不同约束条件下跨声速涡轮叶栅伴随气动优化设计

李佳星; 罗佳奇; 曹志远

doi:10.13224/j.cnki.jasp.20200468

不同约束条件下跨声速涡轮叶栅伴随气动优化设计

doi: 10.13224/j.cnki.jasp.20200468

1.
浙江大学航空航天学院，杭州 310027
2.
西北工业大学动力与能源学院，西安 710129

基金项目: 国家自然科学基金（51676003，51976183，51806174）

详细信息

作者简介:
李佳星（1998-），女，博士生，主要从事叶轮机械气动优化设计研究。

通讯作者:
罗佳奇（1981-），男，研究员、博士生导师，博士，主要从事叶轮机械气动热力学、计算流体力学、优化设计等研究。E-mail：jiaqil@zju.edu.cn

中图分类号: V231.3
计量
- 文章访问数: 499
- HTML浏览量: 249
- PDF量: 205
- 被引次数: 0
出版历程
- 收稿日期: 2020-11-02
- 刊出日期: 2021-09-28

Adjoint-based aerodynamic design optimization of transonic turbine cascades considering different constraints

1.
School of Aeronautics and Astronautics，Zhejiang University，Hangzhou 310027，China
2.
School of Power and Energy，Northwestern Polytechnical University，Xi'an 710129，China

摘要

摘要: 发展了一种简化的基于无反射边界理论的伴随方程进出口边界条件确定方法，研究了考虑不同约束的叶片气动外形优化设计。研究结果表明：采用流动强耦合的简化伴随方程进出口边界条件确定方法，能够确定精度较高的伴随灵敏度，在不同类型的伴随气动优化设计中均具有较好适用性。无约束的出口质量熵优化后，出口质量熵降低0.253%，流道面积和出口气流角变化较大。分别考虑出口气流角气动约束、流道面积几何约束和同时考虑上述两种约束的影响，优化后出口质量熵分别降低0.176%、0.227%和0.164%，优化后叶片气动性能显著提升，且满足约束条件。改变叶型曲率能有效减弱激波强度，吸力面前段曲率降低时，流动减速、出口气流角增大，吸力面前段曲率变化较小时，出口气流角约束较好。
- 气动优化设计 /
- 约束条件 /
- 伴随方法 /
- 边界条件 /
- 涡轮叶栅
Abstract: A simplified method based on non-reflecting boundary theory for determining the inlet and outlet boundary conditions of adjoint equations was introduced，by which the aerodynamic design optimization of turbomachinery blade considering different constraints was investigated.The results showed that the simplified adjoint equations strongly coupling with flow under inlet and outlet boundary conditions were sufficiently accurate and applicable in different constrained optimization design.After outlet specific entropy design optimization without constraints，the outlet specific entropy decreased by 0.253%，with varied passage area and outlet flow angle.Considering the constraints of outlet flow angle and passage area separately and the constraints from both of them，the outlet specific entropy after optimization decreased by 0.176%，0.227% and 0.164%，respectively.The aerodynamic performance of the optimized blades was significantly improved，while the optimization constraints were maintained.Moreover，the results demonstrated that changing the curvature of blade profile weakened the shock wave effectively.When the curvature of front portions decreased，the flow velocity decelerated and the outlet flow angle increased，meanwhile when the curvature of front portions changed slightly，the outlet flow angle was constrained better.
- aerodynamic design optimization /
- constraint /
- adjoint method /
- boundary condition /
- turbine cascade

HTML

参考文献(30)

[1]	CHUNG H S,ALONSO J J A.Multidisciplinary design optimization of supersonic business jets using approximation model-based genetic algorithms[D].Palo Alto，US:University of Stanford,2004.
[2]	ZHU Z,WANG X,FU H,et al.Aerodynamic optimization design of airfoil and wing[R].AIAA 2004-4367,2004.
[3]	SAMAD A,KIM K Y.Multiple surrogate modeling for axial compressor blade shape optimization[J].Journal of Propulsion and Power,2008,24（2）:302-310.
[4]	BONAIUTI D,ZANGENEH M.On the coupling of inverse design and optimization techniques for the multiobjective,multipoint design of turbomachinery[J].Journal of Turbomachinery,2009,131（2）:021014.1-021014.16.
[5]	LAROCCA F.Multiple objective optimization and inverse design of axial turbomachinery blades[J].Journal of Propulsion and Power,2008,24（5）:1093-1099.
[6]	?ZHAN ?,?BRAHIM S A.Multi-objective aerodynamic optimization of axial turbine blades using a novel multilevel genetic algorithm[J].Journal of Turbomachinery,2010,132（4）:041009.1-041009.19.
[7]	JAMESON A.Aerodynamic design via control theory[J].Journal of Scientific Computing,1988,3（3）:233-260.
[8]	NADARAJAH S K,JAMESON A.Optimum shape design for unsteady there-dimensional viscous flows using a non-linear frequency domain method[R].AIAA 2006-3455,2006.
[9]	NADARAJAH S K,JAMESON A.Optimum shape design of helicopter rotors in forward flight via control theory[R].AIAA 2007-3951,2007.
[10]	NADARAJAH S K,JAMESON A.Optimum shape design for unsteady flows with time-accurate continuous and discrete adjoint methods[J].AIAA Journal,2007,45（7）:1478-1500.
[11]	IOLLO A,SALAS M D,TA'ASAN S.Shape optimization governed by the quasi 1D Euler equations using an adjoint method[C]∥Fourteenth International Conference on Numerical Methods in Fluid Dynamics.Bangalore,India:Springerlink,1994:274-279.
[12]	DREYER J,MARTINELLI L.Hydrodynamic shape optimization of propulsor configurations using continuous adjoint approach[R].AIAA 2001-2580,2001.
[13]	YANG S,LIU F.Aerodynamic design of cascades by using an adjoint equation method[R].AIAA 2003-1068,2003.
[14]	WU H Y,LIU F,TSAI H M.Aerodynamic design of turbine blades using an adjoint equation method[R].AIAA 2005-1006,2005.
[15]	LI H,SONG L,LI Y,et al.2D viscous aerodynamic shape design optimization for turbine blades based on adjoint method[J].Journal of Turbomachinery,2011,133（3）:031014.1-031014.8.
[16]	YU J,JI L,LI W,et al.Shape optimization of axial compressor blades using adjoint method with emphasis on thickness distribution[R].ASME Paper GT2015-42232,2015.
[17]	PAPADIMITRIOU D I,GIANNAKOGLOU K C.Compressor blade optimization using a continuous adjoint formulatio[R].ASME Paper GT2006-90466,2006.
[18]	LUO J,XIONG J,LIU F.Three-dimensional aerodynamic design optimization of a turbine blade by using an adjoint method[J].Journal of Turbomachinery,2011,133（1）:011026.1-11026.11.
[19]	LUO J,ZHOU C,LIU F.Multipoint design optimization of a transonic compressor blade by using an adjoint method[J].Journal of Turbomachinery,2014,136（5）:051005.1-051005.10.
[20]	LUO J,LIU F.Multi-objective optimization of a transonic compressor rotor by using an adjoint method[J].AIAA Journal,2015,53（3）:797-801.
[21]	WANG D,HE L.Adjoint aerodynamic design optimization for blades in multistage turbomachines：Part Ⅰ methodology and verification[J].Journal of Turbomachinery,2010,132（2）:2141-2155.
[22]	WALTHER B,NADARAJAH S.Constrained adjoint-based aerodynamic shape optimization of a single-stage transonic compressor[J].Journal of Turbomachinery,2013,135（2）:021017.1-021017.10.
[23]	罗佳奇,杨婧.基于伴随方法的单级低速压气机气动设计优化[J].航空学报,2020,41（5）:134-143.
[24]	MA C,SU X R,YUAN X.An efficient unsteady adjoint optimization system for multistage turbomachinery[J].Journal of Turbomachinery,2017,139（1）:011003.1-011003.12.
[25]	CHEN L,CHEN J.Aerodynamic optimization design for high pressure turbines based on the adjoint approach[J].Chinese Journal of Aeronautics,2015,28（3）:757-769.
[26]	GILES M B,PIERCE N A.On the properties of solutions of the adjoint Euler equations[EB/OL].[2020-10-30].http:∥www2.maths.ox.ac.uk/~gilesm/files/icfd_adj.pdf.
[27]	罗佳奇.基于伴随方法的三维涡轮叶片气动优化设计[D].西安:西北工业大学,2011.
[28]	DENTON J D.Loss mechanisms in turbomachines[J].Journal of Turbomachinery,1993,115（4）:621-656.
[29]	JOUINI D B M.Experimental investigation of two transonic linear turbine cascades at off-design conditions[D].Ottawa，Canada:Carleton University,2000.
[30]	BALDWIN B S,LOMAX H.Thin layer approximation and algebraic model for separated turbulent flow[R].AIAA 1978-257,1978.

施引文献

资源附件(0)

访问统计

点击查看大图

计量

文章访问数: 499
HTML浏览量: 249
PDF量: 205
被引次数: 0

姓名
邮箱
手机号码
标题
留言内容
验证码

留言板

不同约束条件下跨声速涡轮叶栅伴随气动优化设计

doi: 10.13224/j.cnki.jasp.20200468

作者简介:
李佳星（1998-），女，博士生，主要从事叶轮机械气动优化设计研究。

通讯作者:
罗佳奇（1981-），男，研究员、博士生导师，博士，主要从事叶轮机械气动热力学、计算流体力学、优化设计等研究。E-mail：jiaqil@zju.edu.cn

计量

Adjoint-based aerodynamic design optimization of transonic turbine cascades considering different constraints

计量

目录

留言板

不同约束条件下跨声速涡轮叶栅伴随气动优化设计

doi: 10.13224/j.cnki.jasp.20200468

作者简介: 李佳星（1998-），女，博士生，主要从事叶轮机械气动优化设计研究。

通讯作者: 罗佳奇（1981-），男，研究员、博士生导师，博士，主要从事叶轮机械气动热力学、计算流体力学、优化设计等研究。E-mail：jiaqil@zju.edu.cn

计量

出版历程

Adjoint-based aerodynamic design optimization of transonic turbine cascades considering different constraints

计量

出版历程

目录

作者简介:
李佳星（1998-），女，博士生，主要从事叶轮机械气动优化设计研究。

通讯作者:
罗佳奇（1981-），男，研究员、博士生导师，博士，主要从事叶轮机械气动热力学、计算流体力学、优化设计等研究。E-mail：jiaqil@zju.edu.cn