Volume 30 Issue 2
Feb.  2015
Turn off MathJax
Article Contents
DING Shui-ting, WANG Zi-yao, LI Guo. Correlation analysis of energy and stress distributions on variable thickness turbine disk[J]. Journal of Aerospace Power, 2015, 30(2): 341-348. doi: 10.13224/j.cnki.jasp.2015.02.011
Citation: DING Shui-ting, WANG Zi-yao, LI Guo. Correlation analysis of energy and stress distributions on variable thickness turbine disk[J]. Journal of Aerospace Power, 2015, 30(2): 341-348. doi: 10.13224/j.cnki.jasp.2015.02.011

Correlation analysis of energy and stress distributions on variable thickness turbine disk

doi: 10.13224/j.cnki.jasp.2015.02.011
  • Received Date: 2013-10-18
  • Publish Date: 2015-02-28
  • A segmented theoretical method was proposed to derive the temperature and stress distributions of a variable thickness turbine disk under given heating energy on the inner and outer rims, and the correlation between the energy distributions presented by the energy transfer coefficient, and the temperature/stress distributions of the turbine disk was established. By applying the correlation to an aero-engine low pressure turbine disk and comparing the temperature and stress distributions with those obtained from numerical simulation, the results from these two methods show a good agreement; the relative deviations of the temperature and stress distributions are no more than 2% and 13%, respectively; under constant boundary heat flow condition, the temperature of the inner rim increases while that of the outer rim decreases; both the overall equivalent stress level and the maximum equivalent stress of the turbine disk decline with the increase of the energy transfer coefficient. The above results validate that the correlation between the energy and stress distributions obtained from the segmented theoretical method proposed is feasible and correct.

     

  • loading
  • [1]
    U.S.Department of Transportation Federal Aviation Administration.Guidance material for 14 CFR 33.75 safety analysis[R].Washington:U.S.:Federal Aviation Administration,Advisory Circular 33.75-1A,2009.
    [2]
    U.S.Department of Transportation Federal Aviation Administration.Guidance material for aircraft engine life-limited parts requirement[R].Washington:U.S.:Federal Aviation Administration,Advisory Circular 33.70-1,2009.
    [3]
    Yeh K Y,Han R P S.Analysis of high-speed rotating disks with variable thickness and inhomogeneity[J].Journal of Applied Mechanics,1994,61(1):186-191.
    [4]
    Thompson A S,Lester P A.Stresses in rotating disks at high temperature[J].Journal of Applied Mechanics,1946,13(1):A45-A52.
    [5]
    Timoshenko S P,Goodier J N.Theory of elasticity[M].New York:McGraw-Hill,1970.
    [6]
    Reddy T Y,Srinath H.Elastic stresses in a rotating anisotropic annular disk of variable thickness and variable density[J].International Journal of Mechanical Sciences,1974,16(2):85-89.
    [7]
    Peng X L,Li X F.Thermal stress in rotating functionally graded hollow circular disks[J].Composite Structures,2010,92(8):1896-1904.
    [8]
    Kordkheili S A,Naghdabadi R.Thermoelastic analysis of a functionally graded rotating disk[J].Composite Structures,2007,79(4):508-516.
    [9]
    Vullo V,Vivio F.Elastic stress analysis of non-linear variable thickness rotating disks subjected to thermal load and having variable density along the radius[J].International Journal of Solids and Structures,2008,45(20):5337-5355.
    [10]
    Bayat M,Saleem M,Sahari B B,et al.Mechanical and thermal stresses in a functionally graded rotating disk with variable thickness due to radially symmetry loads[J].International Journal of Pressure Vessels and Piping,2009,86(6):357-372.
    [11]
    Hassani A,Hojjati M H,Mahdavi E,et al.Thermo-mechanical analysis of rotating disks with non-uniform thickness and material properties[J].International Journal of Pressure Vessels and Piping,2012,98:95-101.
    [12]
    DING Shuiting,LI Guo,LUO Bin.Active control thermal-loading method to ameliorate stress in aeroengine turbine disk[J].Journal of Thermophysics and Heat Transfer,2013,27(2):274-285.
    [13]
    王元明.工程数学:数学物理方程与特殊函数[M].北京:高等教育出版社,2012.
    [14]
    吕文林.航空发动机强度计算[M].北京:国防工业出版社,1998.
    [15]
    杨桂通.弹塑性力学[M].北京:人民教育出版社,1980.
    [16]
    Belytschko T.Fluid-structure interaction[J].Computers & Structures,1980,12(4):459-469.
    [17]
    Morand H J P,Ohayon R.Fluid structure interaction[M].Chichester:John Wiley,1995.
    [18]
    Cardarelli F.Materials handbook[M].London:Springer,2000.
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索

    Article Metrics

    Article views (1239) PDF downloads(1007) Cited by()
    Proportional views
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return