Experiments of effects of inlet-air distortion on aerodynamic performance in transonic compressor
Experiments of effects of inlet-air distortion on aerodynamic performance in transonic compressor
-
摘要: The inlet-air distortion which was caused by high angle-of-attack flight was simulated by plugboard.Experiments were conducted on a transonic axial-flow compressor's rotor at 98% rotating speed.The flow-field characteristics and mechanism of performance degradation were analyzed in detail.The compressor inlet was divided into four sectors at circumference under inlet-air distortion.They were undistorted sector,transition sector A where the rotor was rotating into the distortion sector,distorted sector and transition sector B where the rotor was rotating out of the distortion sector.The experimental results show that compared with undistorted sector,there is a subsonic flow in transition sector A,so the pressure ratio is decreased by a large margin in this sector.However, the shock wave is enhanced in distortion sector and transition sector B, and thus the pressure ratio increases in these sectors.Because of the different works at circumference,the phase angle of total pressure changes 90° when the inlet total pressure distortion passes through compressor rotor.In addition,the frequency and amplitude of disturbances in front of the rotor strengthenes under inlet distortion,so the unstable flow would take place in advance.In addition, the position of stall inception is in one of the transition sectors.Abstract: The inlet-air distortion which was caused by high angle-of-attack flight was simulated by plugboard.Experiments were conducted on a transonic axial-flow compressor's rotor at 98% rotating speed.The flow-field characteristics and mechanism of performance degradation were analyzed in detail.The compressor inlet was divided into four sectors at circumference under inlet-air distortion.They were undistorted sector,transition sector A where the rotor was rotating into the distortion sector,distorted sector and transition sector B where the rotor was rotating out of the distortion sector.The experimental results show that compared with undistorted sector,there is a subsonic flow in transition sector A,so the pressure ratio is decreased by a large margin in this sector.However, the shock wave is enhanced in distortion sector and transition sector B, and thus the pressure ratio increases in these sectors.Because of the different works at circumference,the phase angle of total pressure changes 90? when the inlet total pressure distortion passes through compressor rotor.In addition,the frequency and amplitude of disturbances in front of the rotor strengthenes under inlet distortion,so the unstable flow would take place in advance.In addition, the position of stall inception is in one of the transition sectors.
-
Key words:
- plugboard simulator /
- inlet-air distortion /
- transonic axial-flow compressor /
- shock wave /
- disturbance
-
[1] Harry D P,Lubick R J.Inlet-air distortion effects on stall,surge and acceleration margin of a turbojet engine equipped with variable compressor inlet guide vanes[R].NACA RM E54K26,1955. [2] Malker C,Sivo J N,Jansen E T.Effects of unequal air-flow distribution from twin inlet ducts on performance of an axial-flow turbojet engine[R].NACA RM E54E13,1954. [3] Hermanson K,Thole K.Effect of non-uniform inlet conditions on endwall secondary flow[J].Journal of Turbomachinery,2002,124(10):623-631. [4] Hirai K,Kodama H,Nozaki O,et al.Unsteady three-dimensional analysis of inlet distortion in turbomachinery[R].AIAA 1997-2735,1997. [5] Hah C,Rabe D,Sullivan T,et al.Effects of inlet distortion on the flow field in a transonic compressor rotor[J].Journal of Turbomachinery,1998,120(2):233-246. [6] Doyle M,Dixon S,Horlock J.Circumferential asymmetry in axia flow compressors[J].Journal of the Royal Aeronautical Soeiety,1966,70(10):956-963. [7] Greitzer E.Surge and rotating stall in axial flow compressors:Part Ⅰ theoretical compression system model[J].Journal of Engineering for Power,1976,98(2):201-213. [8] Stenning A.Inlet distortion effects in axial compressors[J].Fluids Engineering,1980,102(1):7-13. [9] Chue R,Hynes T,Greitzer E,et al.Calculation of inlet distortion induced compressor flow field instability[J].Journal of Heat and Fluid Flow,1989,10(3):211-223. [10] YAO Jixian,Steven E,Aspi R.High-fidelity numerical analysis of per-rev-type inlet distortion trasfer in mutistage fans:Part Ⅰ simulations with selected blade rows[R].ASME Paper GT-2008-50812,2008. [11] YAO Jixian,Steven E,Aspi R.High-fidelity numerical analysis of per-rev-type inlet distortion trasfer in mutistage fans:Part Ⅱ entire component simulation and investigation[R].ASME Paper GT-2008-50813,2008. [12] LI Maoyi,LU Yajun,GONG Zhiqiang.PIV investigation of the internal flow in an axial flow compressor rotor under inlet distortion[J].Journal of Aerospace Power,2006,21(3):461-466.(in Chinese) [13] LI Maoyi,YUAN Wei,SONG Xizhen,et al.An experimental investigation about the effect of the partial treatment on a transonic axial-flow compressor performance under inlet distortion[R].ASME Paper GT-2012-68442,2012. [14] JIANG Huabing.Experimental investigation on the unsteady cooperative flow control for the compressor with inlet distortion[D].Beijing:Beijing University of Aeronautics and Astronautics,2008.(in Chinese) [15] JIANG Huabing,LU Yajun,YUAN Wei,et al.Experimental investigation of the influence of inlet distortion on the stall inception in a low speed axial compressor[R].ASME Paper GT-2009-59139,2009. -
点击查看大图
计量
- 文章访问数: 1454
- HTML浏览量: 104
- PDF量: 1001
- 被引次数: 0
下载: