涡扇发动机整机环境下风扇部件气动稳定性评定方法

王占学; 王鹏; 乔渭阳; 蔡元虎

涡扇发动机整机环境下风扇部件气动稳定性评定方法

西北工业大学动力与能源学院, 西安 710072

基金项目: 国家APTD计划资助项目(APTD-1102-02-03)

计量
- 文章访问数: 1481
- HTML浏览量: 1
- PDF量: 440
- 被引次数: 0
出版历程
- 收稿日期: 2006-04-06
- 修回日期: 2006-10-16
- 刊出日期: 2007-04-28

Aerodynamic stability assessment of fan component running in turbofan engine

School of Power and Energy, Northwestern Polytechnical University, Xi’an 710072, China

摘要

摘要: 将基于部件匹配技术的涡扇发动机非设计点性能计算模型和基于李亚普诺夫稳定性理论的压缩部件气动稳定性评定模型有机的耦合, 实现了发动机整机环境下的压缩部件气动稳定性评定, 使得该模型成为一种实用的涡扇发动机压缩部件气动稳定性分析模型.以某型涡扇发动机为例, 计算比较了均匀进气和畸变进气时发动机整机环境和单独部件评定时风扇部件稳定工作边界的异同, 从计算结果可以看到, 均匀进气条件下, 在发动机环境下和单独部件环境下所得到的风扇部件稳定工作边界变化不大;而畸变进气条件下, 同样的进口畸变度, 发动机环境下风扇的稳定裕度损失比单独部件下风扇的稳定裕度损失都小, 即在发动机环境下评定风扇稳定性时, 风扇对进气温度畸变不敏感, 而在单独部件环境下评定时, 风扇对进气畸变比较敏感.
- 航空、航天推进系统 /
- 涡扇发动机 /
- 气动稳定性 /
- 压缩部件 /
- 数学模型
Abstract: A new model was presented for predicting of aerodynamic stability limit of compressor in turbofan engine. Firstly, a quasi one-dimensional, time dependent compression system model was used to model the dynamic flow in compressor and the actuator-lag-volume model was adopted to model the stage of compressor. Secondly, Lyapunov stability theory was used to identify the aerodynamic stability of compression component. Finally, this aerodynamic stability numerical model was coupled with steady state thermodynamic cycle model of turbofan for predicting of aerodynamic stability limit of compression component in turbofan engine environment. A turbofan engine with 3 stages fan and 5 stages compressor as an example was simulated. Numerical results show that the model presented in this paper is reasonable and reliable and can be used to predict aerodynamic stability limit of fan and compressor in real turbofan engine environment.
- aerospace propulsion system /
- turbofan engine /
- aerodynamic stability /
- compression component /
- numerical model

HTML

参考文献(8)

[1]	Davis Jr M W.Parametric investigation into the combined effects of pressure and temperature distortion on compression system stability[R].AIAA Paper 91-1895.
[2]	Correl S E.Application of a dynamic compression system model to a low-aspect ratio fan:casing treatment and distortion[R].AIAA 93-1871.
[3]	吴虎,廉小纯.多级轴流压气机喘振边界预估的一种新方法[J].推进技术,1997,18(2):75-77.WU Hu,LIAN Xiaochun.A new method for predicting surge line in multistage axial compressors[J].Journal of Propulsion Technology,1997,18(2):75-77.
[4]	张明川,唐狄毅.预测轴流压气机工作稳定性的非线性模型[J].推进技术,1998,19(5):47-51.ZHANG Mingchuan,TANG Diyi.A nonlinear model for instability prediction of axial flow compressors[J].Journal of Propulsion Technology,1998,19(5):47-51.
[5]	胡骏.均匀进气与非均匀进气条件下多级轴流压气机性能计算-均匀进气及径向畸变的影响[J].航空动力学报,2000,15(3):225-228.HU Jun.Calculation of off-design performance of multistage compressors with uniform and radial distorted inlet flow[J].Journal of Aerospace Power,2000,15(3):225-228.
[6]	Manuj Dhingra.Stall and surge precuesores in axial compressors[R].AIAA 2003-4426.
[7]	乔渭阳,蔡元虎.燃气涡轮发动机压缩系统稳定性数值模拟的研究[J].燃气涡轮试验与研究,2001,14(2):19-25.QIAO Weiyang,CAI Yuanhu.An numerical simulation of compression system stability of turbine engine[J].GasTurbine Experiment and Research,2001,14(2):19-25.
[8]	Sellers J F,Daniele C J.DYNGEN-A program for calculating steady-state and transient performance of turbojet and turbofan engines[R].NASN TN D-7901,1975.