Volume 29 Issue 11
Nov.  2014
Turn off MathJax
Article Contents
LÜ Ya-guo, ZHANG Mei-hua, LIU Zhen-xia, HU Jian-ping. Numerical study and validation for two-phase flow of oil and gas in aero-engine bearing cavity[J]. Journal of Aerospace Power, 2014, 29(11): 2751-2757. doi: 10.13224/j.cnki.jasp.2014.11.029
Citation: LÜ Ya-guo, ZHANG Mei-hua, LIU Zhen-xia, HU Jian-ping. Numerical study and validation for two-phase flow of oil and gas in aero-engine bearing cavity[J]. Journal of Aerospace Power, 2014, 29(11): 2751-2757. doi: 10.13224/j.cnki.jasp.2014.11.029

Numerical study and validation for two-phase flow of oil and gas in aero-engine bearing cavity

doi: 10.13224/j.cnki.jasp.2014.11.029
  • Received Date: 2013-12-06
  • Publish Date: 2014-11-28
  • In order to test whether the traditional one-way coupling model was suitable for flowfield calculation of two-phase flow of oil and gas in bearing cavity, two-way coupling model was established. The distributions of air velocity and turbulence kinetic energy in two model cavity after injecting oil with different rotation speeds, were comparative investigated. The data calculated by two-way coupling model were compared with the experiment data in the reference. Some important conclusions were found: in the two-way coupling model, the change law of air velocity distribution after injecting oil is similar with the one-way air flow. However, air velocity reduces markedly at every point and the difference of average air velocity is the maximum in the case of the rotation speed of 8000r/min between these two models; the influence of droplet motion and evaporation on air velocity and turbulence kinetic energy is significant, especially the air velocity which will drop 10%-15% due to the coupling effect of the droplets in mainstream chamber, indicating influence of droplets on the air field cannot be ignored.

     

  • loading
  • [1]
    林基恕.21世纪航空发动机动力传输系统的展望[J].航空动力学报,2001,16(2):108-115. LIN Jishu.Prospects of aeroengine power transmission system in the 21st century[J].Journal of Aerospace Power,2001,16(2):108-115.(in Chinese)
    [2]
    陈光.遄达900发动机非包容爆炸原因及思考[J].国际航空,2012(9):82-83. CHEN Guang.Reason and thinking Trent 900 engine uncontained explosion[J].International Aviation,2012(9):82-83.(in Chinese)
    [3]
    胡剑平,刘振侠,吕亚国.轴承腔壁面液膜厚度数值模拟与实验测量[J].航空计算技术,2013,43(2):68-71. HU Jianping,LIU Zhenxia,LV Yaguo.Comparison of simulation and measurement for film thickness in bearing chamber[J].Aeronautical Computing Technique,2013,43(2):68-71.(in Chinese)
    [4]
    吴昊天,陈国定.轴承腔油气两相泡状流动的数值研究[J].机械工程学报,2008,44(9):70-75. WU Haotian,CHEN Guoding.Numerical research on two-phase gas/oil bubble flow in bearing chamber[J].Chinese Journal of Mechanical Engineering,2008,44(9):70-75.(in Chinese)
    [5]
    李炎军,陈国定,刘亚军,等.航空发动机主轴承环下供油系统两相分相流动分析[J].润滑与密封,2009,34(5):58-61. LI Yanjun,CHEN Guoding,LIU Yajun,et al.Two-phase fractional flow analysis of aero-engine main bearing innerring oil flow system[J].Lubrication Engineering,2009,34(5):58-61.(in Chinese)
    [6]
    Floyd A F.Flaw detecting device and measuring instrument:US,228022[P].1940-04-21.
    [7]
    Farrall M,Simmons S,Hibberd S,et al.Modelling oil droplet film interaction in an aero-engine bearing chamber and comparison with experimental data[R].ASME Paper 2004-GT-53698,2004.
    [8]
    Bachalo W D.Measurement techniques for turbulent two-phase flow research[R].Beijing:International Symposium on Multiphase Fluid,Non-Newtonian Fluid and Physicochemical Fluid Flows,1997.
    [9]
    Cossali G E,Coghe A,Marengo M.The impact of a single drop on a wetted solid surface[J].Experiments in Fluids,1997,22(6):463-472.
    [10]
    Gorse P,Busam S,Dullenkopf K.Influence of operating condition and geometry on the oil film thickness in aero-engine bearing chambers[J].Journal of Engineering for Gas Turbines and Power,2006,128(1):103-110.
    [11]
    Mutchler C K,Larson C L.Splash amounts from waterdrop impact on a smooth surface[J].Water Resources Research,1971,7(1):195-200.
    [12]
    Glahn A,Busam S,Wittig S.Local and mean heat transfer coefficients along the internal housing walls of aero engine bearing chambers[R].ASME Paper 97-GT-261,1997.
    [13]
    Glahn A,Wittig S.Two-phase air/oil flow in aero engine bearing chambers:characterization of oil film flows[J].Journal of Engineering for Gas Turbines and Power,1996,118(3):578-589.
    [14]
    王军.航空发动机轴承腔油滴运动及油膜形成研究[D].西安:西北工业大学,2010. WANG Jun.Research of droplets movement and oil film formation of bearing cavity in aircraft[D].Xi'an:Northwestern Polytechnical University,2010.(in Chinese)
    [15]
    Faeth G M.Current status of droplet and liquid combustion[J].Progress in Energy and Combustion Science,1977,3(4):191-224.
    [16]
    Aidarinis J,Missirlis D,Yakinthos K,et al.CFD modeling and LDA measurements for the air-flow in an aero engine front bearing chamber[J].Journal of Engineering for Gas Turbines and Power,2011,133(8):082504.1-082504.8.
    [17]
    Berlemont A,Grancher M S,Gouesbet G.Heat and mass transfer coupling between vaporizing droplet and turbulence using a Lagrangian approach[J].International Journal of Heat and Mass Transfer,1996,38(16):3023-3034.
    [18]
    Beishuizen N A,Naud B,Roekaerts D.Evaluation of a modified Reynolds stress model for turbulent dispersed two-phase flows including two-way coupling[J].Turbulence and Combustion,2007,79(3):321-341.
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索

    Article Metrics

    Article views (1658) PDF downloads(827) Cited by()
    Proportional views
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return