气口布置对进气涡流及扫气品质的影响

曹娇坤; 丁水汀; 杜发荣; 王振宇

气口布置对进气涡流及扫气品质的影响

北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室, 北京 100191

计量
- 文章访问数: 1661
- HTML浏览量: 19
- PDF量: 1207
- 被引次数: 0
出版历程
- 收稿日期: 2012-07-20
- 刊出日期: 2013-08-28

Effects of porting arrangements on intake swirl and scavenging performance

National Key Laboratory of Science and Technology on Aero-Engine Aero-thermodynamics, School of Energy and Power Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100191, China

摘要

摘要: 采用数值方法研究了气口布置对进气涡流及换气品质的影响,建立了缸内过程的三维瞬态数值模型,通过改变气口平射角引入进气涡流,根据归一化缸内二氧化碳质量分数评价扫气品质,对比了不同气口布置角度下的涡流比及扫气品质.结果表明:①改变气口平射角能够产生包括涡流在内的旋转流动,涡流持续到上止点附近,并近似为刚体涡;②进气涡流造成扫气过程中期短路损失,并使CO₂聚集于旋转区域中心;③扫气口仰角变大或排气口沿旋转流动方向远离扫气口,能够抑制短路;扫气口平射角减小时,上止点附近的涡流比降低,短路损失增大.
- 气口布置 /
- 二冲程重油航空活塞发动机 /
- 进气涡流 /
- 扫气品质 /
- 数值方法
Abstract: Effects of porting arrangements on intake swirl and scavenging performance were investigated numerically.A three-dimensional transient numerical model was established for the in-cylinder processes.Intake swirl was introduced by changing port tangential inclinations and scavenging performance was evaluated by normalized carbon dioxide mass fraction.The intake swirl intensity and scavenging performance with different porting arrangements were compared.The results show: (1) Rotation flow including swirl can be generated by port tangential inclination arrangements,and the swirl approximates to solid-body swirl approaching the top dead center.(2) Intake swirl results in short-circuiting during the scavenge processes and a concentrated carbon dioxide central core.(3) The short-circuiting can be reduced by increasing the axial inclination of inlet ports or extending the distance between inlet and exhaust ports in the flow direction.Swirl intensity can be decreased by reducing scavenge port tangential inclinations,leading to increase of short-circuiting.
- porting arrangements /
- two-stroke diesel aero-engine /
- intake swirl /
- scavenging performance /
- numerical simulation

HTML

参考文献(20)

[1]	Burkardt L A.General aviation light aircraft propulsion:from the 1940's to the next century [R].AIAA-1998-3116,1998.
[2]	Korres D M,Karonis D,Lois E,et al.Aviation fuel JP-5 and biodiesel on a diesel engine[J].Fuel,2008,87(1):70-78.
[3]	Cambone S A,Krieg K J,Pace P,et al.Unmanned aircraft systems (UAS) roadmap 2005-2030.Washington,US:Secretary of Defense,2005.
[4]	Rozenkranc M,Ernst J.Tactical UAV engines integration in IAI [R].AIAA 2003-6534,2003.
[5]	Eran S.Scavenging the two-stroke engine[J].Progress in Energy and Combustion Science,1990,16(2):95-124.
[6]	Heywood J B.Internal combustion engine fundamentals[M].New York:McGraw-Hill,1988.
[7]	Payri F,Benajes J,Margot X,et al.CFD modeling of the in-cylinder flow in direct-injection Diesel engines[J].Computers & Fluids,2004,33(8):995-1021.
[8]	Heywood J B,Sher E.The two-stroke cycle engine:its development,operation,and design[M].Philadelphia,US:Taylor & Francis,1999.
[9]	Sweeney M,Swann G,Kenny R,et al.Computational fluid dynamics applied to two-stroke engine scavenging [R].SAE Technical Paper 851519,1985.
[10]	Ahmadi-Befrui B,Brandstatter W,Kratochwill H.Multidimensional calculation of the flow processes in a loop-scavenged two-stroke cycle engine [R].SAE Technical Paper 890841,1989.
[11]	Creaven J P,Kenny R G,Fleck R,et al.A computational and experimental study of the scavenging flow in the transfer duct of a motored two-stroke cycle engine[J].Journal of Automobile Engineering,2001,215(9):1017-1031.
[12]	Creaven J P,Fleck R,Kenny R G,et al.Laser Doppler velocimetry measurements of flow within the cylinder of a motored two-stroke cycle engine-comparison with some computational fluid dynamics predictions[J].International Journal of Engine Research,2003,4(2):103-128.
[13]	Goldsborough S,Van Blarigan P.Optimizing the scavenging system for a two-stroke cycle,free piston engine for high efficiency and low emissions:a computational approach [R].SAE Technical Paper 2003-01-0001,2003.
[14]	Mao J,Zuo Z,Li W,et al.Multi-dimensional scavenging analysis of a free-piston linear alternator based on numerical simulation[J].Applied Energy,2011,88(4):1140-1152.
[15]	Shimada M.A study of stratified scavenging type in two cycle gasoline engine[J].JSAE Review,1998,19(3):277-279.
[16]	Payri F,Galindo J,Climent H,et al.Optimisation of the scavenging and injection processes of an air-assisted direct fuel injection 50cc 2-stroke S.I.engine by means of modelling.SAE Technical Paper 2001-01-1814,2001.
[17]	Rakopoulos C D,Kosmadakis G M,Dimaratos A M,et al.Investigating the effect of crevice flow on internal combustion engines using a new simple crevice model implemented in a CFD code[J].Applied Energy,2011,88(1):111-126.
[18]	Mohamed Ismail H,Ng H K,Gan S.Evaluation of non-premixed combustion and fuel spray models for in-cylinder Diesel engine simulation[J].Applied Energy,2012,90(1):271-279.
[19]	Versteeg H K,Malalasekera W.An introduction to computational fluid dynamics:the finite volume method[M].New York:Pearson Education Ltd.,2007.
[20]	Freen P D,Berenyi S G,Brouwers A P,et al.Lightweight two-stroke cycle aircraft Diesel engine technology enablement program.NASA-CR-174923-VOL-3,1985.