Coupled simulation of gas radiation and wall temperature in vectored nozzle
-
摘要: 选取内、外调节片和隔热屏建立几何模型,基于封闭腔净辐射模型和壁面热平衡模型建立了燃气辐射与喷管壁面温度的耦合算法.波段为1~5μm的气体辐射采用窄波带模型计算,其他波段不考虑气体辐射,建立辐射净热流密度-有效辐射亮度-壁面温度的关联式求解燃气与壁面的辐射换热,采用牛顿-拉斐尔森迭代法求解壁面热平衡方程计算其温度.对某轴对称矢量喷管(偏转20°),计算了喷管壁面的红外光谱辐射和辐射净热流密度,以及各部分结构的温度.作为验证,还计算了文献中某液体火箭发动机轴对称矢量喷管壁面的辐射净热流密度,与文献的结果进行对比一致性较好.研究表明:轴对称矢量喷管偏转段沿周向的辐射热流密度和温度差异很大,沿偏转方向部位壁面的温度和辐射热流密度都较低,偏转方向壁面的温度比相反方向大约低10%,辐射热流密度大约低50%.Abstract: Models of heat shield and inner, outer shells were built for investigation.A coupled simulation method of gas radiation and nozzle wall temperature was established based on neat radiation in an enclosure model and heat balance model of wall.Gas radiation in 1~5μm was computed with narrow band model, which was considered transparent in all other bands.A coupled equation of neat radiative heat flux-effective radiosity-wall temperature was developed, and the Newton Rafael method was used to solve the heat balance equation to obtain wall temperature of nozzle.An axisymmetric vectored nozzle with 20°deflection angle was taken for investigation.The infrared spectral radiation and neat radiative heat flux on the nozzle wall and the wall temperature were computed.For verification of the computation method, the neat radiative heat flux for one axisymmetric nozzle of a liquid rocket motor were computed, showing well agreement through comparison. This study also shows that radiative heat flux and temperature in deflected section of axisymmetric vectored nozzle varies remarkably along the circumferential direction, much lower on the deflecting side than the other side.Wall temperature of deflecting side is about 90% of the other side, while the radiative heat flux is only 50%.
-
Key words:
- vectored nozzle /
- gas radiation /
- wall temperature /
- coupled simulation /
- numerical study
-
[1] 张小英,王先炜.轴对称矢量喷管红外特性的数值计算研究[J].航空动力学报,2004,19(5):366-369. ZHANG Xiaoying,WANG Xianwei.Numerical study in infrared characteristics of axisymmetric vectoring nozzle[J].Journal of Aerospace Power,2004,19(5):366-369.(in Chinese) [2] Rothman L S,Jacquemart D,Barbe A,et al.The HITRAN 2004 molecular spectroscopic database[J].Journal of Quantitative Spectroscopy and Radiative Transfer,2005,96(2):139-204. [3] Siegel R,Howell J R.Thermal radiation heat transfer[M].4th ed.New York:Taylor and Francis,2002. [4] David L B,Jay P G.Radiating characteristics of high temperature exhaust plumes from a subsonic axisymmetric nozzle[R].AIAA-2009-1639,2009. [5] Marineau E C,Schetz J A,Neel R E.Turbulent Navier-Stokes simulations of heat transfer with complex wall temperature variations[R].AIAA-2006-3087,2006. [6] Rodolphe D,Anouar S,Jean T.Coupled radiation and turbulent multiphase flow in a aluminized solid propellant rocket engine[J].Journal of Quantitative Spectroscopy and Radiative Transfer 2004,84(4),513-526. [7] Doyoung B,Seung W B.Numerical investigation of combustion with non-gray thermal radiation and soot formation effect in a liquid rocket engine[J].International Journal of Heat and Mass Transfer,2007,50(3/4):412-422. [8] James G L,Richard L G.Gaseous-film cooling of a rocket motor with injection near the throat[R].NASA TN D-3836,1967. [9] 金捷,廖华琳,朱谷君,等.轴对称矢量喷管三维传热计算研究[J].燃气涡轮试验与研究,2002,15(2):4-7,46. JIN Jie,LIAO Hualin,ZHU Gujun,et al.A numerical investigation of 3D heat transfer for axisymmetric vectoring exhaust nozzle[J].Gas Turbine Experiment and Reasearch,2002,15(2):4-7,46.(in Chinese) [10] 韩非,刘宇.轴对称喷管与圆转方喷管冷却换热特性的比较[J].航空动力学报,2007,22(11):1947-1953. HAN Fei,LIU Yu.Heat transfer characters of asymmetrical nozzle and RS nozzle[J].Journal of Aerospace Power,2007,22(11):1947-1953.(in Chinese) [11] 郑晓亚,王卫祥,蔡飞超,等.固体火箭发动机喷管热结构一体化计算[J].航空动力学报,2012,27(9):2122-2127. ZHENG Xiaoya,WANG Weixiang,CAI Feichao,et al.Thermo-structure integrative computation for nozzle in SRM[J].Journal of Aerospace Power,2012,27(9):2122-2127.(in Chinese) [12] 张晓光,刘宇,王长辉.双脉冲固体发动机喷管传热烧蚀特性[J].航空动力学报,2012,27(6):1391-1397. ZHANG Xiaoguang,LIU Yu,WANG Changhui.Characterization of nozzle thermal and ablation response in dual-pulse solid rocket motors[J].Journal of Aerospace Power,2012,27(6):1391-1397.(in Chinese) [13] 刘常春,吉洪湖,黄伟,等.一种双S弯二元喷管的红外辐射特性数值研究[J].航空动力学报,2013,28(7):1482-1488. LIU Changchun,JI Honghu,HUANG Wei,et al.Numerical simulation on infrared radiation characteristics of serpentine 2-D nozzle[J].Journal of Aerospace Power,2013,28(7):1482-1488.(in Chinese) [14] 张宏伟,陶文铨,何雅玲,等.再生冷却推力室耦合传热数值模拟[J].航空动力学报,2006,21(5):930-936. ZHANG Hongwei,TAO Wenquan,HE Yaling,et al.Numerical study on coupled heat transfer of thrust chamber with regenerative cooling[J].Journal of Aerospace Power,2006,21(5),930-936.(in Chinese) [15] Kyung J Y,Seung W B,Sung N L,et al.Prediction of the rear fuselage temperature with radiation shield[J].World Academy of Science,Engineering and Technology,2011,59:1520-1523. [16] 刘友宏,李江宁,才娟.考虑导热对流和辐射作用的轴对称收扩喷管壁温计算[J].航空动力学报,2008,23(4):635-641. LIU Youhong,LI Jiangning,CAI Juan.Wall temperature calculation of an axisymmetrical converging-diverging nozzle considering heat conduction,convection and radiation[J].Journal of Aerospace Power,2008,23(4),635-641.(in Chinese) [17] 葛绍岩,刘登瀛.气膜冷却[M].北京:科学出版社,1985. [18] Lucas J G,Golladay R L.An experimental investigation of gaseous-film cooling of a rocket motor[R].NASA TN D-1988,1988.
点击查看大图
计量
- 文章访问数: 1063
- HTML浏览量: 2
- PDF量: 482
- 被引次数: 0