复杂异型机匣高效高精度动力学建模及评价方法

魏静; 周仁弘毅; 张爱强; 姜东

doi:10.13224/j.cnki.jasp.20200365

复杂异型机匣高效高精度动力学建模及评价方法

doi: 10.13224/j.cnki.jasp.20200365

重庆大学机械传动国家重点实验室, 重庆 400044

基金项目:

国家自然科学基金（51775058）

详细信息

作者简介:
魏静(1978-),男,教授、博士生导师,博士,主要从事机械系统动力学研究。

通讯作者:
张爱强(1990-),男,助理研究员,博士,主要从事机械系统动力学研究。E-mail:zaq_sklmt@163.com

中图分类号: V231;TH113.1
计量
- 文章访问数: 423
- HTML浏览量: 103
- PDF量: 135
- 被引次数: 0
出版历程
- 收稿日期: 2020-08-31
- 刊出日期: 2021-07-28

High-efficiency and accurate dynamical modeling and evaluation method for complex irregular casing

State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing 400044, China

摘要

摘要: 为了解决复杂异型机匣模型单元数量大、原始矩阵阶数高导致的动力学计算与后处理困难的问题，提出基于试验模态分析-大规模有限元-子结构缩聚的复杂异型机匣高精度动力学建模及评价方法。以某型直升机主减速器机匣为研究对象，建立该异型构件原始有限元模型并通过模态试验验证模型的有效性，通过分析机匣子结构各阶模态保留主振型，选择模态能量较大处为缩聚点，得到自由度数目大幅减少的缩聚模型，对比验证缩聚前后模态的一致性，并提出一种基于数列相关系数定义的缩聚误差衡量方法，最后利用界面位移协调条件进行子结构耦合，对比整体模型的固有特性以及计算效率。研究结果表明：缩聚矩阵与有限元原始矩阵动力学特性十分接近，固有频率与振型误差均小于4%，且计算时间更短，存储空间占用更少，极大地提高了计算效率。
- 异型机匣 /
- 试验模态分析 /
- 有限元法 /
- 子结构缩聚 /
- 精度评价方法
Abstract: In order to solve the problem of difficult dynamic calculation and post-processing caused by complex irregular casing of large number of model elements and high order of the original matrix, a high-precision dynamic modeling and evaluation method for complex irregular casing based on experimental modal analysis-large-scale finite element-substructure condensation was proposed. Taking the main casing of a helicopter as the research object, the original finite element model of the special-shaped component was established and the validity of the model was verified through modal experiments. By analyzing the retained models of each mode of the substructure, the larger vibration energy space was selected as the condensed node, and then a condensation model with a greatly reduced number of degrees of freedom was obtained. The consistency of each mode before and after the condensation was verified by comparison. A method for measuring the model condensation error based on the correlation coefficient of the sequence was proposed. Finally, by taking the interface displacement compatibility condition into consideration, the substructure coupling was carried out; in addition, the inherent characteristics and computational efficiency of the overall model were compared. The research results showed that the dynamic characteristics of the condensation matrix were very close to the original matrix of the finite element, both the natural frequency and the mode error were less than 4%, the calculation time was shorter and the storage space was less occupied, greatly improving the calculation efficiency.
- irregular casing /
- experimental modal analysis /
- finite element method /
- substructure condensed /
- accuracy evaluation method

HTML

参考文献(21)

[1]	李朝峰,周世华,刘文明,等.齿轮-转子-滚动轴承传动系统的弯扭耦合振动[J].航空动力学报,2014,29(7):1543-1555. LI Chaofeng,ZHOU Shihua,LIU Wenming,et al.Vibration of bending-torsion coupling gear-rotor-rolling bearing transmission system[J].Journal of Aerospace Power,2014,29(7):1543-1555.(in Chinese)
[2]	魏静,史磊,张爱强,等.飞行环境非惯性系下行星齿轮传动系统耦合动力学建模及其动态特性[J].机械工程学报,2019,55(23):162-172. WEI Jing,SHI Lei,ZHANG Aiqiang,et al.Modeling and dynamic characteristics of planetary gear transmission in non-inertial system of aerospace environment[J].Journal of Mechanical Engineering,2019,55(23):162-172.(in Chinese)
[3]	YAVUZ S D,SARIBAY Z B,CIGEROGLU E.Nonlinear dynamic analysis of a drivetrain composed of spur,helical and spiral bevel gears[J].Nonlinear Dynamics,2020,100(56):3145-3170.
[4]	陆春荣,李以农,窦作成,等.齿轮-转子-轴承系统弯扭耦合非线性振动特性研究[J].振动工程学报,2018,31(2):238-244. LU Chunrong,LI Yinong,DOU Zuocheng,et al.Nonlinear vibration of bending-torsion coupling gear-rotor-bearing system[J].Journal of Vibration Engineering,2018,31(2):238-244.(in Chinese)
[5]	朱自冰,朱如鹏,鲍和云.直升机尾传动系统扭转振动建模与特性[J].航空动力学报,2013,28(2):432-438. ZHU Zibing,ZHU Rupeng,BAO heyun.Torsional vibration characteristics analyzing and modeling for helicopter tail drive system[J].Journal of Aerospace Power,2013,28(2):432-438.(in Chinese)
[6]	任亚峰,常山,刘更.箱体柔性对齿轮传动系统动态特性的影响分析[J].振动与冲击,2017,36(14):85-91,103. REN Yafeng,CHANG Shan,LIU Geng.Influence of housing flexibility on the dynamic characteristics of gear transmission systems[J].Journal of Vibration and Shock,2017,36(14):85-91,103.(in Chinese)
[7]	ABBES M S,FAKHFAKH T,HADDAR M,et al.Effect of transmission error on the dynamic behavior of gearbox housing[J].The International Journal of Advanced Manufacturing Technology,2007,34(3/4):211-218.
[8]	ABBOUDI K,LASSȂAD W,YASSINE D,et al.Dynamic behavior of a two-stage gear train used in a fixed-speed wind turbine[J].Mechanism and Machine Theory,2011,46(12):1888-1900.
[9]	高维金,王亮,刘永光.箱式动力结构的振动传递特性分析[J].北京航空航天大学学报,2015,41(3):509-516. GAO Weijin,WANG Liang,LIU Yongguang.Analysis on vibration transmission characteristics of box-like power structure[J].Journal of Beijing University of Aeronautics and Astronautics,2015,41(3):509-516.(in Chinese)
[10]	贺朝霞,常乐浩,刘岚.耦合箱体振动的行星齿轮传动系统动态响应分析[J].华南理工大学学报(自然科学版),2015,43(9):128-134,148. HE Zhaoxia,CHANG Lehao,LIU Lan,et al.Dynamic response analysis of planetary gear transmission system coupled with gearbox vibrations[J].Journal of South China University of Technology (Natural Science Edition),2015,43(9):128-134,148.(in Chinese)
[11]	GUO Y,ERITENEL T,ERICSON T M,et al.Vibro-acoustic propagation of gear dynamics in a gear-bearing-housing system[J].Journal of Sound and Vibration,2014,333(22):5762-5785.
[12]	LU Jianwei,ZENG Fanling,XIN Jiayun,et al.Influences of stochastic perturbation of parameters on dynamic behavior of gear system[J].Journal of Mechanical Science and Technology,2011,25(7):1667-1673.
[13]	GONZÁLEZ-CRUZ C A,JÁUREGUI-CORREA J C,DOMÍNGUEZ-GONZÁLEZ A,et al.Effect of the coupling strength on the nonlinear synchronization of a single-stage gear transmission[J].Nonlinear Dynamics,2016,85(1):123-140.
[14]	周建星,刘更,马尚君.内激励作用下齿轮箱动态响应与振动噪声分析[J].振动与冲击,2011,30(6):234-238. ZHOU Jianxing,LIU Geng,MA Shangjun.Vibration and noise analysis of gear transmission system[J].Journal of Vibration and Shock,2011,30(6):234-238.(in Chinese)
[15]	ZHU Haimin,CHEN Weifang,ZHU Rupeng,et al.Modelling and dynamic analysis of the spiral bevel gear-shaft-bearing-gearbox coupling system[J].Mathematical Problems in Engineering,2019(3):1-16.
[16]	高洁,刘振侠,扶碧波,等.直升机主减速器变形对传动性能的影响分析[J].航空动力学报,2018,33(7):1736-1742. GAO Jie,LIU Zhenxia,FU Bibo,et al.Analysis of influence of helicopter main gearbox deformation on transmission performance[J].Journal of Aerospace Power,2018,33(7):1736-1742.(in Chinese)
[17]	BOUHADDI N,FILLOD R.A method for selecting master DOF in dynamic substructuring using the Guyan condensation method[J].Computers and Structures,1992,45(5/6):941-946.
[18]	JEONG J,BAEK S,CHO M.Dynamic condensation in a damped system through rational selection of primary degrees of freedom[J].Journal of Sound and Vibration,2012,331(7):1655-1668.
[19]	KIM K O,KANG M K.Convergence acceleration of iterative modal reduction methods[J].AIAA Journal,2015,39(1):134-140.
[20]	HELSEN J,VANHOLLEBEKE F,MARRANT B,et al.Multibody modelling of varying complexity for modal behaviour analysis of wind turbine gearboxes[J].Renewable Energy,2011,36(11):3098-3113.
[21]	PEETERS B,VAN DER AUWERAER H,GUILLAUME P,et al.The polymax frequency-domain method:a new standard for modal parameter estimation?[J].Shock and Vibration,2004,11(3/4):395-409.