交叉式多股流板翅式换热器数值研究

李俊; 蒋彦龙; 周年勇; 徐雷; 施红; 郑文远

doi:10.13224/j.cnki.jasp.2016.05.009

交叉式多股流板翅式换热器数值研究

doi: 10.13224/j.cnki.jasp.2016.05.009

1. 南京航空航天大学航空宇航学院, 南京 210016;
2. 中国航空工业集团公司中航工业金城南京机电液压工程研究中心航空机电系统综合航空科技重点实验室, 南京 210016

基金项目:

江苏高校优势学科建设工程资助项目

详细信息

作者简介:
李俊(1986-),男,山西晋中人,博士生,主要从事高效换热技术研究.

中图分类号: V241.0
计量
- 文章访问数: 861
- HTML浏览量: 4
- PDF量: 671
- 被引次数: 0
出版历程
- 收稿日期: 2015-02-06
- 刊出日期: 2016-05-28

Numerical study on cross-type multi-stream plate-fin heat exchanger

1. College of Aerospace Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 210016, China;
2. Aviation Key Laboratory of Science and Technology on Aero Electromechanical System Integration, Nanjing Engineering Institute of Aircraft Systems, Jincheng, Aviation Industry Corporation of China, Nanjing 210016, China

摘要

摘要: 借鉴顺逆式板翅式换热器研究成果,分析了交叉式多股流板翅式换热器传热机理,建立了基于有限容积法的多股流板翅式换热器传热数学模型,经过合理假设将翅片间距与单元格尺寸独立,拓展了前人数学模型适用范围.同时,以机载交叉式3股流板翅式换热器为例,对单元格尺寸选取进行了探讨,对同一通道单元格内流体流动横向传热进行了分析,证明了忽略流动横向传热的可行性,从而在保证精度不变条件下提高了计算效率;并在流体变入口参数条件下进行试验,对数值计算方法进行验证,通过与试验数据对比,理论计算误差小于7.9%,证明了数值计算方法的合理性.
- 板翅式换热器 /
- 交叉式多股流 /
- 有限容积法 /
- 数值计算 /
- 试验验证
Abstract: Heat transfer mechanism of cross-type multi-stream plate-fin heat exchanger (MPFHE) was analyzed and the mathematical model by finite volume method was established based on the research of parallel-counter type MPFHE, and then the distance between fins was separated with cell size by reasonable assumption, expanding the application of former mathematical model. Besides, discussion about choice of cell size was conducted for the airborne cross-type three-stream plate-fin heat exchanger; while the analysis of transverse heat transfer of flow within a cell on the same channel was applied to demonstrate the possibility of ignoring the transverse heat transfer in this direction, so as to increase calculation efficiency under the constant computational accuracy; moreover, experiment of different inlet flow rates or temperatures was carried out to verify the veracity of numerical method. The calculation uncertainty is less than 7.9% compared with the test record, thus proving the rationality of numerical method.
- plate-fin heat exchanger /
- multi-stream with cross type /
- finite volume method /
- numerical calculation /
- experimental test

HTML

参考文献(18)

[1]	Shah P K,Sekulic D P.Fundamentals of heat exchanger design[M].Hoboken:John Wiley & Sons Inc.,2003.
[2]	王松汉.板翅式换热器[M].北京:化学工业出版社,1984.
[3]	Prasad B S V.Fin efficiency and mechanisms of heat exchange through fins in multi-stream plate-fin heat exchangers:formulation[J].International Journal of Heat and Mass Transfer,1996,39(2):419-428.
[4]	Prasad B S V.The performance prediction of multi-stream plate-fin heat exchangers based on stacking pattern[J].Heat Transfer Engineering,1991,12(4):58-70.
[5]	Goyal M,Chakravarty A,Atrey M D.Two dimensional model for multi-stream plate fin heat exchangers[J].Cryogenics,2014,61(5):70-80.
[6]	Ghosh I,Sarang S K,Das P K,An alternate algorithm for the analysis of multi-stream plate fin heat exchangers[J].International Journal of Heat and Mass Transfer,2006,49(17/18):2889-2902.
[7]	Bielski S,Malinowski L.An analytical method for determining transient temperature field in a parallel-flow three-fluid heat exchanger[J].International Communications in Heat and Mass Transfer,2005,32(8):1034-1044.
[8]	Saeid N H,Seetharamu K N.Finite element analysis for co-current and counter-current parallel flow three-fluid heat exchanger[J].International Journal of Numerical Methods for Heat and Fluid Flow,2006,16(3):324-337.
[9]	Shrivastava D,Ameel T A.Three-fluid heat exchangers with three thermal communications:Part A general mathematical model[J].International Journal of Heat and Mass Transfer,2004,47(17/18):3855-3865.
[10]	LUO Xing,LI Meiling,Roetzel W.A general solution for one-dimensional multi stream heat exchangers and their networks[J].International Journal of Heat and Mass Transfer,2002,45(13):2695-2705.
[11]	ZHAO Min,LI Yanzhong.New integral-mean temperature difference model for thermal design and simulation of parallel three-fluid heat exchanger[J].International Journal of Thermal Sciences,2012,59(9):203-213.
[12]	崔国民,卢洪波,蔡祖恢,等.场协同下的多股流换热器换热性能研究[J].工程热物理学报,2002,23(3):323-326. CUI Guomin,LU Hongbo,CAI Zuhui,et al.Study on the heat-transfer property of multi-stream heat exchanger under the effect of field-synergism[J].Journal of Engineering Thermophysics,2002,23(3):323-326.(in Chinese)
[13]	吕岩岩,崔国民,郭佳,等.多股流换热器设计的量纲1温差场均匀性优化因子[J].化工学报,2007,58(10):2469-2473. LÜ Yanyan,CUI Guomin,GUO Jia,et al.Application of temperature-difference uniformity optimization principle to path arrangement of multi-stream heat exchangers[J].Journal of Chemical Industry and Engineering,2007,58(10):2469-2473.(in Chinese)
[14]	柳雄斌,过增元.换热器性能分析新方法[J].物理学报,2009,58(7):4766-4771. LIU Xiongbin,GUO Zengyuan.A novel method for heat exchanger analysis[J].Acta Physica Sinica,2009,58(7):4766-4771.(in Chinese)
[15]	彭波涛,罗来勤,王秋旺,等.多股流板翅式换热器的微分与优化数值研究[J].化工学报,2004,55(6):876-881. PENG Botao,LUO Laiqin,WANG Qiuwang,et al.Numerical study of differential and optimal design for multi-stream plate-fin heat exchanger[J].Journal of Chemical Industry and Engineering,2004,55(6):876-881.(in Chinese)
[16]	Ghosh S,Ghosh I,Pratihar D K,et al.Optimum stacking pattern for multi-stream plate-fin heat exchanger through a genetic algorithm[J].International Journal of Thermal Sciences,2011,50(2):214-224.
[17]	PENG Xiang,LIU Zhenyu,QIU Chan,et al.Passage arrangement design for multi-stream plate-fin heat exchanger[J].International Journal of Heat and Mass Transfer,2014,77:1055-1062.
[18]	Sanaye S,Hajabdollahi H.Thermal-economic multi-objective optimization of plate fin heat exchanger[J].Applied Energy,2010,87(6):1893-1902.