碱金属工质在基于毛细泵回路的多孔芯蒸发器内的热质传输特性

吴双应; 郑小峰; 肖兰

doi:10.13224/j.cnki.jasp.2017.12.016

碱金属工质在基于毛细泵回路的多孔芯蒸发器内的热质传输特性

doi: 10.13224/j.cnki.jasp.2017.12.016

重庆大学低品位能源利用技术及系统教育部重点实验室，重庆 400044；重庆大学动力工程学院，重庆 400044

基金项目: 国家自然科学基金（51306215）

计量
- 文章访问数: 793
- HTML浏览量: 121
- PDF量: 453
- 被引次数: 0
出版历程
- 收稿日期: 2016-05-22
- 刊出日期: 2017-12-28

Heat and mass transfer characteristics of alkali metal working medium in porous wick evaporator based on capillary pumped loop

摘要

摘要: 以基于毛细泵回路(CPL)原理的多孔芯蒸发器为研究对象，耦合多孔芯、蒸汽槽道和蒸发器壳体等多个部件，通过数值模拟的方法对碱金属工质在蒸发器内部的流动和相变传热特性进行分析，得到蒸发器内部的气相体积分数、温度、压力以及速度等分布。结果表明：碱金属液体极高的导热系数使得多孔芯部分的平均过热度不足1K；以碱金属为工质的多孔芯蒸发器，其内部的蒸发属于表面蒸发，气液界面稳定在多孔芯和蒸汽槽道的界面处，且在相同参数条件下，其毛细抽吸力比使用传统工质的蒸发器高1~2个数量级，具有更大的传输能力。
- 热质传输 /
- 碱金属 /
- 毛细泵回路 /
- 多孔芯蒸发器 /
- 相变
Abstract: Taking porous wick evaporator based on the principle of capillary pumped loop (CPL) as object and considering the wick, vapor groove and casing as a whole, the heat transfer and phase change characteristics of alkali metal working fluid in the porous wick evaporator were analyzed by numerical simulation method. The distributions of vapor phase volume fraction, temperature, pressure and velocity of working medium were obtained. The results showed that the average superheat of porous wick was less than 1K due to high thermal conductivity of alkali metal liquid. The evaporation of alkali metal liquid took place at outside surface of the porous wick and the liquidvapor interface was maintained at wickgroove interface. Under the same parameter conditions, the evaporator using alkali metal had greater transport capacity since its capillary force was 1 to 2 orders of magnitude higher than that of the evaporator using conventional working fluid.
- heat and mass transfer /
- alkali metal /
- capillary pumped loop /
- porous wick evaporator /
- phase change

HTML

参考文献(21)

[1]	张来福,李然,童建忠,等.碱金属热电转换器(AMTEC)的新技术［J］.能源技术,2001,22(1):21-23.ZHANG Laifu,LI Ran,TONG Jianzhong,et al.The new technique of alkali metal thermal to electric converter (AMTEC)［J］.Energy Technology,2001,22(1):21-23.(in Chinese)
[2]	麻昔.AMTEC内毛细泵回路流动与换热机理研究［D］.哈尔滨:哈尔滨工程大学,2012.MA Xi.Mechnaism investigation on flow and heat transfer of capillary pumped loop in AMTEC［D］.Harbin:Harbin Engineering University,2012.(in Chinese)
[3]	WU S Y,XIAO L,CAO Y D,et al.A parabolic dish/AMTEC solar thermal power system and its performance evaluation［J］.Applied Energy,2010,87(2):452-462.
[4]	FIGUS C,BRAY Y L,Bories S,et al.Heat and mass transfer with phase change in a porous structure partially heated:continuum model and pore network simulations［J］.International Journal of Heat and Mass Transfer,1999,42(11):2557-2569.
[5]	王强,刘伟,刘志春,等.CPL蒸发器多孔芯温压变化的数值模拟［J］.华中科技大学学报(自然科学版),2004,32(5):87-89.WANG Qiang,LIU Wei,LIU Zhichun,et al.Numerical study of the pressure and temperature changing of the porous wick in capillary pumped loop evaporator［J］.Huazhong University of Science and Technology (Nature Science Edition),2004,32(5):87-89.(in Chinese)
[6]	万忠民,刘伟,盖东兴,等.带翅片的小型平板CPL蒸发器相变传热的数值模拟［J］.化工学报,2007,58(12):2994-3000.WAN Zhongming,LIU Wei,GAI Dongxing,et al.Numerical simulation of heat transfer with phase change in smallscale flat capillary pumped loop finned evaporator［J］.Journal of Chemical Industry and Engineering(China),2007,58(12):2994-3000.(in Chinese)
[7]	BOUBAKER R,PLATEL V,BERGES A,et al.Dynamic model of heat and mass transfer in an unsaturated porous wick of capillary pumped loop［J］.Applied Thermal Engineering,2015,76:1-8.
[8]	黄晓明,刘伟,韩延民.CPL蒸发器多孔芯传热传质特性的新数学模型［J］.工程热物理学报,2004,25(4):652-654.HUANG Xiaoming,LIU Wei,HAN Yanming.A new model for the heat and mass transfer character of CPL evaporation［J］.Journal of Engineering Thermophysics,2004,25(4):652-654.(in Chinese)
[9]	钱吉裕,李强,宣益民.毛细泵回路蒸发器的数值研究［J］.中国空间科学技术,2005,25(1):28-32.QIAN Jiyu,LI Qiang,XUAN Yiming.Numerical investigation on evaporator for CPL［J］.Chinese Space Science and Technology,2005,25(1):28-32.(in Chinese)
[10]	KAYA T,GOLDAK J.Numerical analysis of heat and mass transfer in the capillary structure of a loop heat pipe［J］.International Journal of Heat and Mass Transfer,2006,49(17/18):3211-3220.
[11]	王俊.微环路热管蒸发器内两相流动换热特性研究［D］.江苏镇江:江苏大学,2015.WAN Jun.Study of twophase flow and heat transfer characteristics in the evaporator of the MLHP systems［D］.Zhenjiang Jiangsu:Jiangsu University,2015.(in Chinese)
[12]	LI Q,ZHAO K,XUAN Y M.Simulation of flow and heat transfer with evaporation in a porous wick of a CPL evaporator on pore scale by lattice Boltzmann method［J］.International Journal of Heat and Mass Transfer,2011,54(13/14):2890-2901.
[13]	NISHIKAWARA M,NAGANO H,MOTTET L,et al.Numerical study of thermal performance of a capillary evaporator in a loop heat pipe with liquidsaturated wick［J］.Journal of Electronics Cooling and Thermal Control,2014,4(4):118-127.
[14]	LI J,PETERSON G P.3D heat transfer analysis in a loop heat pipe evaporator with a fully saturated wick［J］.International Journal of Heat and Mass Transfer,2011,54(1/2/3):564-574.
[15]	ZHANG X F,LI X Y,WANG S F.Threedimensional simulation on heat transfer in the flat evaporator of miniature loop heat pipe［J］.International Journal of Thermal Sciences,2012,54(4):188-198.
[16]	马正军.毛细蒸发流场数值模拟研究［D］.哈尔滨:哈尔滨工程大学,2009.MA Zhengjun.Numerical Simulation study of capillary evaporator［D］.Haerbin:Haerbin Engineering University,2009.(in Chinese)
[17]	钱吉裕.毛细泵回路流动与换热机理研究［D］.南京:南京理工大学,2005.QIAN Jiyu.Flow and heat transfer mechanism of capillary pump loop［D］.Nanjing:Nanjing University of Science and Technology,2005.(in Chinese)
[18]	宋鹏杰.环路热管蒸发器传热模拟研究［D］.南京:南京航空航天大学,2010.SONG Pengjie.Heat transfer simulation study of loop heat pipe［D］.Nanjing:Nanjing University of Aeronautics and Astronautics,2010.(in Chinese)
[19]	张红,杨峻,庄骏.热管节能技术［M］.北京:化学工业出版社,2009.
[20]	SANTOS P H D,BAZZO E,OLIVEIRA A A M.Thermal performance and capillary limit of a ceramic wick applied to LHP and CPL［J］.Applied Thermal Engineering,2012,41(4):92-103.
[21]	吴双应,曹宝喜,肖兰,等.插管对基于AMTEC太阳能热发电的毛细芯蒸发器性能的影响［J］.太阳能学报,2013,34(2):277-282.WU Shuangying,CAO Baoxi,XIAO Lan,et al.Effect of bayonet tube on performance of capillary porous wick evaporator based on AMTEC solar thermal power generation［J］.Acta Energiae Solaris Sinica,2013,34(2):277-282.(in Chinese)