多级旋流空气雾化喷嘴高空气动雾化场的数值研究

赵乾鹏; 杨金虎; 刘存喜; 刘富强; 穆勇; 胡春艳; 徐纲

doi:10.13224/j.cnki.jasp.20210050

多级旋流空气雾化喷嘴高空气动雾化场的数值研究

doi: 10.13224/j.cnki.jasp.20210050

赵乾鹏^1,2,
杨金虎^1,2,3,
刘存喜^1,2,3,
刘富强^1,2,3,
穆勇^1,2,3, ,,
胡春艳^1,2,3,
徐纲^1,2,3

1.
中国科学院工程热物理研究所轻型动力重点实验室，北京 100190
2.
中国科学院大学航空宇航学院，北京100049
3.
中国科学院轻型动力创新研究院，北京 100190

基金项目: 国家科技重大专项（2017-Ⅲ-0007-0032）

详细信息

作者简介:
赵乾鹏（1995-），男，博士生，研究领域为燃烧室燃油雾化与点熄火特性。

通讯作者:
穆勇（1979-），男，高级工程师，博士，主要从事航空发动机燃烧方面的研究。E-mail：muyong@iet.cn

中图分类号: V231.2
计量
- 文章访问数: 456
- HTML浏览量: 167
- PDF量: 163
- 被引次数: 0
出版历程
- 收稿日期: 2021-01-30
- 刊出日期: 2021-12-28

Numerical investigation of high altitude aerodynamic and spray fields for multi-swirl airblast atomizer

ZHAO Qianpeng^1,2,
YANG Jinhu^1,2,3,
LIU Cunxi^1,2,3,
LIU Fuqiang^1,2,3,
MU Yong^{1,2,3
, ,},
HU Chunyan^1,2,3,
XU Gang^1,2,3

1.
Laboratory of Light-Duty Gas-Turbine，Institute of Engineering Thermophysics，Chinese Academy of Sciences，Beijing 100190，China
2.
School of Aeronautics and Astronautics，University of Chinese Academy of Sciences，Beijing 100049，China
3.
Innovation Academy for Light-duty Gas Turbine，Chinese Academy of Sciences，Beijing 100190，China

摘要

摘要: 为有效拓宽采用预膜式空气雾化喷嘴的多旋流分级燃烧室的稳定工作边界，在模型燃烧室上开展了高原及高空工况下气动雾化场的数值研究，采用经过实验验证的数值模拟方法获取了多旋流分级燃烧室的高空气动场和雾化场，分析了低温、低压进口条件对燃烧室流场结构和雾化质量的影响。结果表明：低温及低压进口工况对中心回流区的结构及尺度、速度分布影响较小，但低温会削弱旋流器出口湍动能强度，低压会显著降低旋流空气切向剪切力。相同旋流器压降下，低温、低压条件会造成气液比和韦伯数的降低，导致雾化粒径增大，液滴群轴向穿透深度增加。相关研究结论能够解释该类燃烧室高空点火困难的影响机制。
- 空气雾化喷嘴 /
- 多旋流分级 /
- 低温 /
- 低压 /
- 气动场 /
- 雾化场
Abstract: In order to effectively widen the stable operating limits of multi-swirl staged combustor with prefilming airblast atomizer，the aerodynamic and spray fields of a model combustor under plateau and high-altitude conditions were studied numerically.A numerical method verified by experiments was used to acquire the high-altitude aerodynamic and spray fields of a multi-swirl staged combustor.The influences of low temperature and sub-atmospheric pressure conditions on the flow field structure and atomization quality were analyzed.The results showed that the low temperature and sub-atmospheric pressure conditions had little influence on the flow structure，scale and velocity distributions of central recirculation zone.However，the low temperature weakened the turbulent intensity in swirler outlet，and the sub-atmospheric pressure significantly reduced the tangential shear force of swirling air.Under the same pressure drop of injector，the low temperature and sub-atmospheric pressure conditions led to the decrease of air-liquid ratio and Weber number，which further led to the increase of droplet size and the axial penetration depth of droplet group.The findings from this investigation can explain the influence mechanism of altitude relight difficulty for this kind of combustor.
- airblast atomizer /
- multi-swirl staged /
- low temperature /
- sub-atmospheric pressure /
- aerodynamic field /
- spray field

HTML

参考文献(20)

[1]	LEFEBVRE A H,BALLAL D R.Gas turbine combustion:alternative fuels and emissions[M].Boca Raton，US:CRC Press,2010.
[2]	FOUST M,THOMSEN D,STICKLES R,et al.Development of the GE aviation low emissions TAPS combustor for next generation aircraft engines[R].AIAA 2012-0936,2012.
[3]	林宇震,林阳,张弛,等.先进燃烧室分级燃烧空气流量分配的探讨[J].航空动力学报,2010,25（9）:1923-1930.
[4]	LEFEBVRE A H.Airblast atomization[J].Progress in Energy and Combustion Science,1980,6（3）:233-261.
[5]	RIZKALLA A A,LEFEBVRE A H.The influence of air and liquid properties on airblast atomization[J].Journal of Fluids Engineering,1974,97（3）:316-320.
[6]	EL-SHANAWANY M S,LEFEBVRE A H.Airblast atomization:the effect of linear scale on mean drop size[J].Journal of Energy,1980,4（4）:184-189.
[7]	RIZK N K,LEFEBVRE A H.Spray characteristics of plain-jet airblast atomizers[J].Journal of Engineering for Gas Turbines and Power,1984,106（3）:634-638.
[8]	LIU Cunxi,LIU Fuqiang,MAO Yanhui,et al.Experimental investigation of performance of an air blast atomizer by planar laser sheet imaging technique[R].ASME Paper GT 2013-94129,2013.
[9]	GURUBARAN R K,SUJITH R I,CHAKRAVARTHY S R.Characterization of a prefilming airblast atomizer in a strong swirl flow field[J].Journal of Propulsion and Power,2008,24（5）:1124-1132.
[10]	SHANMUGADAS K P,CHAKRAVARTHY S R.A canonical geometry to study wall filming and atomization in pre-filming coaxial swirl injectors[J].Proceedings of the Combustion Institute,2017,36（2）:2467-2474.
[11]	SHANMUGADAS K P,CHAKRAVARTHY S R,CHIRANTHAN R N,et al.Characterization of wall filming and atomization inside a gas-turbine swirl injector[J].Experiments in Fluids,2018,59（10）:1-26.
[12]	SHANMUGADAS K P,MANUPRASAD E S,CHIRANTHAN R N,et al.Fuel placement and atomization inside a gas-turbine fuel injector at realistic operating conditions[J].Proceedings of the Combustion Institute,2021,38（2）:3261-3268.
[13]	WARNCKE K,GEPPERTH S,SAUER B,et al.Experimental and numerical investigation of the primary breakup of an airblasted liquid sheet[J].International Journal of Multiphase Flow,2017,91:208-224.
[14]	CHAUSSONNET G,GEPPERTH S,HOLZ S,et al.Influence of the ambient pressure on the liquid accumulation and on the primary spray in prefilming airblast atomization[J].International Journal of Multiphase Flow,2020,125:1-24.
[15]	DENTON M.Experimental investigation into the high altitude relight characteristics of a three-cup combustor sector[D].Cincinnati，US:University of Cincinnati,2017.
[16]	MAJCHERCZYK M,ZARZALIS N,TURRINI F.Influence of the turbulence length scale and intensity on spark ignition of kerosene jet-A1-air mixtures at high altitude relight conditions[R].ASME Paper GT 2014-25332,2014.
[17]	MARTINOS A D,ZARZALIS N,HARTH S R.Analysis of ignition processes at combustors for aero engines at high altitude conditions with and without effusion cooling[R].ASME Paper GT 2020-16173,2020.
[18]	READ R W,ROGERSON J W,HOCHGREB S.Planar laser-induced fluorescence fuel imaging during gas-turbine relight[J].Journal of Propulsion and Power,2013,29（4）:961-974.
[19]	YANG Jinhu,LIU Cunxi,LIU Fuqiang,et al.Experimental and numerical study of the effect of main stage stratifier length on lean blow-out performance for a stratified partially premixed injector[J].Journal of Power and Energy,2018,232（7）:812-825.
[20]	金如山，索建秦.先进燃气轮机燃烧室[M].北京:航空工业出版社，2016.