| Citation: | LANG Xudong,LI Wei,DAI Jinxin,et al.Test on effect of swallowing water on component performance of reverse⁃flow combustor[J].Journal of Aerospace Power,2022,37(7):1345‑1351. doi: 10.13224/j.cnki.jasp.20210264 |
The test of a certain annular reverse⁃flow combustor performance change after swallowing water was carried out,the combustor performance was measured,including the inlet temperature,combustion efficiency,equivalent temperature rise,overall temperature distribution factor (OTDF) and radial temperature distribution factor (RTDF),etc.The results showed that:when the mass of swallowing water ranged from zero to 5%,with the increase of the mass of swallowing water in all flight states,the inlet temperature and total pressure loss decreased,equivalent temperature rise decreased and ground idle combustion efficiency decreased from 99.3% to 97.2%.overall temperature distribution factor and radial temperature distribution factor increased,of which overall temperature distribution factor increased from 0.23 to 0.28 in design state.The lean blowout fuel and air ratio of ground idle state increased from 0.004 5 to 0.006 5 and the lean blowout boundary became narrower.
| [1] |
金如山,索建秦.先进燃气轮机燃烧室[M].北京:航空工业出版社出版,2016.
|
| [2] |
程卫华,杨士杰,魏德明,等.航空涡轮喷气和涡轮风扇发动机通用规范:GJB241A⁃2010[S].北京:总装备部军标出版发行部,2010:38⁃42.
|
| [3] |
易军,单晓明,何峻,等.航空涡轮螺桨和涡轮轴发动机通用规范:GJB242A⁃2018[S].北京:国家军用标准出版发行部,2018:59⁃60.
|
| [4] |
旷桂兰,王道波,单晓明,等.某型航空涡轴发动机整机吞水性能试验[J].航空动力学报,2009,24(11):2415⁃2420.
KUANG Guilan,WANG Daobo,SHAN Xiaoming,et al.Swallowing water capability experiment of one turbine shaft overall aviation engine[J].Journal of Aerospace Power,2009,24(11):2415⁃2420.(in Chinese)
|
| [5] |
马庆祥.航空发动机地面模拟吞水试验[J].燃气涡轮试验与研究,2002,15(4):39⁃44.
MA Qingxiang.Aeroengine sea level water ingestion simulation test[J].Gas Turbine Experiment and Research,2002,15(4):39⁃44.(in Chinese)
|
| [6] |
田小江,张灵,夏全忠,等.小型航空涡喷发动机吞水试验装置研制[J].燃气涡轮试验与研究,2015,28(2):49⁃52.
TIAN Xiaojiang,ZHANG Ling,XIA Quanzhong,et al.Development of equipment for water ingestion test of certain mini⁃typeaero⁃engine[J].Gas Turbine Experiment and Research,2015,28(2):49⁃52.(in Chinese)
|
| [7] |
邢洋,王常亮,李兆红,等.航空涡扇发动机吞水性能变化[J].航空动力学报,2019,34(8):1717⁃1723.
XING Yang,WANG Changliang,LI Zhaohong,et al.Performance change of aero turbofan engine after swallowing water[J].Journal of Aerospace Power,2019,34(8):1717⁃1723.(in Chinese)
|
| [8] |
白鹏博,邢玉明,吴峰,等.发动机吞水试验云雾特性数值模拟[J].航空计算技术,2015,45(2):53⁃56.
BAI Pengbo,XING Yuming,WU Feng,et al.Numerical simulation of cloud parameter for test of engine water ingestion[J].Aeronautical Computing Technique,2015,45(2):53⁃56.(in Chinese)
|
| [9] |
米晓童,邢玉明.航空发动机吞水试验台喷雾系统数值模拟[J].燃气涡轮试验与研究,2016,29(3):49⁃54.
MI Xiaotong,XING Yuming.Numerical simulation of spray system in aero⁃engine[J].Gas Turbine Experiment and Research,2016,29(3):49⁃54.(in Chinese)
|
| [10] |
王春晓,邓潇.民用大涵道比涡扇发动机吸雨能力评估的方法研究[J].民用飞机设计与研究,2013(增刊2):1⁃3.
WANG Chunxiao,DENG Xiao.A method for estimating rain ingestion effect on high bypass ratio turbofan engine performance[J].Civil Aircraft Design and Research2013(Suppl 2):1⁃3.(in Chinese)
|
| [11] |
张宏伟,刘乐,李继超,等.轴流压气机雨雾环境模拟实验台搭建及实验研究[J].工程热物理学报,2012,33(8):1305⁃1308.
ZHANG Hongwei,LIU Le,LI Jichao,et al.Axial compressor rain fog environment simulation experiment tables set up and experimental research[J].Journal of Engineering Thermophysics,2012,33(8):1305⁃1308.(in Chinese)
|
| [12] |
杨璐,郑群,张海,等.轴流压气机吞水后的性能变化研究[J].推进技术,2017,38(7):1499⁃1506.
YANG Lu,ZHENG Qun,ZHANG Hai,et al.Performance changes of axial flow compressor after water ingestion[J].Journal of Propulsion Technology,2017,38(7):1499⁃1506.(in Chinese)
|
| [13] |
JASON K,ALAN H,MILT D.A numerical investigation of the effects of steam ingestion on compression system performance[R].ASME Paper GT2004⁃54190,2004.
|
| [14] |
DAY I,JOHN W,CHRISTOPHER F.Rain ingestion in axial flow compressors at part speed[R].ASME Paper GT2005⁃68582,2005.
|
| [15] |
袁怡祥,林宇震,刘高恩.旋流杯燃烧室头部流场与喷雾对贫油熄火的影响[J].航空动力学报,2004,19(3):332⁃337.
YUAN Yixiang,LIN Yuzhen,LIU Gaoen.The effect of flow field and fuel spray of combustor with swirl cup on lean blowout limit at idle condition[J].Journal of Aerospace Power,2004,19(3):332⁃337.(in Chinese)
|
| [16] |
袁怡祥,林宇震,刘高恩,等.燃油周向分级对贫油熄火油气比的影响[J].航空动力学报,2003,18(5):639⁃644.
YUAN Yixiang,LIN Yuzhen,LIU Gaoen,et al.The effect of fuel⁃circumferential⁃staging on lean blowout limit at idle condition[J].Journal of Aerospace Power,2003,18(5):639⁃644.(in Chinese)
|
| [17] |
代威,林宇震,许全宏,等.径向旋流器气量分配对点熄火特性的影响[J].航空动力学报,2016,31(3):608⁃615.
DAI Wei,LIN Yuzhen,XU Quanhong,et al.influence of air split of a radial swirler on ignition and extinction characteristics[J].Journal of Aerospace Power,2016,31(3):608⁃615.(in Chinese)
|
| [18] |
丁国玉,安伯堃,何小民,等.三级轴向旋流器燃烧室的贫油熄火性能试验[J].航空动力学报,2015,30(2):356⁃361.
DING Guoyu,AN Bokun,HE Xiaomin,et al.Experiment on lean blowout performance of triple axial swirler combustor[J].Journal of Aerospace Power,2015,30(2):356⁃361.(in Chinese)
|
| [19] |
张智搏,郑洪涛,凌瑞.使用特征参数准则预测航空发动机燃烧室贫油熄火极限[J].航空动力学报,2014,29(7):1631⁃1638.
ZHANG Zhibo,ZHENG Hongtao,LING Rui.Feature⁃parameter⁃criterion for predicting lean blowout limit of aero⁃engine combustor[J].Journal of Aerospace Power,2014,29(7):1631⁃1638.(in Chinese)
|
| [20] |
明贵清,杨灵,朱涛,等.航空燃气涡轮发动机燃烧室性能试验方法:HB7485⁃2012[S].北京:中国航空综合技术研究所,2013:14⁃15.
|