Volume 31 Issue 6
Jun.  2016
Turn off MathJax
Article Contents
LI Jia, LI Hua-cong, FU Jiang-feng, WANG Shu-hong. Flow field characteristics of the U-shaped throttling constant differential pressure valve[J]. Journal of Aerospace Power, 2016, 31(6): 1469-1476. doi: 10.13224/j.cnki.jasp.2016.06.024
Citation: LI Jia, LI Hua-cong, FU Jiang-feng, WANG Shu-hong. Flow field characteristics of the U-shaped throttling constant differential pressure valve[J]. Journal of Aerospace Power, 2016, 31(6): 1469-1476. doi: 10.13224/j.cnki.jasp.2016.06.024

Flow field characteristics of the U-shaped throttling constant differential pressure valve

doi: 10.13224/j.cnki.jasp.2016.06.024
  • Received Date: 2014-10-08
  • Publish Date: 2016-06-28
  • As the research object of a U-shaped throttling constant differential pressure valve, numerical simulation study was carried out based on three-dimensional modeling technology, the preliminary model of pressure valve was designed, then structured grid was divided by using periodic mesh. Finally the inner-flow performance was simulated and the flow field of the pressure valve was analysed, and then the performances between different pressure valve's output opening were compared. The inner flow state indicates: under different flux and opening, the pressure gradient is large because of area change, pressure drop is mainly concentrated around the break zone, and some low-speed ranges and secondary vortex flows move around. The predicted performance of the external characteristics shows that: for both different flow rate and different opening degrees at the same flow conditions, pressure difference is maintained at around 0.9MPa, meeting the design requirements. And pressure change has a similar trend at different degrees of opening, the greater opening means the larger pressure, and low flow is accordingly faster.

     

  • loading
  • [1]
    樊思齐.航空发动机控制[M].西安:西北工业大学出版社,2008.
    [2]
    樊思齐.航空推进系统控制[M].西安:西北工业大学出版社,1995.
    [3]
    管彦深.航空动力装置控制[M].北京:国防工业出版社,1985.
    [4]
    安德森.计算流体力学基础及其应用[M].吴颂平,刘赵淼,译.北京:机械工业出版社,2007.
    [5]
    吴琪华.航空发动机调节[M].北京:国防工业出版社,1986.
    [6]
    要继业.基于Fluent的节流槽滑阀仿真[D].秦皇岛 河北:燕山大学,2012. YAO Jiye.Simulation of spool valve with notches based on fluent[D].Qinhuangdao Hebei:Yanshan University,2012.(in Chinese)
    [7]
    王东升.节流槽滑阀阀口流量系数及稳态液动力计算的研究[D].兰州:兰州理工大学,2008. WANG Dongsheng.Investigation into flow coefficient of orifice calculation of steady flow force of spool valve with notches[D].Lanzhou:Lanzhou University of Technology,2008.(in Chinese)
    [8]
    赵蕾.阀芯运动过程液压滑阀内部流场的CFD计算[D].太原:太原理工大学,2008. ZHAO Lei.CFD study for the flow field inside the hydraulic spool valve considering of the movement of valve element[D].Taiyuan:Taiyuan University of Technology,2008.(in Chinese)
    [9]
    WANG Anlin,DONG Yaning,ZHOU Pengju,et al.Robust design method for the seizure problem of hydraulic slide valve[J].Journal of Shanghai Jiao Tong University,2011,45(11):1637-1642.
    [10]
    魏艳艳,王宏宇,缪万波.某型涡轴发动机等压差活门建模分析[J].航空发动机,2014,40(4):25-31. WEI Yanyan,WANG Hongyu,MIAO Wanbo.Analysis on modeling of constant pressure diffence valve for a turboshaft engine[J].Aeroengine,2014,40(4):25-31.(in Chinese)
    [11]
    梁玲,张浩.高等学校计算机应用规划教材:UG NX 6基础教程[M].北京:清华大学出版社,2011.
    [12]
    温正,石良辰,任毅如.流体计算应用教程[M].北京:清华大学出版社,2008.
    [13]
    江帆,黄鹏.Fluent高级应用与实例分析[M].北京:清华大学出版社,2008.
    [14]
    徐文娟,韩建勇.工程流体力学[M].哈尔滨:哈尔滨工业大学出版社,2002.
    [15]
    李雄.U形槽滑阀阀口特性及稳态液动力研究[D].武汉:武汉科技大学,2013. LI Xiong.Research on the flow characteristics and the steady-state flow force of the U-shaped notch throttle orifice in spool valve[D].Wuhan:Wuhan Technology University,2013.(in Chinese)
    [16]
    WANG Xinhua,ZHENG Jian,SUN Shuwen,et al.Research on performance of slide-valve in water hydraulic servo-valve with hydrostatic bearing[R].Wuhan:International Conference on Mechanic Automation and Control Engineering,2010.
    [17]
    Amirante R,Moscatelli P G,Catalano L A.Evaluation of the flow force on a direct (single stage) proportional valve by means of a computational fluid dynamic analysis[J]. Energy Conversion and Management,2007,48(3):942-953.
    [18]
    WANG Xinhua,ZHENG Jian,LI Wei,et al.Design and analysis of slide valve used in water hydraulic servo valve based on flow field simulation[J].Applied Mechanics and Materials,2010,45(34/35):1279-1283.
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索

    Article Metrics

    Article views (1031) PDF downloads(570) Cited by()
    Proportional views
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return