine cascade thermal radiation characteristics research［J］.Journal of Mechanical Engineer,2010(4):74-76.(in Chinese)
[19]	《中国航空材料手册》编辑委员会.中国航空材料手册［M］.北京:中国标准出版社,2002:585-593.