带气腔的离心压缩机旋转失速的三维数值模拟

郭强; 竺晓程; 杜朝辉; 陈华; 赵岩

带气腔的离心压缩机旋转失速的三维数值模拟

1.
上海交通大学机械与动力工程学院, 上海 200030, Chin
2.
美国Honeywell公司

基金项目: 美国Honeywell公司资助

计量
- 文章访问数: 1390
- HTML浏览量: 2
- PDF量: 531
- 被引次数: 0
出版历程
- 收稿日期: 2006-06-07
- 修回日期: 2006-10-19
- 刊出日期: 2007-07-28

Three-dimensional numerical simulation of rotating stall inside a centrifugal compressor with plenum model

1.
School of Mechanical and Power Engineering, Shanghai Jiaotong University, Shanghai 200030, China
2.
Honeywell Corporation, USA

摘要

摘要: 使用商业CFD计算软件CFX求解三维雷诺平均的Navier-Stokes方程组, 结合出口气腔模型对某带无叶扩压器的离心压缩机的旋转失速现象进行数值模拟.首先使用定常计算得到了该离心压缩机的稳态性能曲线, 并和实验测量值进行了比较.然后引入出口气腔模型, 模拟离心压缩机内的旋转失速流动.在小流量下, 从矢量图和径向速度等值线图中观察得到了离心压缩机内部流场的非定常流动现象.还研究了气腔模型不同参数对失速流动的影响, 结果表明气腔体积越大, 计算得到的失速频率越低.
- 航空、航天推进系统 /
- 离心压缩机 /
- 无叶扩压器 /
- 非定常数值模拟 /
- 气腔模型
Abstract: Numerical simulation results of rotating stall flow phenomenon inside a centrifugal compressor with vaneless diffuser by solving three-dimensional Reynolds averaged compressible N-S equations using commerce computational fluid dynamjcs(CFD) software CFX adopting RNG k-ε turbulence model are presented in this paper.Firstly,the steady performance curve is obtained using steady calculations and compared with experimental results. Secondly,a plenum chamber model is added at the vaneless diffuser outlet to simulate the rotating stall flow phenomenon inside the centrifugal compressor.The paper gives the centrifugal compressor internal flow fields at different times during the stall cycle at the least mass flow rate and observes the stall flow phenomenon.The plenum chamber influence on the rotating stall is also investigated.The simulation indicates the more the plenum chamber volume,the lower the stall frequency.
- aerospace propulsion system /
- centrifugal compressor /
- vaneless diffuser /
- unsteady numerical simulation /
- plenum chamber model

HTML

参考文献(6)

[1]	蒋康涛,徐刚,黄伟光,等.低速轴流压气机旋转失速的二维数值模拟[J].工程热物理学报,2004,24(6):935-938.JIANG Kangtao,XU Gang,HUANG Weiguang,et al.Two-dimensional numerical simulation of rotating stall in a low-speed axial compressor[J].Journal of Engineering Thermophysics,2004,24(6):935-938.
[2]	Nie C Q,Xu G,Cheng X,et al.Micro air injection and its unsteady response in a low-speed axial compressor[J].Journal of Turbomachinery,2002,124(4):572-579.
[3]	Outa E.Kato D.Chiba K.An N-S simulation of stall cell behavior in a 2-D compressor rotor-stator system at various loads[R].ASME 94-GT-257.1994.
[4]	He L.Computational study of rotating stall inception in axial compressor[J].Journal of Propulsion and Power,1997,13(1):31-38.
[5]	Saxer F H M,Saxer A P,Inderbitzin A,et al.Prediction and measurement of rotating stall in an axial compressor[R].ASME 98-GT-67,1998.
[6]	Stein A.Computational analysis of stall and separation control in centrifugal compressor[D].Doctor Thesis,USA:Georgia Institute of Technology,2000.