Volume 32 Issue 11
Nov.  2017
Turn off MathJax
Article Contents
Oxyfuel combustion of propane based on rapidly mixed tubular flame technology[J]. Journal of Aerospace Power, 2017, 32(11): 2629-2637. doi: 10.13224/j.cnki.jasp.2017.11.009
Citation: Oxyfuel combustion of propane based on rapidly mixed tubular flame technology[J]. Journal of Aerospace Power, 2017, 32(11): 2629-2637. doi: 10.13224/j.cnki.jasp.2017.11.009

Oxyfuel combustion of propane based on rapidly mixed tubular flame technology

doi: 10.13224/j.cnki.jasp.2017.11.009
  • Received Date: 2016-04-21
  • Publish Date: 2017-11-28
  • An inherently safe technique of rapidly mixed tubular flame combustion, with the fuel and oxidizer individually injected into a combustor, was adopted to investigate the oxyfuel combustion of propane. The variations of flame structure and combustion stability with oxygen mole fraction were addressed. Based on propane/air combustion, it was found that the rapidly mixed combustion could obtain almost the same flame structure as that of the premixed combustion. Thereafter CO2 was used as the diluent, and combustion tests were conducted under different oxygen mole fractions. Results illustrated that when oxygen mole fraction was no more than 05, a uniform and stable tubular flame can be established from lean to rich limit; by increasing oxygen mole fraction to 06, the laminar flame became nonuniform in structure, however, the flame was stable; by raising oxygen mole fraction to 07, the stable tubular flame was merely obtained at lean combustion, and oscillatory combustion appeared when the equivalence ratio of 1.0. By further increasing oxygen mole fraction, the oscillation region was expanded. The combustion range for propane/oxygen mixture diluted by N2 and CO2 was examined when oxygen mole fraction was no more than 04. It was found that the flammable range diluted by N2 was wider than that diluted by CO2, and the minimum oxygen mole fraction to sustain propane/oxygen combustion diluted by CO2 was 018, higher than that of 0125 diluted by N2.

     

  • loading
  • [1]
    北京市环境保护局、北京市技术监督局.DB11/8472011 固定式燃气轮机大气污染物排放标准[S].北京:中国标准出版社,2011:1-5.
    [2]
    FOUST M,THOMSEN D,STICKLES R,et all.Development of the GE aviation low emissions TAPS Combustor for NEXT generation aircraft engines[J].AIAA-2012-0936,2012.
    [3]
    张弛,于博文,杨谦,等.弱旋流喷嘴的污染排放和燃烧稳定性分析[J].航空动力学报,2015,30(11):2575-2583.ZHANG Chi,YU Bowen,YANG Qian,et all.Analysis of lowswirl injector emissions and combustion stabilization.Journal of Aerospace Power,2015,30(11):2575-2583.(in Chinese)
    [4]
    Ernest Orlando Lawrence Berkeley National Laboratory.NERSC 20082009 annal report[R].Iawrence Berkeley National Laboratory,LBNL-3476E,2010.
    [5]
    KUTNE P,KAPADIA B K,MEIER W,et al.Experimental analysis of the combustion behaviour of oxyfuel flames in a gas turbine model combustor[J].Proceedings of the Combustion Institute,2011,33(2):3383-3390.
    [6]
    WALL T F.Combustion processes for carbon capture[J].Proceedings of the Combustion Institute,2007,31(6):31-47.
    [7]
    SUNDKVIST S G,DAHLQUIST A,JANCZEWSKI J,et al.Concept for a combustion system in oxyfuel gas turbine combined cycles[J].Journal of Engineering for Gas Turbines and Power,2013,136(10):101513.1-101513.12.
    [8]
    徐采松,胡砾元,罗永浩.旋流燃烧室内分级进风对燃烧污染物生成的影响[J].动力工程学报,2009,29(5):445-450.XU Caisong,HU Liyuan,LUO Yonghao,et al.Effects of staged air injection on combustion pollutant formation in a swirl combustor[J].Journal of Power Engineering,2009,29(5):445-450.(in Chinese)
    [9]
    SHEN D,MOST J M,JOULAIN P,et al.The effect of initial conditions for swirl turbulent diffusion flame with a straightexit burner[J].Combustion Science and Technology,2007,100(1):203-224.
    [10]
    BUHRE B J P,ELLIOTT L K,SHENG C D,et al.Oxyfuel combustion technology for coalfired power generation[J].Progress in Energy and Combustion Science,2005,31(4):283-307.
    [11]
    CHEN L,YONG S Z,GHONIEM A F.Oxyfuel combustion of pulverized coal:characterization,fundamentals,stabilization and CFD modeling[J].Fuel and Energy Abstracts,2012,38(2):14-25.
    [12]
    SCHELE J V.Use of direct flame impingement oxyfuel[J].Ironmaking and Steelmaking,2009,36(7):487-490.
    [13]
    VON SCHELE J.Oxyfuel combustion in the steel industry:energy efficiency and decrease of CO2 emissions[J].Energy Efficiency ,2010,3:83-102.
    [14]
    刘志付,赵恩录,张文玲,等. 玻璃熔窑全氧燃烧技术的开发[J].玻璃,2008,34(2):14-16.LIU Zhifu,ZHAO Enlu,ZHANG Wenling,et al. Development of pure oxygen combustion technology in glass furnace[J].Glass,2008,34(2):83-102. (in Chinese)
    [15]
    SEEPANA S,JAYANTI S.Experimental studies of flame extinction in a swirlstabilized oxyfuel burner[J].Fuel,2012,93(5):75-81.
    [16]
    SHI B L,JIE H,ISHIZUKA S.Carbon dioxide diluted methane/oxygen combustion in a rapidly mixed tubular flame burner[J].Combustion and Flame,2015,162(2):420-430.
    [17]
    LIU C Y,CHEN G,SIPCZ N,et al.Characteristics of oxyfuel combustion in gas turbines[J].Applied Energy,2012,89(1):387-394.
    [18]
    AMATO A,HUDAK B,DSOUZA P,et al.Measurements and analysis of CO and O2 emissions in CH4/CO2/O2 flames[J].Proceedings of the Combustion Institute,2011,33(2):3399-3405.
    [19]
    KUTNE P,KAPADIA B K,MEIER W,et al.Experimental analysis of the combustion behaviour of oxyfuel flames in a gas turbine model combustor[J].Proceedings of the Combustion Institute,2011,33(2):3383-3390.
    [20]
    ISHIZUKA S,MOTODAMARI T,SHIMOKURI D.Rapidly mixed combustion in a tubular flame burner[J].Proceedings of the Combustion Institute,2007,31(1):1085-1092.
    [21]
    ISHIZUKA S.On the behavior of premixed flames in a rotating flow field:establishment of tubular flames[J].Symposium on Combustion,1985,20(1):287-294.
    [22]
    ISHIZUKA S.Characteristics of tubular flames[J].Progress in Energy and Combustion Science,1993,19(3):187-226.
    [23]
    ISHIZUKA S,DUNNRANKIN D,PITZ R W,et al.Tubular combustion[M].New York:Momentum Press,2013.
    [24]
    SHI B L,SHIMOKURI D,ISHIZUKA S.Reexamination on methane/oxygen combustion in a rapidly mixed type tubular flame burner[J].Combustion and Flame,2014,161(5):1310-1325.
    [25]
    SYRED N,BER J M.Combustion in swirling flows:a review[J].Combustion and Flame,1974,23(2):143-201.
    [26]
    MILLER J A,BOWMAN C T.Mechanism and modeling of nitrogen chemistry in combustion[J].Progress in Energy and Combustion Science,1989,15(4):287-338.
    [27]
    LIU F,GUO H,SMALLWOOD G J.The chemical effect of CO2 replacement of N2 in air on the burning velocity of CH4 and H2 premixed flames[J].Combustion and Flame,2003,133(4):495-497.
    [28]
    METCALFE W K,BURKE S M,AHMED S S,et al.A hierarchical and comparative kinetic modeling study of C1C2 hydrocarbon and oxygenated fuels[J].International Journal of Chemical Kinetics,2013,45(10):638-675.
    [29]
    Reaction Design Incorporation. CHEMKIN PRO Release 15101[R].San Diego,CA:Reaction Design Incorporation,2010.
    [30]
    METGHALCHI M,KECK J C.Laminar burning velocity of propaneair mixtures at high temperature and pressure[J].Combustion and Flame,1980,38(2):143-154.
    [31]
    SHIMOKURI D,SHIRAGA Y,ISHII K,et al.An experimental study on the high frequency oscillatory combustion in tubular flame burners[J].Combustion and Flame,2014,161(8):2025-2037.
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索

    Article Metrics

    Article views (1236) PDF downloads(828) Cited by()
    Proportional views
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return