凸肩径向位置对风扇叶片振动特性的影响

洪杰; 文敏; 马艳红; 张大义

doi:10.13224/j.cnki.jasp.2015.12.001

凸肩径向位置对风扇叶片振动特性的影响

doi: 10.13224/j.cnki.jasp.2015.12.001

北京航空航天大学能源与动力工程学院, 北京 100191

详细信息

作者简介:
洪杰(1965-),男,北京人,教授,博士,主要研究方向为叶片阻尼技术研究.

通讯作者:
马艳红(1976-),女,辽宁铁岭人,副教授,博士,主要研究方向为航空发动机强度振动.E-mail:mayanh2002@163.com

中图分类号: V231.92
计量
- 文章访问数: 1210
- HTML浏览量: 66
- PDF量: 653
- 被引次数: 0
出版历程
- 收稿日期: 2014-05-10
- 刊出日期: 2015-12-28

Influence of the shroud's radial position on vibration characteristics of the fan blade

School of Energy and Power Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100191, China

摘要

摘要: 针对带凸肩风扇叶片的动力学设计需求,研究凸肩径向位置对风扇叶片振动特性的影响规律.基于梁理论建立带凸肩风扇叶片的力学模型,采用瑞利法推导了1阶固有频率解析解,并获得了1阶固有频率随凸肩径向位置的变化规律.基于非线性接触有限元法,研究了凸肩径向位置对接触状态和振动特性的影响.研究结果表明:凸肩径向相对位置为0.75时,可使叶片具有最大的刚度值和1阶固有频率值.而综合考虑多阶模态频率时,凸肩径向相对位置为0.55至0.68时,叶片振动特性最优.凸肩接触正压力随凸肩径向位置增加而下降,切向接触刚度随凸肩径向位置的增加先增加后减小.
- 凸肩 /
- 叶片 /
- 瑞利法 /
- 刚度 /
- 振动特性
Abstract: The influence of the shroud's radial position on the vibration characteristics of the fan blade considering its dynamics design requirements was investigated. Mechanical model of the shrouded fan blade was built based on beam theory, and the first order natural frequency was obtained using Rayleigh method. Further the influence of the shroud's radial position on the first order natural frequency was also acquired. The influence of the shroud's radial position on the contact status and vibration characteristics was also investigated by the nonlinear finite element method with contact elements. The results reveal that the stiffness and the first order natural frequency are maximal while the relative shroud's radial position is 0.75. The vibration characteristics for multi-modes are best while the relative shroud's radial position is 0.55-0.68. The pressure of the contact surface of the shroud decreases for the increasing of the relative shroud's radial position, and the tangential contact stiffness first increases and then decreases for the increasing of the shroud's radial position.
- shroud /
- blade /
- Rayleigh method /
- stiffness /
- vibration characteristics

HTML

参考文献(18)

[1]	陈光.航空发动机结构设计分析[M].北京:北京航空航天大学出版社,2006.
[2]	陈光,洪杰,马艳红.航空燃气涡轮发动机结构[M].北京:北京航空航天大学出版社,2010.
[3]	任勇生,朱德懋.带凸肩叶片的稳态响应计算及其阻尼减振分析[J].振动工程学报,1994,7(2):103-111. REN Yongsheng,ZHU Demao.Steady state response of shrouded blades calculation and damping vibration analysis[J].Journal of Vibration Engineering,1994,7(2):103-111.(in Chinese)
[4]	李宏新,赵开宁,张连祥.航空发动机风扇叶片凸肩的结构设计[J].航空发动机,2004,30(4):14-17. LI Hongxin,ZHAO Kaining,ZHANG Lianxiang.Structure design of min-span shrouds for aircraft engine fan blades[J].Aeroengine,2004,30(4):14-17.(in Chinese)
[5]	Williams E J,Earles S W E.Optimization of the response of frictionally damped beam type structure with reference to gas turbine compressor blading[J].Journal of Engineering for Industry,1974,96(2):471-476.
[6]	单颖春,朱梓根,刘献栋.凸肩结构对叶片的干摩擦减振研究:规律分析[J].航空动力学报,2006,21(1):174-180. SHAN Yingchun,ZHU Zigen,LIU Xiandong.Investigation of vibration control by frictional constraints between blade shrouds:rule analysis[J].Journal of Aerospace Power,2006,21(1):174-180.(in Chinese)
[7]	单颖春,郝燕平.干摩擦阻尼块在叶片减振方面的应用与发展[J].航空动力学报,2001,16(3):218-223. SHAN Yingchun,HAO Yanping.Application and development of platform friction damper for depressing resonant vibration of blades[J].Journal of Aerospace Power,2001,16(3):218-223.(in Chinese)
[8]	唐智明,詹孟萱.高效节能发动机文集:第3分册风扇、压气机设计与试验[M].北京:航空工业出版社,1991.
[9]	单祖辉.材料力学[M].北京:高等教育出版社,2004.
[10]	李东旭.高等结构动力学[M].北京:科学出版社,2010.
[11]	陈璐璐.风扇阻尼结构动力学设计理论与方法研究[D].北京:北京航空航天大学,2012.
[12]	宋兆泓,熊昌炳,郑光华.航空燃气涡轮发动机强度设计[M].北京:北京航空学院出版社,1987.
[13]	刘高思,吴文东.高效节能发动机文集:第4分册燃烧室设计与试验[M].北京:航空工业出版社,1991.
[14]	Szwedowicz J,Kissel M,Ravindra B.Estimation of contact stiffness and its role in the design of a friction damper[R].ASME Paper 2001-GT-0290,2001.
[15]	SHI Xi.Measurement and modeling of normal contact stiffness and contact damping at the meso scale[J].Journal of Vibration and Acoustics,2005,127(1):52-60.
[16]	Sherif H A,Omar T M A.Interface properties due to microslip from vibration measurement[J].Journal of Tribology,2001,123(1):230-233.
[17]	Mindlin R D.Compliance of elastic bodies in contact[J].Journal of Applied Mechanics,1949,16:259-268.
[18]	Filippi S,Akay A,Gola M M.Measurement of tangential contact hysteresis during microslip[J].Journal of Tribology,2004,126(3):482-489.