Volume 26 Issue 11
Nov.  2011
Turn off MathJax
Article Contents
WANG Xing-tao, ZHANG Jing-zhou, TAN Xiao-ming. Numerical simulation on impingement cooling characteristics of pulsed detonation tube[J]. Journal of Aerospace Power, 2011, 26(11): 2515-2521.
Citation: WANG Xing-tao, ZHANG Jing-zhou, TAN Xiao-ming. Numerical simulation on impingement cooling characteristics of pulsed detonation tube[J]. Journal of Aerospace Power, 2011, 26(11): 2515-2521.

Numerical simulation on impingement cooling characteristics of pulsed detonation tube

  • Received Date: 2010-11-15
  • Rev Recd Date: 2011-02-12
  • Publish Date: 2011-11-28
  • According to axial wall temperature distributions on pulsed detonation chamber wall measured from experiment,the quasi-steady state heat flux along the detonation tube with ladder distribution was deduced under a specific frequency.Based on the quasi-steady thermal load,a series of computations were conducted to analyze the cooling effects with array jet impingement.The results show that:the jet velocity from rear rows is bigger than that from the front rows due to end wall effects,the cooling action is stronger near the pulsed detonation tube edge,and the impingement cooling effect is worse in the middle part because the impinging jet is weakened by cross-flow forming from the front rows.Under the same cooling flow Reynolds number at circular passage inlet,the array jet holes are reasonably arranged at middle area of pulsed detonation chamber.When the ratio of the impinging space to diameter is 1.5,the cooling effect seems to be best with uniform axial temperature distribution and lowest peak temperature.And smaller diameter of the cooling holes is also beneficial to improving the cooling effects.

     

  • loading
  • [1]
    严传俊,范玮.脉冲爆震发动机原理及关键技术[M].西安:西北工业大学出版社,2005.
    [2]
    Dean A J.A review of of PDE development for propulsion application .AIAA Paper 2007-985,2007.
    [3]
    黄希桥,严传俊,范玮,等.脉冲爆震燃烧效率的探索性试验研究[J].航空动力学报,2006,21(6):962-966. HUANG Xiqiao,YAN Chuanjun,FAN Wei,et al.Preliminary experimental study of pulse detonation combustion efficiency[J].Journal of Aerospace Power,2006,21(6):962-966.(in Chinese)
    [4]
    张义宁,王家骅,张靖周.两相多循环爆震波特性研究[J].航空动力学报,2006,21(5):789-794. ZHANG Yining,WANG Jiahua,ZHANG Jingzhou.Investigation of two-phase and multi-cycle detonation[J].Journal of Aerospace Power,2006,21(5):789-794.(in Chinese)
    [5]
    Hoke J,Bradley R,Schauer F.Heat transfer and thermal management in a pulsed detonation engine .AIAA Paper 2003-6486,2003.
    [6]
    Kasahara J,Takazava T,Arai T,et al.Experimental study of impulse and heat transfer on pulse detonation engines .AIAA Paper 2002-4071,2002.
    [7]
    郑龙席,严传俊,范玮,等.脉冲爆震发动机模型机爆震室壁温分布试验研究[J].燃烧科学与技术,2003,9(4):344-347. ZHENG Longxi,YAN Chuanjun,FAN Wei,et al.Experimental investigation on outer wall temperature distribution of a pulsed detonation engine model[J].Journal of Combustion Science and Technology,2003,9(4):344-347.(in Chinese)
    [8]
    郑龙席,严传俊,李牧.多循环PDE模型机爆震室壁温分布数值模拟[J].燃烧科学与技术,2007,13(5):414-420. ZHENG Longxi,YAN Chuanjun,LI Mu.Numerical simulation on detonation chamber wall temperature distribution of a multi-cycle pulse detonation engine model[J].Journal of Combustion Science and Technology,2007,13(5):414-420.(in Chinese)
    [9]
    宫继双,范育新,王家骅,等.爆震管壁面热负荷实验研究[J].航空动力学报,2009,24(9):1952-1958. GONG Jishuang,FAN Yuxin,WANG Jiahua,et al.Experimental study on heat load of detonation tube[J].Journal of Aerospace Power,2009,24(9):1952-1958.(in Chinese)
    [10]
    Ghosn L J, Zhu D.Thermal barrier and protective coating to improve the durability of a combustor under a pulse detonation engine enviroment .AIAA Paper 2007-2070, 2007.
    [11]
    Ajmani K,Breisacher K J.Multi-cycle analysis of an ejector-cooled pulse detonation device .AIAA Paper 2004-3915,2004.
    [12]
    Ajmani K,Breisacher K J,Ghosn L J,et al.Numerical and experimental studies of a film cooled pulsed detonation tube .AIAA Paper 2005-3059,2005.
    [13]
    涂洪妍,范玮,范珍涔,等.基于主动冷却的爆震爆震火箭发动机燃油加温实验研究[J].航空工程进展,2010,1(1):95-98. TU Hongyan,FAN Wei,FAN Zhencen,et al.The experimental of fule-heating based on active cooling in pulse detonation rocket engines[J].Advances in Aeronautical Science and Engineering,2010,1(1):95-98.(in Chinese)
    [14]
    范育新,王家骅,宫继双,等.壁温蒸发器对脉冲爆震发动机工作性能的影响[J].航空学报,2010,31(1):82-87. FAN Yuxin,WANG Jiahua,GONG Jishuang,et al.Effects of wall-evaporator on performance of a pulse detonation engine[J].Acta Aeronautica et Astronautica Sinica,2010,31(1):82-87.(in Chinese)
    [15]
    张靖周,李永康,谭晓茗,等.阵列射流冲击冷却局部对流换热特性的数值计算与试验验证[J].航空学报,2004,25(4): 339-342. ZHANG Jingzhou,LI Yongkang,TAN Xiaoming,et al.Numerical computation and experimental investigation on local convective heat transfer characteristics for jet array impingement[J].Acta Aeronautica et Astronautica Sinica,2004,25(4):339-342.(in Chinese)
    [16]
    谭蕾,张靖周,杨卫华.半封闭肋化通道射流冲击换热特性的数值研 究与实验验证[J].航空学报,2008,29(5):1105- 1111. TAN Lei,ZHANG Jingzhou,YANG Weihua. Numerical computation and experimental examination of convective heat transfer characteristics of jet impingement inside semi-confined rib-roughed channel[J].Acta Aeronautica et Astronautica Sinica,2008,29(5):1105-1111.(in Chinese)
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索

    Article Metrics

    Article views (1798) PDF downloads(56) Cited by()
    Proportional views
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return