级环境下附面层抽吸对对转压气机性能的影响

刘波; 曹志远; 魏巍; 史磊

级环境下附面层抽吸对对转压气机性能的影响

西北工业大学动力与能源学院, 西安 710072

基金项目: 国家自然科学基金(50976093)

计量
- 文章访问数: 1616
- HTML浏览量: 156
- PDF量: 959
- 被引次数: 0
出版历程
- 收稿日期: 2012-05-08
- 刊出日期: 2013-04-28

Effects of boundary layer suction on counter-rotating compressor in multistage environment

School of Power and Energy, Northwestern Polytechnical University, Xi'an 710072, China

摘要

摘要: 为研究级环境下附面层抽吸(BLS)对对转压气机性能影响的机理,针对某双排轴流对转压气机转子进行附面层抽吸的探索.在前排转子R1(Rotor 1)、后排转子R2(Rotor 2)吸力面沿弦向不同位置分别开设3个不同抽吸槽,研究了不同吸气位置与吸气量下R1单独吸气、R2单独吸气对对转压气机流场结构及性能的影响.结果表明:R1单独吸气时,随吸气量增加,R1效率提高,R2效率降低,对转压气机整机效率先增大后减小,最佳吸气位置靠近R1尾缘;R2单独吸气时,随吸气量增加,R1效率基本不变,R2效率先增大后减小,对转压气机整机效率先增大后减小,最佳吸气位置靠近R2尾缘;附面层抽吸后落后角明显减小,叶排间的气流参数匹配是级环境下附面层抽吸需要考虑的重要因素.
- 吸附式压气机 /
- 附面层抽吸 /
- 压气机 /
- 对转 /
- 二次流
Abstract: In order to study the effects of boundary layer suction (BLS) on counter-rotating compressors in multistage environment, numerical investigations were performed on the rotors of a dual stage counter-rotating compressor with BLS method. Three different suction slots in chord direction were set up on the front rotor (R1) and rear rotor (R2) suction surface to study the effects of flow structure and performance on different suction ways, and independent suctions were carried out on R1 and R2 respectively at different suction locations and suction air rate in counter-rotating compressor. By BLS of individual R1, the efficiency increases with the rise of suction air rate. But the aerodynamic performance matching R1 with R2 becomes worse and makes R2 fall directly. The overall efficiency is also represented by the fluctuation from going up to down. The best suction location of R1 is near the trailing edge. By BLS of R2 individually, the efficiency of R2 keeps the trend from increase to reduction with the rise of suction rate, while the efficiency and flow field of R1 remain unchanged nearly. The best suction location of R2 is near the trailing edge. The deviation angles reduce obviously after the BLS. The above results demonstrate that matching of aerodynamic parameters between blades rows is a main factor to be considered after BLS in multistage environment.
- aspirated compressor /
- boundary layer suction /
- compressor /
- counter-rotating /
- secondary flow

HTML

参考文献(15)

[1]	Kerrebrock J L,Reijnen D P,Ziminsky W S,et al.Aspirated Compressors [R].ASME Paper 97-GT-525,1997.
[2]	WANG Songtao,QIANG Xiaoqing,LIN Weichun,et al.Highly-loaded low-reaction boundary layer suction axial flow compressor [R].ASME Paper GT-2007-28191,2007.
[3]	Francesca Satta,Marina Ubaldi,Pietro Zunino,et al.Wake control by boundary layer suction applied to a high-lift low-pressure turbine blade [R].ASME Paper GT-2010-23475,2010.
[4]	刘波,南向谊,王掩刚,等.吸附式风扇/压气机技术的进展与展望[J].航空动力学报,2007,22(6):945-954. LIU Bo,NAN Xiangyi,WANG Yangang,et al.Development and prospect of aspirated fan/compressor[J].Journal of Aerospace Power,2007,22(6):945-954.(in Chinese)
[5]	Merchant A.Aerodynamic design and performance of aspirated airfoils[J].ASME Journal of Turbomachinery,2003,125(1):141-148.
[6]	Kerrebrock J L,Epstein A H,Merchant A A,et al. Design and test of an aspirated counter-rotating fan[J].ASME Journal of Turbomachinery,2008,130(2):021004.1-021004.8.
[7]	刘波,南向谊,陈云永.附面层抽吸对转子激波结构和分离流动的影响[J].航空学报,2008,29(2):315-320. LIU Bo,NAN Xiangyi,CHEN Yunyong.Effects of BLS on the shockwave structure and separation flow of fan rotor[J].Acta Aeronautica et Astronautica Sinica,2008,29(2):315-320.(in Chinese)
[8]	南向谊,刘波,靳军,等.超声速压气机转子叶片吸力面抽气抑制附面层分离的机理[J].航空动力学报,2007,22(7):1093-1099. NAN Xiangyi,LIU Bo,JIN Jun,et al.Study of suppression boundary layer separation on the suction surface of supersonic compressor rotor[J].Journal of Aerospace Power,2007,22(7):1093-1099.(in Chinese)
[9]	SONG Yanping,CHEN Fu,YANG Jun,et al. A numerical investigation of boundary layer suction in compound lean compressor cascades [R].ASME Paper GT-2005-68441,2005.
[10]	王掩刚,牛楠,赵龙波,等.端壁抽吸位置对压气机叶栅角区分离控制的影响[J].推进技术,2010,31(4):433-437. WANG Yangang,NIU Nan,ZHAO Longbo,et al.Effect on corner separation control for high load compressor cascade with different end-wall BLS position[J].Journal of Propulsion Technology,2010,31(4):433-437.(in Chinese)
[11]	王掩刚,国睿,任思源,等.跨声速叶栅叶表附面层抽吸效应试验[J].航空动力学报,2011,26(9):2068-2074. WANG Yangang,GUO Rui,REN Siyuan,et al.Experimental investigation of boundary layer suction effects on a transonic cascade[J].Journal of Aerospace Power,2011,26(9):2068-2074.(in Chinese)
[12]	王掩刚,牛楠,任思源,等.跨音速压气机转子叶表和端壁抽吸对比研究[J].工程热物理学报,2011,32(11):1843-1846. WANG Yangang,NIU Nan,REN Siyuan,et al.Comparison of BLS on blade surface & end-wall for a transonic compressor rotor[J].Journal of Engineering Thermophysics,2011,32(11):1843-1846.(in Chinese)
[13]	郭爽,陈绍文,陆华伟,等.组合抽吸对大转角扩压叶栅性能的影响[J].航空动力学报,2010,25(12):2697-2703. GUO Shuang,CHEN Shaowen,LU Huawei,et al.Effect of compound boundary layer suction on the performance of a high-load diffusion compressor cascade with a large camber angle[J].Journal of Aerospace Power,2010,25(12):2697-2703.(in Chinese)
[14]	兰发祥.吸附式压气机设计技术研究 [D].南京:南京航空航天大学,2008. LAN Faxiang.Research on design technology of the aspirated compressor [D].Nanjing:Nanjing University of Aeronautics and Astronautics,2008.(in Chinese)
[15]	葛正威.跨声速吸气式轴流压气机设计及数值模拟研究 [D].北京:中国科学院,2007. GE Zhengwei.Design and numerical investigations of axial aspirated transonic compressor stage [D].Beijing:Chinese Academy of Sciences,2007.(in Chinese)