菱形孔射流在超声速流场中的气动特性

张丁午; 王强; 胡海洋

菱形孔射流在超声速流场中的气动特性

北京航空航天大学能源与动力工程学院,北京 100191

计量
- 文章访问数: 1809
- HTML浏览量: 93
- PDF量: 511
- 被引次数: 0
出版历程
- 收稿日期: 2012-05-18
- 刊出日期: 2012-10-28

Aerodynamic characteristics of sonic injection through diamond-shaped orifices in supersonic flow field

School of Jet Propulsion, Beijing University of Aeronautics and Astronautics,Beijing 100191,China

摘要

摘要: 针对带有横向射流的三维超声速流场进行数值模拟,分析了菱形结构喷孔与普通圆孔的差异,并探讨了不同喷射角度下菱形喷孔对流场的影响.研究结果表明:与普通圆孔相比,采用菱形孔射流能够减弱弓形激波的强度、降低总压损失,增加燃料的穿透高度,但是在展向方面两者对于燃料的扩散能力基本相同;随着喷射角度的增加,燃料的穿透高度表现出先增加后降低的趋势,在计算的3种模型中,喷射角为60°表现出更好的特性;喷射角度在一定范围内变化时,总压损失的改变不明显,但是过大的喷射角度会导致总压损失迅速增加.通过研究进一步认识了菱形孔射流的流场特性,为优化喷射装置提供依据.
- 菱形孔 /
- 横向射流 /
- 超声速 /
- 气动特性 /
- 喷射角度
Abstract: Three-dimensional supersonic flow field with sonic injector was numerically investigated,the characteristics of diamond-shaped orifice which were compared with that of the circular injector were analyzed,and at last the effect of the diamond-shaped orifice on the flow field with different injection angles was explored.It is found that the plume from diamond-shaped orifice can weaken the strength of the bow shock and reduce total pressure loss,and the fuel penetration height of diamond-shaped orifice is higher than that of the circular injector,however,the diffusivity is almost the same in spanwise direction regardless of the structure type of injector.With the increase of the injection angle,the penetration height of the fuel firstly increases and then decreases;the model with 60 degree injection angle has the best characteristics.The change of total pressure loss is not obvious when the injection angle changes within a certain range,whereas an injection angle which is too large would lead to a rapid increase in the total pressure loss.This investigation provides insight into the characteristics of flow field with diamond-shaped orifice,which is crucial for optimization of injector.
- diamond-shaped orifice /
- transverse jet /
- supersonic /
- aerodynamic characteristics /
- injection angle

HTML

参考文献(15)

[1]	Gruber M R,Donbar J M,Carter C D,et al.Mixing and combustion studies using cavity-based flame holders in supersonic flow[J].Journal of Propulsion and Power,2004,20(5):769-778.
[2]	Mitain T,Chinzei N,Kanda T.Reaction and mixing controlled combustion in scramjet engines[J].Journal of Propulsion and Power,2001,17(2):308-314.
[3]	Schetz J A,Thomas R H,Billig F S.Mixing of transverse jets and wall jets in supersonic flow .Separated Flows and Jets,SFJ Paper 807-837,1991.
[4]	Hollo S D,McDaniel J C.Quantitative investigation of compressible mixing:staged traverse injection into Mach 2 flow .AIAA-1994-0528,1994.
[5]	Fuller R P,Wu P K,Nejad A S,et al.Comparison of physical and aerodynamic ramps as fuel injectors in supersonic flow[J].Journal of Propulsion and Power,1998,14(2):135-145.
[6]	Jacobsen L S,Schetz J A,Ng W F,et al.Near a multiport injector array in a supersonic flow[J].Journal of Propulsion and Power,2000,16(2):216-226.
[7]	Gruber M R,Nejad A S,Chen T H,et al.Mixing and penetration studies of sonic jets in a Mach 2 free stream[J].Journal of Propulsion and Power,1995,11(2):315-323.
[8]	McClinton C R.The effects of injection angle on the interaction between sonic secondary jets and a supersonic free stream .NASA TN D-6669,1972.
[9]	Mays R B,Thomas R H,Schetz J A.Low angle injection into supersonic flow .AIAA-1989-2461,1989.
[10]	Fuller E J,Mays R B,Thomas R H,et al.Mixing studies of helium in air at high supersonic speeds .AIAA-1992-2234,1992.
[11]	Guerra R,Waidmann W,Laible C.An experimental investigation of the combustion of a hydrogen jet injected parallel in a supersonic air stream .AIAA-1991-5102,1991.
[12]	Bowersox R,Fan H,Lee D. Sonic injection into a Mach 5.0 freestream through diamond orifices[J].Journal of Propulsion and Power,2004,20(2):280-287.
[13]	Tomioka S,Jacobsen L,Schezt J.Sonic injection from diamond-shaped orifices into supersonic crossflow[J].Journal of Propulsion and Power,2003,19(1);104-114.
[14]	Barber M J,Schetz J A,Roe L A.Normal,sonic helium injection through a wedge-shaped orifice into supersonic flow[J].Journal of Propulsion and Power,1997,13(2):257-263.
[15]	Tomioka S,Kohchi T,Masumoto,et al.Supersonic combustion with supersonic injection through diamond-shaped orifices[J].Journal of Propulsion and Power,2011,27(6):1196-1203.