双级轴向旋流杯气量比对雾化性能影响的试验

王志凯; 陈盛; 刘冉

doi:10.13224/j.cnki.jasp.2019.12.015

双级轴向旋流杯气量比对雾化性能影响的试验

doi: 10.13224/j.cnki.jasp.2019.12.015

基金项目: 中国航发自主创新专项资金(ZZCX-2017-018)

计量
- 文章访问数: 1342
- HTML浏览量: 1
- PDF量: 289
- 被引次数: 0
出版历程
- 收稿日期: 2019-06-09
- 刊出日期: 2019-12-28

Experiment on effects of airflow ratio on spray characteristics of dual-axial swirl cup

Hunan Aviation Powerplant Research Institute,Aero Engine Corporation of China,Zhuzhou Hunan 412002,China

摘要

摘要: 为探索小状态下改善雾化性能的途径,从调节旋流杯气量分配的角度出发,对不同一、二级气量比的双级轴向旋流杯开展了试验研究,获得了气量比对液滴平均直径、液滴尺寸分布指数以及喷雾锥角的影响规律。试验结果表明:气量比的增大不仅降低液滴平均直径,而且使得旋流杯在较宽的供油压差范围内都具有良好的雾化品质,可实现小状态下雾化性能的改善。旋流杯喷雾锥角随气量比的增大而增大,随供油压差的增大而增大并逐渐趋于稳定。旋流杯总气量恒定时,气量比接近1时的综合雾化性能最佳。
- 双级轴向旋流杯 /
- 气量比 /
- 液滴平均直径 /
- 喷雾锥角 /
- 液雾翻边
Abstract: In order to explore a way to improve the spray performance under low injection pressure differential, from the perspective of regulating airflow split, effects of airflow ratio of primary swirler to secondary swirler on the spray characteristics of dual-axial swirl cup were studied by experimental system. The influences of airflow ratio on mean drop diameter, drop size distribution parameter and spray angle were obtained. The experimental results indicated that increasing the airflow ratio, the mean drop diameter decreased, and the swirl cup had good spray property over a wide range of injection pressure differential, which could achieve the improvement of the spray performance under low injection pressure differential. The spray angle increased with the airflow ratio, and firstly increased but then remained constant with the injection pressure differential. For a given total airflow of swirl cup, the optimal comprehensive spray performance was obtained when the airflow ratio was about 1.
- dual-axial swirl cup /
- airflow ratio /
- mean drop diameter /
- spray angle /
- spray flanging

HTML

参考文献(29)

[1]	LEFEBVRE A H.Gas turbine combustion［M］.New York:Hemisphere Publishing Corporation,1983.
[2]	金如山,索建秦.先进燃气轮机燃烧室［M］.北京:航空工业出版社,2016.
[3]	黄勇.燃烧与燃烧室［M］.北京:北京航空航天大学出版社,2009.
[4]	徐华胜,黄义勇,王秀兰.喷嘴供油特性对双涡流器头部气动雾化效果的影响研究［J］.燃气涡轮试验与研究,2004,17(2):14-17. XU Huasheng,HUANG Yiyong,WANG Xiulan.Study on the effect of fuel jet characteristics on airblast atomization performance for device with two-stage swirler［J］.Gas Turbine Experiment and Research,2004,17(2):14-17.(in Chinese)
[5]	张弛,田兴鹏,林宇震,等.旋流杯文氏管长度对积碳的影响研究［J］.推进技术,2015,36(12):1833-1838. ZHANG Chi,TIAN Xingpeng,LIN Yuzhen,et al.Effects of venturi length of swirl cup on carbon deposition［J］.Journal of Propulsion Technology,2015,36(12):1833-1838.(in Chinese)
[6]	刘成川,许全宏,于博文.一级旋流偏置对双旋流杯下游流场的影响［J］.北京航空航天大学学报,2016,42(6):1244-1249. LIU Chengchuan,XU Quanhong,YU Bowen.Influence of primary swirl offset on downstream flowfield of dual-swirl cup［J］.Journal of Beijing University of Aeronautics and Astronautics,2016,42(6):1244-1249.(in Chinese)
[7]	于博文,张弛,杨谦,等.一级旋流强度对双旋流杯下游油气分布的影响［J］.推进技术,2014,35(11):1482-1487. YU Bowen,ZHANG Chi,YANG Qian,et al.Effects of primary swirl intensity on flow and fuel distribution downstream a dual-swirl cup［J］.Journal of Propulsion Technology,2014,35(11):1482-1487.(in Chinese)
[8]	刘桂桂,林宇震,胡好生,等.旋流杯一级旋流数变化对点火性能的影响［J］.北京航空航天大学学报,2015,41(6):1117-1121. LIU Guigui,LIN Yuzhen,HU Haosheng,et al.Effect of swirl cup’s primary swirl number on ignition performance［J］.Journal of Beijing University of Aeronautics and Astronautics,2015,41(6):1117-1121.(in Chinese)
[9]	程明,林宏军,李锋.旋流杯设计参数对燃烧性能的影响［J］.航空动力学报,2014,29(10):2355-2361. CHENG Ming,LIN Hongjun,LI Feng.Effect of swirl cup design parameters on combustion performance［J］.Journal of Aerospace Power,2014,29(10):2355-2361.(in Chinese)
[10]	罗国良,宋双文,胡好生,等.旋流杯空气雾化喷嘴套筒出口形状对小型燃烧室点火性能的影响［J］.航空动力学报,2011,26(8):1708-1712. LUO Guoliang,SONG Shuangwen,HU Haosheng,et al.Influences of the swirl cup flares design on the small combustor ignition performances［J］.Journal of Aerospace Power,2011,26(8):1708-1712.(in Chinese)
[11]	谢法,黄勇,苗辉,等.气量分配对轴径向旋流杯燃烧室贫熄边界的影响［J］.航空动力学报,2011,26(8):1756-1760. XIE Fa,HUANG Yong,MIAO Hui,et al.Effects of airflow split and primary holes arrangement on the lean blowout limits of a combustor with axial-radial swirl cup［J］.Journal of Aerospace Power,2011,26(8):1756-1760.(in Chinese)
[12]	徐浩鹏,王方,黄勇,等.头部气量分配对旋流杯结构燃烧室贫熄性能的影响［J］.航空动力学报,2009,24(2):347-352. XU Haopeng,WANG Fang,HUANG Yong,et al.Effects of flow split among swirlers and primary holes on the lean blowoff limits of a combustor with swirl cup［J］.Journal of Aerospace Power,2009,24(2):347-352.(in Chinese)
[13]	黄勇,郭志辉.适于旋流杯下游流场的改进型半分析关系式［J］.北京航空航天大学学报,2006,32(6):630-634. HUANG Yong,GUO Zhihui.Improved semi-analytical correlation approach for the flowfield downstream of swirl cups［J］.Journal of Beijing University of Aeronautics and Astronautics,2006,32(6):630-634.(in Chinese)
[14]	VASHAHI F,LEE J.On the emerging flow from a dual-axial counter-rotating swirler:LES simulation and spectral transition［J］.Applied Thermal Engineering,2018,129:646-656.
[15]	WANG Xiaofeng,LIN Yuzhen,ZHANG Chi,et al.Effect of swirl cup’s secondary swirler on flow field and ignition performance［J］.Journal of Thermal Science,2015,24(5):488-495.
[16]	WANG Xiaofeng,LIN Yuzhen,HU Haosheng,et al.Effect of swirl cup’s venturi shape on spray structure and ignition process［R］.ASME Paper GT2014-25216,2014.
[17]	JONG-HOON P,YOUNGBIN Y,IN-SEUCK J,et al.Effect of swirl cup on characteristics of fuel spray in gas turbine combustor［R］.AIAA-2000-3352,2000.
[18]	LIN S C,WANG Xionghui,ESTEFANOS W,et al.The effect of the geometric modifications of the venturi on the non-reactive flowand combustion behavior using a counter-rotating radial-radial swirler［R］.ASME Paper GT2017-64876,2017.
[19]	SHANMUGADAS K P,CHAKRAVARTHY S R,CHIRANTHAN R N,et al.Characterization of wall filming and atomization inside a gas turbine swirl injector［J］.Experiments in Fluids,2018,59:1-26.
[20]	COHEN J M,ROSFJORD T J.Influence on the sprays formed by high-shear fuel nozzle swirler assemblies［J］.Journal of Propulsion and Power,1993,9(1):16-27.
[21]	ROCK N,CHTEREV I,SMITH T,et al.Reacting pressurized spray combustor dynamics:Part 1 fuel sensitivities and blowoff characterization［J］.ASME Paper GT2016-56346,2016.
[22]	CHTEREV I,ROCK N,EK H,et al.Reacting pressurized spray combustor dynamics:Part 2 high speed planar measurements［R］.ASME Pape GT2016-56345,2016.
[23]	CHTEREV I,ROCK N,EK H,et al.Simultaneous high speed (5 kHz) fuel-PLIE,OH-PLIF and stereo PIV imaging of pressurized swirl-stabilized flames using liquid fuels［R］.AIAA-2017-0152,2017.
[24]	ROCK N,CHTEREV I,EMERSON B,et al.Liquid fuel property effects on lean blowout in an aircraft relevant combustor［R］.Journal of Engineering for Gas Turbines and Power,2019,141(7):071005.1-071005.13.
[25]	HAN Y M,SEOL W S,LEE D S,et al.Effects of fuel nozzle displacement on pre-fliming airblast atomization［J］.Journal of Engineering for Gas Turbines and Power,2001,123(1):33-40.
[26]	LIU Cunxi,LIU Fuqiang,YANG Jinhu,et al.Investigations of the effects of spray characteristics on the flame pattern and combustion stability of a swirl-cup combustor［J］.Fuel,2015,139:529-536.
[27]	XIAO Wei,GUO Zhengyan,CHEN Pimin.Effect of geometric parameters on mean drop sizes from dual-orifice pressure nozzles［R］.ASME Paper GTP-18-1061,2018.
[28]	陈坚,李建中,袁丽,等.雾化特性对喷雾燃烧点火过程的影响［J］.推进技术,2017,38(6):1318-1326. CHEN Jian,LI Jianzhong,YUAN Li,et al.Effects of spray characteristics on ignition process in spray combustion［J］.Journal of Propulsion Technology,2017,38(6):1318-1326.(in Chinese)
[29]	王志凯,陈盛,江立军,等.气量分配对双级轴向旋流器性能影响的试验研究［J］.推进技术,2019,40(8):1799-1806. WANG Zhikai,CHEN Sheng,JIANG Lijun,et al.Experimental investigation of effects of airflow split on the characteristics of dual-axial swirler［J］.Journal of Propulsion Technology,2019,40(8):1799-1806.(in Chinese)