基于真空羽流试验的洁净真空系统设计

凌桂龙; 蔡国飙; 张建华

基于真空羽流试验的洁净真空系统设计

北京航空航天大学宇航学院, 北京 100191

计量
- 文章访问数: 1521
- HTML浏览量: 106
- PDF量: 880
- 被引次数: 0
出版历程
- 收稿日期: 2012-05-29
- 刊出日期: 2013-05-28

Oil-free vacuum system design based on vacuum plume experiment

School of Astronautics, Beijing University of Aeronautics and Astronautics, Beijing 100191, China

摘要

摘要: 研制的洁净真空系统可用于真空羽流试验及热真空试验研究.详细介绍了真空系统的组成、方案设计及工作模式;计算了不同工作模式下的真空抽气时间;分别对罗茨泵机组、分子泵及低温泵进行了容器极限抽速测试,测试结果表明,满足技术指标;最后对真空容器压力维持能力进行了测试,测得容器平均压升率为0.111Pa/h,对应的平均漏气率为7.24Pa·L/s,真空容器达到了较高的工艺水平.真空系统有多种工作模式供选择,可根据试验需求及故障模式选取,增加了“真空羽流效应实验系统”运行的实用性和经济性.
- 真空系统 /
- 羽流试验 /
- 粗真空系统 /
- 高真空系统 /
- 超高真空系统 /
- 压升率 /
- 漏气率
Abstract: An oil-free vacuum system for vacuum plume and thermal vacuum experiments was established.The composition of vacuum system,scheme design and working modes were described in detail.The vacuum pumping time under different working modes was calculated.The vessel ultimate pumping speed tests were conducted on the roots pump,molecular pump and cryopump,respectively.The test results show that the technical indexes of the instruments are attained.Finally,the pressure maintenance ability of the vacuum vessel was measured.The average pressure rise rate of the vessel is 0.111Pa/h,corresponding to an average leakage rate of 7.24Pa·L/s,which demonstrates that the vacuum vessel has achieved a high process level.According to the experimental requirements and the selection of failure mode,the vacuum system has several working modes to choose,which increases the practicality and economy of the vacuum plume investigation experiment system.
- vacuum system /
- plume experiment /
- low vacuum system /
- high vacuum system /
- ultra-high vacuum system /
- pressure rise rate /
- leakage rate

HTML

参考文献(16)

[1]	凌桂龙,王文龙,蔡国飙,等.用于发动机羽流试验研究的液氦热沉设计[J].航空动力学报,2011,26(11):2630-2635. LING Guilong,WANG Wenlong,CAI Guobiao,et al.Liquid helium heat sink design for the engine vacuum plume effects experimental study[J].Journal of Aerospace Power,2011,26(11):2630-2635.(in Chinese)
[2]	王文龙,周建平,蔡国飙.羽流效应地面模拟试验系统关键技术发展[J].航空动力学报,2012,27(4):900-906. WANG Wenlong,ZHOU Jianping,CAI Guobiao.Development of vacuum plume effects ground simulation experimental system key techonlogy[J].Journal of Aerospace Power,2012,27(4):900-906.(in Chinese)
[3]	达道安.真空设计手册[M].北京:国防工业出版社,2004.
[4]	黄本诚,童靖宇.空间环境工程学[M].北京:中国科学技术出版社,2010.
[5]	黄本诚,陈金明.空间真空环境与真空技术[M].北京:国防工业出版社,2005.
[6]	黄本诚.空间模拟器设计[M].北京:宇航出版社,1994.
[7]	黄本诚,马有礼.航天器空间环境试验技术[M].北京:国防工业出版社,2002.
[8]	成致祥.KM4空间模拟器的清洁真空改造[J].中国空间科学技术,1993(2):45-52. CHENG Zhixiang.Oil-free transforming of KM4 space environmental simulator[J].Chinese Space Science and Technology,1993(2):45-52.(in Chinese)
[9]	黄本诚,刘国青,成致祥,等.特大型空间环境试验设备的超高真空获得技术[J].真空科学与技术,2001,21(1):1-4. HUANG Bencheng,LIU Guoqing,CHENG Zhixiang,et al.Vacuum technology of extra large and ultra-high vacuum space environment simulator[J].Vacuum Science and Technology,2001,21(1):1-4.(in Chinese)
[10]	茹晓勤,祁妍,吴树迎.用制冷机低温泵获得清洁无油高真空[J].航天器环境工程,2006,23(2):119-121. RU Xiaoqin,QI Yan,WU Shuying.Production of dry-clean high-vacuum with refrigerator's cryopumps[J].Spacecraft Environment Engineering,2006,23(2):119-121.(in Chinese)
[11]	郭欣,邵容平,阎荣鑫.环境模拟器低温泵测试系统设计[J].真空,2011,48(2):79-82. GUO Xin,SHAO Rongping,YAN Rongxin.Design of performance testing system of cryopumps for environment simulator[J].Vacuum,2011,48(2):79-82.(in Chinese)
[12]	张璠.真空容器的漏气率与升压率[J].真空,1993(2):1-5. ZHANG Pan.Leak throughput and rate of pressure rise of vacuum chamber[J].Vacuum,1993(2):1-5.(in Chinese)
[13]	李殿东.高真空阀门漏率和升压率的区别[J].真空,2003(4):37-39. LI Diandong.Difference between leak rate and rate of pressure rise of high vacuum valve[J].Vacuum,2003(4):37-39.(in Chinese)
[14]	陈涛,李玉忠,许忠旭,等.真空热试验中材料放气的放气量及其导热问题[J].航天器环境工程,2006,23(2):103-106. CHEN Tao,LI Yuzhong,XU Zhongxu,et al.Material outgassing amount and thermal conduction in vacuum thermal test[J].Spacecraft Environment Engineering,2006,23(2):103-106.(in Chinese)
[15]	田玉林,黄文学,王玥,等.RFQ1L系统压升率的理论与实验研究[J].原子核物理评论,2008,25(1):44-47. TIAN Yulin,HUANG Wenxue,WANG Yue,et al.Theoretical and experimental study on the pressure rise rate of RFQ1L system[J].Nuclear Physics Review,2008,25(1):44-47.(in Chinese)
[16]	中国国家标准化管理委员会.GB/T 22561-2008真空热处理[S].北京:中国标准出版社,2008. Standardization Administration of the People's Republic of China.GB/T 22561-2008 vacuum heat treatment[S].Beijing:Standards Press of China,2008.