| Citation: | WEI Hong, ZU Yingqing. Enhanced heat transfer performance and flow resistance characteristics of the double-wall cooling structures with jet impingement and pin fins[J]. Journal of Aerospace Power, 2024, 39（8）：20220489 doi: 10.13224/j.cnki.jasp.20220489
|
For the double-wall cooling structure with jet impingement holes and pin fins, in order to study the influences of non-dimansional row spacing and dimensionless hole pitch of the jet impingement holes, the dimensionless diameter of pin fins and the jet impingement Reynolds number on the enhanced heat transfer performance and flow resistance characteristics, experimental studies were conducted based on various geometrical and flow parameters in present study. In addition, the corresponding numerical simulations were also carried out according to the experimental conditions. The results showed that on the whole internal wall surface of the jet impingement target plate with pin fins, the area-averaged Nusselt number monotonically increased with the increase of the jet impingement Reynolds number, and basically presented a linearly increasing tendency. In general, the area-averaged Nusselt number of the wall surface of pin fins was slightly higher than that on the internal wall surface of the jet impingement target plate. With the increase of dimensionless diameter of pin fins, the area-averaged Nusselt number of the entire internal wall surface of the double-wall cooling structure decreased firstly and then increased. In addition, the area-averaged Nusselt number of the entire internal wall surface decreased with the increase of non-dimensionla row spacing. However, the area-averaged Nusselt number of the entire internal wall surface was not sensitive to the variation of non-dimensional hole pitch. The discharge coefficient of the double-wall cooling structure with jet impingement holes and pin fins increased with the increase of the jet impingement Reynolds number, the dimensionless row spacing and non-dimansional hole pitch of jet impingement holes, but decreased with the increase of dimensionless diameter of pin fins.
| [1] |
王磊,张靖周,杨卫华. 密集型阵列冲击射流换热特性实验[J]. 航空动力学报,2009,24(6): 1264-1269. WANG Lei,ZHANG Jingzhou,YANG Weihua. Experimental research on heat transfer characteristics of denser jet array impingement[J]. Journal of Aerospace Power,2009,24(6): 1264-1269. (in Chinese
WANG Lei, ZHANG Jingzhou, YANG Weihua. Experimental research on heat transfer characteristics of denser jet array impingement[J]. Journal of Aerospace Power, 2009, 24(6): 1264-1269. (in Chinese)
|
| [2] |
JANG J H,CHIU H C,YAN W M. Impinging cooling of film hole surface using transient liquid crystal thermograph[J]. International Communications in Heat and Mass Transfer,2013,44: 23-30. doi: 10.1016/j.icheatmasstransfer.2013.03.009
|
| [3] |
FECHTER S,TERZIS A,OTT P,et al. Experimental and numerical investigation of narrow impingement cooling channels[J]. International Journal of Heat and Mass Transfer,2013,67: 1208-1219. doi: 10.1016/j.ijheatmasstransfer.2013.09.003
|
| [4] |
LIU Haiyong,LIU Songling,QIANG Hongfu,et al. Aerodynamic investigation of impingement cooling in a confined channel with staggered jet array arrangement[J]. Experimental Thermal and Fluid Science,2013,48: 184-197. doi: 10.1016/j.expthermflusci.2013.02.023
|
| [5] |
单文娟,毛军逵,李毅,等. 斜向冲击强化换热特性试验[J]. 航空动力学报,2013,28(3): 701-708. SHAN Wenjuan,MAO Junkui,LI Yi,et al. Experiment on heat transfer characteristics with inclined impingement[J]. Journal of Aerospace Power,2013,28(3): 701-708. (in Chinese
SHAN Wenjuan, MAO Junkui, LI Yi, et al. Experiment on heat transfer characteristics with inclined impingement[J]. Journal of Aerospace Power, 2013, 28(3): 701-708. (in Chinese)
|
| [6] |
LEE J,REN Zhong,LIGRANI P,et al. Crossflows from jet array impingement cooling: hole spacing,target plate distance,Reynolds number effects[J]. International Journal of Thermal Sciences,2015,88: 7-18. doi: 10.1016/j.ijthermalsci.2014.09.003
|
| [7] |
蒋新伟,许卫疆,朱惠人. 冲击射流在凹坑壁面通道内的换热特性研究[J]. 工程热物理学报,2016,37(12): 2638-2644. JIANG Xinwei,XU Weijiang,ZHU Huiren. Study of heat transfer characteristics in a dimpled wall channel with impingement jets[J]. Journal of Engineering Thermophysics,2016,37(12): 2638-2644. (in Chinese
JIANG Xinwei, XU Weijiang, ZHU Huiren. Study of heat transfer characteristics in a dimpled wall channel with impingement jets[J]. Journal of Engineering Thermophysics, 2016, 37(12): 2638-2644. (in Chinese)
|
| [8] |
CHEN Lingling,BRAKMANN R G A,WEIGAND B,et al. Experimental and numerical heat transfer investigation of an impingement jet array with V-ribs on the target plate and on the impingement plate[J]. International Journal of Heat and Fluid Flow,2017,68: 126-138. doi: 10.1016/j.ijheatfluidflow.2017.09.005
|
| [9] |
蒋新伟,许卫疆,朱惠人. 带凹坑楔形通道内射流冲击换热特性实验[J]. 航空动力学报,2017,32(12): 2981-2987. JIANG Xinwei,XU Weijiang,ZHU Huiren. Experiment of impingement heat transfer characteristics in dimpled wedge channel[J]. Journal of Aerospace Power,2017,32(12): 2981-2987. (in Chinese
JIANG Xinwei, XU Weijiang, ZHU Huiren. Experiment of impingement heat transfer characteristics in dimpled wedge channel[J]. Journal of Aerospace Power, 2017, 32(12): 2981-2987. (in Chinese)
|
| [10] |
KIM S H,AHN K H,PARK J S,et al. Local heat and mass transfer measurements for multi-layered impingement/effusion cooling: effects of pin spacing on the impingement and effusion plate[J]. International Journal of Heat and Mass Transfer,2017,105: 712-722. doi: 10.1016/j.ijheatmasstransfer.2016.10.007
|
| [11] |
RAO Yu,LIU Yuyang,WAN Chaoyi. Multiple-jet impingement heat transfer in double-wall cooling structures with pin fins and effusion holes[J]. International Journal of Thermal Sciences,2018,133: 106-119. doi: 10.1016/j.ijthermalsci.2018.07.021
|
| [12] |
韦宏,祖迎庆. 双层壁冷却结构中多排射流冲击冷却的换热和流阻特性[J]. 航空动力学报,2021,36(8): 1621-1632. WEI Hong,ZU Yingqing. Heat transfer and flow resistance characteristics of multi-row jet impingement cooling in double-wall cooling structure[J]. Journal of Aerospace Power,2021,36(8): 1621-1632. (in Chinese doi: 10.13224/j.cnki.jasp.20200486
WEI Hong, ZU Yingqing. Heat transfer and flow resistance characteristics of multi-row jet impingement cooling in double-wall cooling structure[J]. Journal of Aerospace Power, 2021, 36(8): 1621-1632. (in Chinese) doi: 10.13224/j.cnki.jasp.20200486
|
| [13] |
HAM J C,DUTTA S,EKKAD S. Gas turbine heat transfer and cooling technology [M]. 2nd ed. New York: Taylor & Francis Group,2012: 14-67.
|
| [14] |
MOFFAT R J. Describing the uncertainties in experimental results[J]. Experimental Thermal and Fluid Science,1988,1(1): 3-17. doi: 10.1016/0894-1777(88)90043-X
|
| [15] |
JUNG E Y,PARK C U,LEE D H,et al. Effect of the injection angle on local heat transfer in a showerhead cooling with array impingement jets[J]. International Journal of Thermal Sciences,2018,124: 344-355. doi: 10.1016/j.ijthermalsci.2017.10.033
|
| [16] |
LEE K D,CHOI D W,KIM K Y. Optimization of ejection angles of double-jet film-cooling holes using RBNN model[J]. International Journal of Thermal Sciences,2013,73: 69-78. doi: 10.1016/j.ijthermalsci.2013.05.015
|
| [17] |
JIANG Yuting,ZHENG Qun,DONG Ping,et al. Conjugate heat transfer analysis of leading edge and downstream mist–air film cooling on turbine vane[J]. International Journal of Heat and Mass Transfer,2015,90: 613-626. doi: 10.1016/j.ijheatmasstransfer.2015.07.005
|
| [18] |
KE Zhaoqing,WANG Jianhua. Conjugate heat transfer simulations of pulsed film cooling on an entire turbine vane[J]. Applied Thermal Engineering,2016,109: 600-609. doi: 10.1016/j.applthermaleng.2016.08.132
|
| [19] |
JIANG Yuting,WAN Xinchao,MAGAGNATO F,et al. Multi-step optimizations of leading edge and downstream film cooling configurations on a high pressure turbine vane[J]. Applied Thermal Engineering,2018,134: 203-213. doi: 10.1016/j.applthermaleng.2018.02.012
|
| [20] |
JIANG Yuting,LIN Hongfei,YUE Guoqiang,et al. Aero-thermal optimization on multi-rows film cooling of a realistic marine high pressure turbine vane[J]. Applied Thermal Engineering,2017,111: 537-549. doi: 10.1016/j.applthermaleng.2016.09.143
|
| [21] |
陈朔. 层板冷却单元的流动换热计算模型研究[D]. 哈尔滨: 哈尔滨工业大学,2015. CHEN Shuo. Research on calculation model of flow and heat transfer of lamilloy cooling unit[D]. Harbin: Harbin Institute of Technology,2015. (in Chinese
CHEN Shuo. Research on calculation model of flow and heat transfer of lamilloy cooling unit[D]. Harbin: Harbin Institute of Technology, 2015. (in Chinese)
|
DownLoad:
