Volume 37 Issue 5
May  2022
Turn off MathJax
Article Contents
Article Navigation >  Journal of Aerospace Power  > 2022  >  37(5): 1030-1041
XUAN Liming, ZOU Zhengping, ZHAO Qiang, HUANG Lin, DU Jinlin, CHEN Yun. Effect of tip injection on aerodynamic performance of squealer tip[J]. Journal of Aerospace Power, 2022, 37(5): 1030-1041. doi: 10.13224/j.cnki.jasp.20210104
Citation: XUAN Liming, ZOU Zhengping, ZHAO Qiang, HUANG Lin, DU Jinlin, CHEN Yun. Effect of tip injection on aerodynamic performance of squealer tip[J]. Journal of Aerospace Power, 2022, 37(5): 1030-1041. doi: 10.13224/j.cnki.jasp.20210104
shu

Effect of tip injection on aerodynamic performance of squealer tip

doi: 10.13224/j.cnki.jasp.20210104
  • 1.

    National Key Laboratory of Science and Technology on Aero-Engine Aero-thermodynamics，School of Energy and Power Engineering，Beihang University，Beijing 100191，China

  • 2.

    Research Institute of Aero-Engine，Beihang University，Beijing 102206，China

  • 3.

    Shenyang Engine Research Institute，Aero Engine Corporation of China,Shenyang 110015，China

  • Received Date: 2021-03-09
  • Publish Date: 2022-05-28
    Abstract
  • A low-speed blade profile of a certain aero-engine high-pressure turbine rotor blade obtained by similarity transformation was studied,and the effect of tip injection on the aerodynamic performance of the squealer tip under the condition of relative casing motion was discussed.The results showed that tip injection had limited effect on the aerodynamic performance of the flat tip,but it could reduce the efficiency of the squealer tip.Under the same injection condition,the squealer tip can reduce the tip leakage loss by 20% compared with the flat tip.The energy dissipation of the leakage flow in the cavity mainly came from the interaction of the leakage flow with cavity vortex and scraping vortex.Under the injection condition,scraping vortex was still the dominant flow structure of the leakage flow.The injection position had a significant effect on the performance of the squealer tip; the jet holes near the suction side and leading edge were conducive to the improvement of the aerodynamic performance.Based on the above research,a leakage flow loss model for the squealer tip was established,and the error of new model was reduced by 31.6% compared with the Denton model.

     

    • FullText(HTML)
  • loading
    • References(30)
  • [1]
    DENTON J D.The 1993 IGTI scholar lecture:loss mechanisms in turbomachines[J].Journal of Turbomachinery,1993,115（4）:621-656.
    [2]
    HAN J C.Fundamental gas turbine heat transfer[J].Journal of Thermal Science & Engineering Applications,2013,5（2）:021007.1-021007.15.
    [3]
    ZOU Z,WANG S,LIU H,et al.Axial turbine aerodynamics for aero-engines[M].Singapore City,Singapore:Springer,2018.
    [4]
    邹正平,綦蕾,李维,等.上游尾迹与涡轮转子泄漏流相互作用数值模拟[J].航空动力学报,2010,25（1）:58-66.
    [5]
    BINDON J P.The measurement and formation of tip clearance loss[J].Journal of Turbomachinery,1989,111（3）:257-263.
    [6]
    YARAS M I,SJOLANDER S A.Prediction of tip leakage losses in axial turbine[J].ASME Paper 90-GT-154,1990.
    [7]
    GAO J,ZHENG Q,XU T,et al.Inlet conditions effect on tip leakage vortex breakdown in unshrouded axial turbines[J].Energy,2015,91:255-263.
    [8]
    HUANG A.Loss mechanisms in turbine tip clearance[D].Cambridge,USA:Massachusetts Institute of Technology,2011.
    [9]
    魏佐君,段文华,乔渭阳,等.涡轮转子叶尖泄漏涡涡核稳定性及控制[J].航空动力学报,2018,33（9）:2139-2149.
    [10]
    BUNKER R S.Axial turbine blade tips:function,design,and durability[J].Journal of Propulsion and Power,2006,22（2）:271-285.
    [11]
    HEYS F J G,HODSON H P.The effect of blade tip geometry on the tip leakage flow in axial turbine cascades[J].Journal of Turbomachinery,1992,114（3）:643-651.
    [12]
    邹正平,姚李超,轩笠铭,等.涡轮转子凹槽叶尖泄漏流动气动热力特征[J].推进技术,2020,41（9）:1975-1987.
    [13]
    ZOU Z,SHAO F,LI Y,et al.Dominant flow structure in the squealer tip gap and its impact on turbine aerodynamic performance[J].Energy,2017,138:167-184.
    [14]
    杜金霖,邹正平,黄霖,等．计及机匣相对运动的涡轮叶片叶顶凹槽流动研究[J].实验流体力学,2021,35（2）:22-35.
    [15]
    KRISHNABABU S K,NEWTON P J,DAWES W N,et al.Aero-thermal investigations of tip leakage flow in axial flow turbines:Part Ⅰ effect of tip geometry and tip clearance gap[J].Journal of Turbomachinery，2009，131（1）:1-14.
    [16]
    KEGALJ M,SCHMID G,SCHIFFER H P,et al.Experimental and numerical investigation of tip leakage flow in a 1/2 stage turbine rig comparing flat and cavity-squealer tip geometries[R].ASME Paper GT2012-69568,2012.
    [17]
    杜昆,李军.涡轮叶片凹槽状叶顶非定常流动传热特性的数值研究[J].推进技术,2017,38（3）:551-558.
    [18]
    皮骏,杜旭博,孔庆国,等.冲击式凹槽叶尖流动换热特性[J].航空动力学报,2019,34（2）:331-340.
    [19]
    王维杰,卢少鹏,马海腾,等.高压涡轮尾切凹槽叶尖冷却换热特性[J].航空动力学报,2019,34（10）:2131-2139.
    [20]
    VOLINO R J.Control of tip leakage in a high pressure turbine cascade using tip blowing[R].ASME Paper GT2016-56511,2016.
    [21]
    WANG Y,SONG Y,YU J,et al.Effect of cooling injection on the leakage flow of a turbine cascade with honeycomb tip[J].Applied Thermal Engineering,2018,133:690-703.
    [22]
    ZHOU Z,CHEN S,LI W,et al.Thermal performance of blade tip and casing coolant injection on a turbine blade with cavity and winglet-cavity tip[J].International Journal of Heat and Mass Transfer,2019,130:585-602.
    [23]
    GAO J,ZHENG Q,ZHANG Z,et al.Aero-thermal performance improvements of unshrouded turbines through management of tip leakage and injection flows[J].Energy,2014,69:648-660.
    [24]
    NIU M,ZANG S.Experimental and numerical investigations of tip injection on tip clearance flow in an axial turbine cascade[J].Experimental Thermal and Fluid Science,2011,35（6）:1214-1222.
    [25]
    ZHOU C,HODSON H.The tip leakage flow of an unshrouded high pressure turbine blade with tip cooling[J].Journal of Turbomachinery,2011,133（4）:041028.1-041028.12.
    [26]
    ZENG F,DU J,HUANG L,et al.An experimental method for squealer tip flow field considering relative casing motion[J].Chinese Journal of Aeronautics,2020,33（7）:1942-1952.
    [27]
    Erhard J.Design,construction and commissioning of a transonic test-turbine facility[D].Graz,Austria:Graz University of Technology,2000.
    [28]
    YOUNG J B,HORLOCK J H.Defining the efficiency of a cooled Turbine[J].Journal of Turbomachinery,2006,128（4）:658-667.
    [29]
    SCHLICHTING H,GERSTEN K.Boundary-layer theory[M].New York,USA:McGraw-Hill,1979.
    [30]
    BAKER S.Regions of recirculating flow associated with two-dimensional steps[D].Guildford,UK:University of Surrey,1977.
    • Relative Articles
    • Supplements(0)
    • Cited By
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索
    Get Citation
    PDF(2356.0KB)
    XML

    Article Metrics

    Article views (450) PDF downloads(75) Cited by()
    Proportional views
    Related

    Copyright © 《Journal of Aerospace Power》 All Rights Reserved.

    Supported by: Beijing Renhe Information Technology Co., Ltd.  

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return