Volume 35 Issue 1
Jan.  2020
Turn off MathJax
Article Contents
Article Navigation >  Journal of Aerospace Power  > 2020  >  35(1): 169-177
ZHU Jiaxing, LI Huacong, FU Jiangfeng. Lubrication characteristics in contact state of journal bearings inside aero gear pump[J]. Journal of Aerospace Power, 2020, 35(1): 169-177. doi: 10.13224/j.cnki.jasp.2020.01.020
Citation: ZHU Jiaxing, LI Huacong, FU Jiangfeng. Lubrication characteristics in contact state of journal bearings inside aero gear pump[J]. Journal of Aerospace Power, 2020, 35(1): 169-177. doi: 10.13224/j.cnki.jasp.2020.01.020
shu

Lubrication characteristics in contact state of journal bearings inside aero gear pump

doi: 10.13224/j.cnki.jasp.2020.01.020

  • School of Power and Energy,Northwestern Polytechnical University,Xi’an 710072,China

  • Received Date: 2019-07-08
  • Publish Date: 2020-01-28
    Abstract
  • In order to solve the problem of aero-gear pump gear-shaft/bearing gap lubrication under high load condition, CFD simulation and gear-shaft rigid model were combined to realize the transient lubrication calculation based on the CFD radial motion coupled analysis. The bearings film three-dimensional thermohydrodynamic lubrication calculation model and rough surface micro-asperity contact model were established. On the basis of calculation of the gear-shaft radial motion orbit on the gear pump transient field influence, the model was used to achieve the analysis of the characteristics under high eccentricity/contact condition. Results showed that: the error between gear pump simulation results and experimental results was less than 10%. And the transient behavior of pressure distribution caused by gear pump transient field had an impact on the fluctuation shape of gear shaft radial load, leading to the change of bearings lubrication characteristics. By the numerical calculation for bearings lubrication model, it was found that: compared with non-contact condition, journal bearings lubrication state was more serious on the contact condition, with the higher temperature and lower viscosity.

     

    • FullText(HTML)
  • loading
    • References(19)
  • [1]
    COSTA L,MIRANDA A S,FILLON M,et al.An analysis of the influence of oil supply conditions on the thermohydrodynamic performance of a single-groove journal bearing［J］.Journal of Engineering Tribology,2003,217(2),133-144.
    [2]
    黎伟,汪久根,王庆九,等.多瓦可倾瓦径向滑动轴承热弹流润滑分析［J］.润滑与密封,2012,37(9):5-9. LI Wei,WANG Jiugen,WANG Qingjiu,et al.Thermo-elastohydrodynamic lubrication analysis on multi-tilting-pad journal bearing［J］.Lubrication Engineering,2012,37(9):5-9.(in Chinese)
    [3]
    BAGHERI M,AKBARZADEH S,TIKANI R,et al.Thermohydrodynamic analysis of foil journal bearings using differential quadrature method［J］.Journal of Engineering Tribology,2016,230(5):561-570.
    [4]
    SOLGHAR A A,GANDJALIKHAN N S A.Thermohydrodynamic behaviors of finite journal bearings with cavitation［J］.Mécanique and Ustries,2011,12(1):5-15.
    [5]
    朱少禹,孙军,李彪,等.计及轴颈倾斜的径向滑动轴承湍流润滑分析［J］.摩擦学学报,2019,39(2):235-247. ZHU Shaoyu,SUN Jun,LI Biao,et al.Analysis of turbulent lubrication of misaligned journal bearing［J］.Tribology,2019,39(2):235-247.(in Chinese)
    [6]
    段京华,孙军.计及表面形貌和热效应的燃油泵滑动轴承润滑分析［J］.机械设计,2016,33(6):1-5. DUAN Jinghua,SUN Jun.Lubrication analysis of fuel pump journal bearing considering surface topography and thermal effect［J］.Journal of Machine Design,2016,33(6):1-5.(in Chinese)
    [7]
    富彦丽,马希直,朱均.圆轴承三维热流体动力润滑的研究［J］.航空动力学报,2002,17(4):469-474. FU Yanli,MA Xizhi,ZHU Jun.Three-dimensional thermohydrodynamic analysis of circular journal bearing［J］.Journal of Aerospace Power,2002,17(4):469-474.(in Chinese)
    [8]
    张传伟,李东升,古乐,等.精密H型气体轴承的动态起动接触行为分析［J］.机械工程学报,2018,54(6):18-24. ZHANG Chuanwei,LI Dongsheng,GU Le,et al.Dynamic contact behaviors of precision H-type air bearings during startup process［J］.Journal of Mechanical Engineering,2018,54(6):18-24.(in Chinese)
    [9]
    GU C X,MENG X H,ZHANG D,et al.A transient analysis of the textured journal bearing considering micro and macro cavitation during an engine cycle［J］.Journal of Engineering Tribology,2017,231(10):1289-1306.
    [10]
    CUI S H,GU L,FILLON M,et al.The effects of surface roughness on the transient characteristics of hydrodynamic cylindrical bearings during startup［J］.Tribology International,2018,128:421-428.
    [11]
    DU R L,CHEN Y L,ZHOU H,et al.Numerical analysis of the lubricating gap between the gear shaft and the journal bearing in water hydraulic internal gear pumps［J］.Journal of Mechanical Engineering Science,2018,232(12):2297-2314.
    [12]
    符江锋,李华聪,樊丁,等.一种自冷却结构燃油泵滑动轴承润滑特性分析［J］.北京航空航天大学学报,2018,44(10):2052-2062. FU Jiangfeng,LI Huacong,FAN Ding,et al.Lubrication characteristics analysis of a type of self-cooling structure fuel pump sliding bearings［J］.Journal of Beijing University of Aeronautics and Astronautics,2018,44(10):2052-2062.(in Chinese)
    [13]
    符江锋,李昆,李华聪,等.基于润滑特性仿真的燃油泵滑动轴承优化设计［J］.摩擦学学报,2018,38(5):512-520. FU Jiangfeng,LI Kun,LI Huacong,et al.Optimization design of fuel pump sliding bearing based on the analysis of lubrication characteristics［J］.Tribology,2018,38(5):512-520.(in Chinese)
    [14]
    MO J,GU C,PAN X,et al.Experimental and numerical study of the influence of loading direction on the lubrication and cooling of self-circulating oil bearing system applied in internal gear pumps［J］.Journal of Engineering Tribology,2018,232(4):415-426.
    [15]
    MO J,GU C,PAN X,et al.A thermohydrodynamic analysis of the self-lubricating bearings applied in gear pumps using computational fluid dynamics method［J］.Journal of Tribology,2018,140(1):011102.1-011102.9.
    [16]
    LORENZ N,OFFNER G,KNAUS O.Fast thermo-elasto-hydrodynamic modeling approach for mixed lubricated journal bearings in internal combustion engines［J］.Journal of Engineering Tribology,2015,229(8):962-976.
    [17]
    SANG M C,KHONSARI M M.Wear simulation for the journal bearings operating under aligned shaft and steady load during start-up and coast-down conditions［J］.Tribology International,2016,97:440-466.
    [18]
    LEE S C,REN N.Behavior of elastic-plastic rough surface contacts as affected by surface topography,load,and material hardness［J］.Tribology Transactions,1996,39(1):67-74.
    [19]
    FERRON J J,FRENE J J,BONCOMPAIN R R.A study of the thermohydrodynamic performance of a plain journal bearing comparison between theory and experiments［J］.Journal of Lubrication Technology,1983,105(3):422-428.
    • Relative Articles
    • Supplements(0)
    • Cited By
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索
    Get Citation
    PDF(5027.0KB)
    XML

    Article Metrics

    Article views (692) PDF downloads(385) Cited by()
    Proportional views
    Related

    Copyright © 《Journal of Aerospace Power》 All Rights Reserved.

    Supported by: Beijing Renhe Information Technology Co., Ltd.  

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return