| Citation: | JIANG Yong-jian, HE Li-ming, SU Jian-yong, YU Jin-lu. Numerical investigation on improvement of film cooling effectiveness with small coolant jets[J]. Journal of Aerospace Power, 2008, 23(8): 1375-1380. |
| [1] |
Bunker R S.Film cooing effectiveness due to discrete holes with a transverse surface slot[R].ASME Paper GT-2002-30178,2002.
|
| [2] |
Wang T,Chintalapati S,Bunker R S,et al.Jet mixing in a slot[J].Experimental Thermal and Fluid Science,2000,22:1-17.
|
| [3] |
Schmidt D,Sen B,Bogard D.Film cooling with compound angle holes:adiabatic effectiveness[J].Journal of Turbomachinary,1996,118:807-813.
|
| [4] |
朱惠人,许都纯,刘松龄.气膜孔形状对排孔下游冷却效率的影响[J].航空学报,2002,23(1):75-78.ZHU Huiren,XU Duchun,LIU Songling.Effects of hole shape on film cooling effectiveness[J].Acta Aeronautic et Astronautic Sinica,2002,23(1):75-78.(in Chinese)
|
| [5] |
林宇震.燃烧室多斜孔壁气膜冷却研究[D].北京:北京航空航天大学,1997.
|
| [6] |
Nasir H,Acharya S,Ekkad S.Improved film cooling from cylindrical angled holes with triangular tabs:effect of tab orientations[J].International Journal of Heat and Fluid,2003,24:657-668.
|
| [7] |
李永康,张靖周,姚玉.利用三角形突片改善气膜冷却效率的数值研究[J].航空动力学报,2006,21(1):83-87.LI Yongkang,ZHANG Jingzhou,YAO Yu.Numerical investigation on improvement of film cooling effectiveness using delta-shaped tabs[J].Journal of Aerospace Power,2006,21(1):83-87.(in Chinese)
|
| [8] |
Yiping Lu,Hasan Nasir,Ekkad S V.Film cooling from a row of holes embedded in transverse slots[R].ASME Paper GT2005-68598,2005.
|
| [9] |
Na S,Shih T I P.Increasing adiabatic film cooling effectiveness by using an upstream ramp[R].ASME Paper GT2006-91163,2006.
|
| [10] |
Javadi K,Taeibi-Rahni M,Darbandi M.Jet into cross flow boundary layer control an innovation in gas turbine blade cooling[R].35th AIAA Fluid Dynamics Conference,AIAA 2005-5272,2005.
|
| [11] |
Leylek J H,Zerkle R D.Discrete jet film cooling:a comparison of computational results with experiments[J].ASME Journal of Turbomachinery,1994,116:358-368.
|