航空发动机电子控制系统的小型化SIP技术

刘葆华; 黄金泉

航空发动机电子控制系统的小型化SIP技术

刘葆华^1,2,
黄金泉¹

1.
南京航空航天大学能源与动力学院, 南京210016
2.
中国航空工业集团公司航空动力控制系统研究所, 江苏无锡214000

计量
- 文章访问数: 1735
- HTML浏览量: 74
- PDF量: 978
- 被引次数: 0
出版历程
- 收稿日期: 2012-09-20
- 刊出日期: 2013-09-28

System-in-package technology for miniaturization design of aero-engine electronic control system

LIU Bao-hua^1,2,
HUANG Jin-quan¹

1.
College of Energy and Power Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 210016, China
2.
Aviation Motor Control System Institute, Aviation Industry Corporation of China, Wuxi Jiangsu 214000, China

摘要

摘要: 针对电子装备小型化的需求,开展了对航空发动机电子控制系统的系统级封装(SIP)技术研究.以一个航空发动机电子控制系统设计为例,采用芯片堆叠结构,将多个裸芯片管脚用键合线引至电路衬底上的连接点,辅以印制板电路,构成完整的电路系统.通过设计优化和信号完整性仿真分析来控制信号质量,试验验证了在保证电路板信号质量的情况下,采用SIP技术,面积缩小约80%,质量减少约70%.研究显示系统级封装技术是未来航空电子控制系统小型化、高可靠的发展方向之一.
- 航空发动机电子控制系统 /
- 小型化 /
- 系统级封装 /
- 多芯片模块 /
- 信号完整性仿真 /
- 时序
Abstract: An advanced technology of system-in-package(SIP) was presented for miniaturization of the aero-engine control system's electronic equipments.The circuit design of an aero-engine electronic control system was taken as an example.In the chip, an integrated approach was adopted based on a pile of integrated chips,and internal die pins were led to the connection points on the circuit underlay;then the surrounding was supplemented by printed circuit board;finally a complete electrical system was constituted.Design optimization and signal integrity simulation were implemented for quality control of signals.The test results show that,by use of SIP technology,the circuit board is reduced about 80% in area and 70% in mass as well as the signal quality is satisfied.The research illustrates that the SIP technology becomes one of the development directions of miniaturization and high reliability design of aero-engine electronic control system in the future.
- aero-engine electronic control system /
- miniaturization /
- system-in-package(SIP) /
- multichip module(MCM) /
- signal integrity simulation /
- timing

HTML

参考文献(15)

[1]	郭虹.航空发动机控制系统的发展趋势[J].沈阳航空工业学院学报,1997,14(1):70-74. GUO Hong.The developing trend of the jet engine control system[J].Journal of Shenyang Institute of Aeronautical Engineering,1997,14(1):70-74.(in Chinese)
[2]	王曦,程茵.国外航空推进控制技术的发展[J].航空发动机,2009,35(3):4-7. WANG Xi,CHENG Yin.Development of thrust control technology for foreign aero engine[J].Aeroengine,2009,35(3):4-7.(in Chinese)
[3]	张绍基.航空发动机控制系统的研发与展望[J].航空动力学报,2004,19(3):375-382. ZHANG Shaoji.A review of aero engine control system[J].Journal of Aerospace Power,2004,19(3):375-382.(in Chinese)
[4]	刘兴堂,邓建军,黄树彩.超音速军用航空发展综述[J].空军工程大学学报,2000,1(4):91-94. LIU Xingtang,DENG Jianjun,HUANG Shucai.A summary on development of supersonic military aviation[J].Journal of Air Force Engineering University,2000,1(4):91-94.(in Chinese)
[5]	毛小红,崔西会,高能武.高密度集成技术与电子装备小型化[J].电子信息对抗技术,2009,24(4):68-71. MAO Xiaohong,CUI Xihui,GAO Nengwu.High density integrated technologies and miniature in electronic equipment[J].Electronic Information Warfare Technology,2009,24(4):68-71.(in Chinese)
[6]	陈一杲,张江华,李宗怿,等.系统级封装技术及其应用[J].中国集成电路,2009(12):56-62. CHEN Yigao,ZHANG Jianghua,LI Zongyi,et al.System in package technology and the application[J].China Integrated Circuit,2009(12):56-62.(in Chinese)
[7]	窦新玉.系统集成封装技术[J].电子工业专用设备,2005,34(5):1-4. DOU Xinyu.System integration in package[J].Equipment for Electronic Products Manufacturing,2005,34(5):1-4.(in Chinese)
[8]	李振亚,赵钰.SIP封装技术现状与发展前景[J].电子封装,2009,9(2):5-10. LI Zhenya,ZHAO Yu.The status and future prospects of system-in-package technology[J].Electronics and Packaging,2009,9(2):5-10.(in Chinese)
[9]	蒋彭龙.未来航天控制系统中系统集成技术的发展[J].战术导弹控制技术,2010,27(3):1-6. JIANG Penglong.The technological development of system integrated in future aerospace control system[J].Control Technology of Tactical Missile,2010,27(3):1-6.(in Chinese)
[10]	King L T.System-in-package (SIP):challenge and opportunities //Proceedings of the 2000 Asia and South Pacific Design Automation Conference.New York:Association for Computing Machinery,2000:191-196.
[11]	曾理,陈文媛,谢诗文,等.集成电路封装高密度化与散热问题..http://www.eepw.com.cn/article/17530.htm.
[12]	覃婕,阎波,林水生.基于Cadence_Allegro的高速PCB设计信号完整性分析与仿真[J].现代电子技术,2011,34(10):169-171. QIN Jie,YAN Bo,LIN Shuisheng.Signal integrity analysis and simulation in high-speed PCB design based on Cadence_ Allegro[J].Modern Electronics Technique,2011,34(10):169-171.(in Chinese)
[13]	顾菘.高速电路中的信号完整性分析[J].电子设计工程,2011,19(16):134-136. GU Song.Analysis of signal integrity in High-speed circuit designing[J].Electronic Design Engineering,2011,19(16):134-136.(in Chinese)
[14]	李胜朝,张江鑫.高速电路中时序问题的分析与处理[J].浙江工业大学学报,2009,37(5):499-502. LI Shengchao,ZHANG Jiangxing.Timing problem analysis and processing in high-speed circuit[J].Journal of Zhejiang University of Technology,2009,37(5):499-502.(in Chinese)
[15]	杨洪军,刘永亮,石琳.基于信号完整性的高速数据采集传输系统设计[J].计算机测量与控制,2011,19(7):1781-1783. YANG Hongjun,LIU Yongliang,SHI Lin.Design of high speed data collection and transmission system based on signal integrity[J].Computer Measurement and Control,2011,19(7):1781-1783.(in Chinese)